DCS-8525LH
D-Link Corporation
DCS-8525LH
Full HD Pan & Tilt Wi-Fi
Camera
User’s Manual
Version 1.0
March 12th, 2018
Page 1
DCS-8525LH D-Link Corporation
Table of Contents
1. PRODUCT INTRODUCTION .................................................................... 3
2.
HARDWARE OVERVIEW .........................................................................3
4. INSTALLATIONS ...................................................................................... 5
Page 2
DCS-8525LH D-Link Corporation
1. PRODUCT INTRODUCTION
The DCS-8525 Full HD Pan & Tilt Wi-Fi Camera provides a range of features
to help you effectively monitor large areas of your home or small office at all
hours of the day. The pan/tilt function allows the camera to patrol a wide area,
while the built-in IR LEDs provide around the clock surveillance in all lighting
conditions. Extra details are captured in 1080p high-definition resolution and
H.264 compression saves space without sacrificing performance. An
integrated microSD card slot1 allows you to record videos directly onto the
camera, without the need of a computer. You can set up the camera to record
only when motion or sound is detected.
Wireless connectivity means that there is no need for additional cabling and
Micro-USB input lets you power the device using universal cables and power
adapters, making setup quick and hassle-free.
2. HARDWARE OVERVIEW
Page 3
DCS-8525LH
D-Link Corporation
Page 4
DCS-8525LH D-Link Corporation
3. INSTALLATIONS
3-1
Wireless set-up: Plug the included USB Power Adapter into the back of
the camera. Wait until the PWR LED changes from red to blinking orange.
Wired set-up: Plug the included USB Power Adapter and Ethernet cable
into the back of the camera. Wait until the red PWR LED turns off and the
green LINK LED turns on
Page 5
DCS-8525LH
3-2
To download and install the mydlink app on your mobile device, scan the QR
code above for your Android or iOS device.
3-3
New users: Tap Sign Up to register for a mydlink account, then tap Add a
Device to install your camera.
D-Link Corporation
Existing users: Sign In using your mydlink account and tap the icon at the
top left, then tap Add a Device to start the setup wizard.
Page 6
DCS-8525LH D-Link Corporation
3-4
When asked to scan the QR code, use the code found on the bottom of the
camera.
Page 7
DCS-8525LH D-Link Corporation
Regulatory Statements
Federal Communication Commission Interference
Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and r
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV techn
FCC Caution:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
Note: The country code selection is for non-US model only and is not
available to all US model. Per FCC regulation, all WiFi product marketed in
US must fixed to US operation channels only.
eceiver.
ician for help.
Page 8
DCS-8525LH D-Link Corporation
Industry Canada statement:
This device complies with ISED’s licence-exempt RSSs. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’ ISED applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes : (1) le dispositif ne doit pas produire de
brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage
reçu, y compris un brouillage susceptible de provoquer un
fonctionnement indésirable.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the
radiator & your body.
Déclaration d'exposition aux radiations:
Cet équipement est conforme aux limites d'exposition aux
rayonnements ISED établies pour un environnement non contrôlé. Cet
équipement doit être installé et utilisé avec un minimum de 20 cm de
distance entre la source de rayonnement et votre corps.
Page 9
DCS-8525LH D-Link Corporation
低功率電波輻射性電機管理辦法
低功率電波輻射性電機管理辦法
低功率電波輻射性電機管理辦法低功率電波輻射性電機管理辦法
第十二條 經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者
均不得擅自變更頻率、加大功率或變更原設計之特性及功能。
第十四條 低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現
象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規
定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻
射性電機設備之干擾。
CE(LVD)
CE(LVD)警語更新
CE(LVD)CE(LVD)
manufacturer " or equivalent.
警語更新::::
警語更新警語更新
IMPORTANT : " This unit to be used with the power supply provided by
Page 10
Loading...