D Link 2002080002-2 External Installation procedures
This product works with the following operating
system software:
Windows XP, Windows
2000, Windows Me, Windows 98SE
DWL-AG520
Air Xpert Tri-Mode Dualband
Before You Begin
You must have at least the following:
• A desktop computer with an available PCI 2.2, 32-bit, 3.3 volt PCI slot
• At least a 500 MHz processor and 128MB of memory
• An 802.11a, 802.11b or 802.11g Access Point (for Infrastructure Mode) or
another 802.11a, 802.11b, or 802.11g wireless adapter (for Ad-Hoc;
Peer-to-Peer networking mode.)
Check Your Package Contents
These are the items included with your DWL-AG520 purchase:
DWL-AG520 Air Xpert Tri-Mode Dualband Wireless PCI
Adapter
CD-ROM (containing Drivers, Manual and Warranty)
TM
Wireless PCI Adapter
If any of the above items are missing, please contact your reseller.
Insert the D-Link CD Into Your Desktop PC
Turn on the computer and
Insert the D- Link Air Xpert DWL-AG520
Driver CD in the CD-ROM drive.
The step-by-step instructions that follow are shown
in Windows XP. The steps and screens are similar
for the other Windows operating systems
©2003 D-Link Systems, Inc. All rights reserved. Trademarks or registered trademarks are the property of their respective holders. Software and
specifications subject to change without notice. DWL-G520 03072003
1
Do NOT install
the DWL-AG520
Wireless PCI Adapter
into your computer
before installing the
driver software from
the D-Link CD!
Part No. IG-BDWLAG520
Continued...
The Install Screen will appear.
Click Install Drivers
If the CD Autorun function
does not automatically start
on your computer , go to
Start > Run and type
“D:\Setup.exe.” If it does
start, proceed to the next
screen.
Type “D:\Setup.exe.”
The letter “D”
represents the
letter of the CD-ROM
drive. Your CD-ROM
drive may be a different
drive letter.
Click OK
Click Next
Click Next
2
Click Next
Click Next
Click Finish
Shut down your computer
3
Installing the DWL-AG520 Wireless PCI
Adapter in Your Computer
A. Make sure to turn off your computer and unplug the power cord
before you begin. Remove the back or side cover of the computer.
B. Carefully guide the DWL-AG520’s antenna through the PCI
bracket opening adjacent to the PCI slot you intend to use for the
DWL-AB520.
C. Install the DWL-AG520 carefully,
and firmly set it into the available
PCI slot (which is typically white
or cream-colored).
D. Secure the DWL-AG520’s back
panel bracket with its mounting
screw.
E. Replace the computer’s cover.
To avoid damage caused by static electricity, make
sure to properly ground yourself by first touching a
metal part of your computer to discharge any static
electricity before working with the DWL-AG520.
4
Loading...