D Link 2002080002-2 Internal antenna OEM installation instruction

DWL-AG520 Internal Antenna Installation

Before You Begin

• Make sure to turn off your computer and unplug the power cord.

Remove the front plastic cover from the computer.

Identify an antenna installation location:

A. High on the metal front of the chassis.
B. Use a clearance area of 22x16x10mm which will not interfere with the plastic cover.
C. Less than 2cm from a 3x3mm, or larger, hole in the metal.

Carefully guide the antenna cable through the desired aperture
towards the PCI slots.

Verify proper clearance exists between the metal and front plastic
cover.

Pull the cable taut, expose the adhesive on the antenna, and affix
the antenna less than 2cm from the cable hole on the clean metal
surface.

Make sure to orient
the antenna so that
the writing on the
antenna is parallel
with the bottom of
the machine

Attach the antenna cable to the DWL-AG520 by gently pushing it
into the on-board connector.

Attach the antenna cable

Install the DWL-AG520 carefully and firmly seat it into an available

PCI slot (may require removing an existing bracket on the computer
back panel).