Page 1
OSMO
Quad Charging System
User Guide
V1.0
Page 2
Disclaimer and Warning
Congratulations on purchasing your new DJITM product. The information in
this document aects your safety and your legal rights and responsibilities.
Read this entire document carefully to ensure proper conguration before
use. Failure to read and follow instructions and warning s in this document may
result in serious injury to yourself or others, damage to your DJI product, or
damage to other objects in the vicinity. This document and all other collateral
documents are subject to change at the sole discretion of DJI. For up-to-date
product information, visit http://www.dji.com and click on the product page
for this product.
By using this product, you hereby signify that you have read this disclaimer
and warning carefully and that you understand and agree to abide by the
terms and conditions herein. You agree that you are solely responsible for
your own conduct while using this product, and for any consequences
thereof. You agree to use this product only for purposes that are proper
and in accordance with all applicable laws, rules, and regulations, and all
terms, precautions, practices, policies and guidelines DJI has made and
may make available. DJI accepts no liability for damage, injury or any legal
responsibility incurred directly or indirectly from the use of this product. The
user shall observe safe and lawful practices including, but not limited to,
those set forth in this document.
DJI is a trademark of SZ DJI Technology Co., Ltd. (abbreviated as “DJI”)
and its aliated companies. Names of products, brands, etc., appearing
in this manual are trademarks or registered trademarks of their respective
owner companies.
Page 3
Important
1. The OsmoTM Quad Charging System is only compatible with the dedicated DJI
Battery Chargers. Do not use it with any other battery charger.
2. The Quad Charging System is only compatible with the Osmo HB01-
522365 and HB02-542465 (high capacity) Intelligent Batteies. Do not use
the Quad Charging System with other battery models.
3. Place the Quad Charging System on a at and stable surface when in use.
Ensure the device is properly insulated to prevent re hazards.
4. Do not touch the metal terminals on the Quad Charging System.
5. Clean the metal terminals with a clean, dry cloth if there is any noticeable
buildup.
Introduction
The Osmo Quad Charging System is used with the dedicated DJI Battery
Chargers, which can charge up to four Osmo Intelligent Batteries. It will take
approximately 100 minutes (for the HB01-522365) or 120 minutes (for the
HB02-542465) to fully charge the battery.
1
1. Battery Level Indicators
2
2. Charging Ports
3
3. Power Port
Page 4
Usage
1. Attach the Osmo Intelligent Battery to a Charging Port. The Charging
Ports can charge one to four batteries at a time.
2. Connect the Osmo Quad Charging System to a DJI Charger, then
connect the charger to a power outlet. The battery level LED indicators
will indicate each battery’s power level. Refer to the table below for more
information about the blinking patterns.
• The Charger provided with the Osmo cannot be used with the Osmo
Quad Charging System. Refer to the Specifications section for
information about supported DJI Chargers.
Page 5
Battery Level Indicator Description
The four battery level indicators will blink alternately when there is no battery
attached. The corresponding battery level indicator will indicate the battery’s
power level after it starts to charge, while the battery level indicator will turn o if
there is no battery attached to the corresponding charging port.
Blinking Patterns Battery Level
......
Blinking Green
(within a certain time)
— Solid Green Fully charged
Blinks once < 25%
Blinks twice 25% to 49%
Blinks three times 50% to 74%
Blinks four times 75% to 99%
Specications
Model OS1CH
Supported DJI Intelligent Battery HB01-522365, HB02-542465
Supported DJI Charger
Operating Temperature 5° to 40° C
Operating Voltage 12.6 V / 13.2 V
Weight 76 g
PH4C100 (Phantom 4 Charger)
ADE019 (Phantom 3 - 100W Charger)
A14-057N1A
(Phantom 3 / Lightbridge 2 - 57W Charger)
Page 6
Compliance Information
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
EU Compliance Statement
SZ DJI TECHNOLOGY CO., LTD. hereby declares that this device is in compliance
with the essential requirements and other relevant provisions of the EMC Directive.
A copy of the EU Declaration of Conformity is available online at www.dji.com/
euro-compliance
EU contact address: DJI GmbH, Industrie Strasse. 12, 97618, Niederlauer, Germany
DJI Support
www.dji.com/support
This content is subject to change.
Download the latest version from
http://www.dji.com/product/osmo
OSMOTM is a trademark of DJI.
Copyright © 2016 DJI All Rights Reserved.
Printed in China.
Loading...