Disney DDS8005, DDS8005-BLKOM, Jam Stand DDS8005-BLK User Manual
stereo speakers/recharger
User’s Guide
Jam Stand™ Stereo Speaker/Recharger
Manual del Usuario
Altavoces estereofónicos/recargador Jam Stand™
Guide d'utilisation
Haut-parleurs Stéréo et Borne
de Recharge Jam Stand™
DDS8005-BLK
1
QUICK REFERENCE
Rotate to adjust the volume
Will light red when the power is on
Plug the small end of the AC adapter
into this jack
Connect the MP3 player through
the Audio In cable (included) onto
this plug and the other end to the
MP3 player's Line out or
Headphone jack
Insert the Disney Digital Music
Player (DDA8040) directly to the
Input Plug and the USB Jack
SIMPLIFIED OPERATION FOR DISNEY DIGITAL MUSIC PLAYER (DDA8040)
1. Connect the AC adapter (included) to the AC outlet and the DC IN jack at the
rear of the unit; the Power indicator will light red.
2a. To charge the rechargeable battery of the Disney Digital Music player
(DDA8040), slide the Power switch (on the DDA8040) to the OFF position; then
insert it directly onto the Audio Input plug and the USB jack to begin charging.
2b. To hear the music from the Disney Digital Music player (DDA8040), slide the
Power switch (on the DDA8040) to the ON position and insert it directly onto the
Audio Input plug and the USB jack. The Disney Digital Music player (DDA8040)
will start playback automatically; the sound will be heard through the Speaker
System and the lights around the speakers will flash randomly. Adjust the volume
by rotating the Volume control at the top of the Speaker system and the Volume
buttons on the Disney Digital Music player (DDA8040).
3. When finished, unplug the AC adapter and the Disney Digital Music player from
the Speaker System.
SIMPLIFIED OPERATION FOR OTHER MP3 PLAYERS:
1. Insert the MP3 player through the Audio IN cable (included) to the Audio Input
plug.
2. Connect the AC adapter (included) to the AC outlet and the DC IN jack at the
rear of the unit; the Power indicator will light red.
3. Refer to the owner’s manual of the MP3 player to start playback. The sound will
be heard through the Speaker System and the light around the speakers will
flash randomly. Adjust the volume by rotating the Volume control.
4. When finished, unplug the AC adapter and the MP3 player from the Speaker
System.
2
SAFETY PRECAUTIONS
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
This Caution Marking is located at the bottom enclosure of the unit.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
DANGEROUS VOL
TAGE:
The lightning flash with arrowhead symbol, within an
equilateral triangle is intended to alert the user to the
presence of uninsulated dangerous voltage within the
product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
ATTENTION:
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
FCC WARNING:
This equipment may generate or use radio frequency energy.
Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this
equipment if an unauthorized change or modification is made.
ATTENTION:
POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA
PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE
LA PRISES ET POUSSER JUSQU’AU FOND.
INFORMATION:
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
3
SAFETY PRECAUTIONS
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS UNIT TO
RAIN OR MOISTURE.
SURGE PROTECTORS:
It is recommended to use a surge protector for AC
connection. Lightning and power surges ARE NOT
covered under warranty for this product.
4
USING AN ADAPTER (INCLUDED)
1. Plug the small end of the AC adapter into the DC IN jack on
the rear of the unit.
2. Connect the other end (with two blades) into an AC outlet
having 120V, 60Hz AC only; the Power indicator will light red
when the AC adapter is connected.
NOTES:
• Only use the supplied AC adapter which has the following
specs: DC 12V, 500mA
z.
• For the Disney Digital Music Player (DDA8040), while the
player is turned off, directly connect it to the Audio Input plug
and the USB jack, the Disney Digital Music Player’s
rechargeable battery will charge.
POWER SOURCE
5
LOCATION OF CONTROLS
5
6
2
3
1
4
7
1. VOLUME Control
2. Left Speaker
3. Right Speaker
4. Power Indicator
5. Audio Input Plug
6. DC IN Jack (Rear of Unit)
7. USB Jack (Can only be used to recharge the battery of
the Disney Digital Music player [DDA8040])
6
OPERATION
Connect the AC adapter as described on
page 4; the Power indicator on the
Speaker System will light red.
1
For the Disney Digital Music Player
(DDA8040): Slide the Power switch on the
DDA8040 to the ON position. Then insert
the unit directly onto the Audio Input plug
and the USB jack. After a few seconds, the
unit will start playback automatically. The
sound will be heard through the Speaker
System and the lights around the
speakers will flash randomly.
NOTE: For
the DDA8040, if the unit is in the Stop
mode, after two minutes, it will start
playback again automatically. If you don't
want it to start playback again, you should
unplug the unit from the Speaker System.
2
For another MP3 player: Connect the MP3
Player as described on the next page, then
refer to the owner's manual of the MP3
Player to start playback. The sound will be
heard through the Speaker System and the
lights around the speakers will flash
randomly.
3
Adjust the volume by rotating the Volume
control at the top of the Speaker System
and the V
olume control of your MP3 player.
When finished, unplug the Speaker
System and the MP3 player.
4
NOTE:
• If the lights around the speakers do not flash randomly during playback, increase the
volume level of your MP3 player.
7
OPERATION (CONTINUED)
For Disney Digital Music Player
(DDA8040), insert the unit directly
onto the Audio Input plug and the
USB jack.
NOTE: Make sure to slide the
Power switch on the Disney Digital
Music Player (DDA8040) to the
OFF position to charge the battery.
For other MP3 players, insert the
Audio IN cable to the MP3
player's Line Out or Headphone
jack and the other end to the
Audio Input Plug of the Speaker
System.
CONNECTING AN MP3 PLAYER
Connect the MP3 player to the Speaker System following one of
the two connections below:
8
OPERATION (CONTINUED)
Slide the Power switch on the Disney
Digital Music Player (DDA8040) to the OFF
position, remove the USB Flash Plug cover
and insert the unit directly onto the USB
Jack and Audio Input Plug to charge up the
rechargeable battery of the Disney Digital
Music Player (DDA8040).
1
RECHARGING THE RECHARGEABLE BATTERY OF THE
DISNEY DIGITAL MUSIC PLAYER (DDA8040)
While charging the battery, the Function
indicator on the Disney Digital Music
Player (DDA8040) will flash green and red.
The Function indicator will light green when
fully charged.
It takes approx. 2.5 to 3 hours to charge
the battery from empty to full.
2
When finished charging, remove the
Disney Digital Music Player (DDA8040)
from the Speaker System and unplug the
AC adapter.
4
NOTE:
• To recharge the rechargeable battery of the Disney Digital Music Player (DDA8040),
make sure you have turned off the unit before inserting it onto the USB jack. If you are
playing music or the unit is already inserted into the USB jack and the Audio Input plug,
you should unplug the player, then turn off the unit and insert it back onto the USB jack
to start charging the battery.
• If charging is finished and you want to playback the music files from the Disney Digital
Music Player (DDA8040), unplug the unit from the Speaker System. Then slide the Power
switch on the DDA8040 to the ON position and insert it back onto the Speaker System to
start playback.
While charging, you can press the
Play/Pause button on the DDA8040 to
playback the music files from the
DDA8040, the unit will stop when the
music files from the DDA8040 have been
played.
NOTE: While charging, the
Function indicator on the DDA8040 will
continuously flash red and green, even
though the DDA8040 is in Play mode.
3
Loading...