Dirt Devil DDST14V User Manual

2IN1 CORDLESS
VACUUM

USER GUIDE

DDST14V

2 Year Warranty

WARNING

BASIC SAFETY PRECAUTIONS

• This vacuum cleaner is intended
for household use only and NOT
for commercial or industrial use.

• Only use the vacuum cleaner
indoors and keep the area you’re
cleaning well lit.

•Keepngers,hairandloose

clothing from moving parts
and openings whilst using
the vacuum cleaner.

• This appliance is not intended
for use by children and persons

withreducedphysical,sensory

or mental capabilities or lack

ofexperienceandknowledge,

unless they have been given

supervision or instruction
concerning use of the appliance
in a safe way and understands
the hazards involved.

• Only Dirt Devil recommended

charger,toolsandaccessories

should be used with this
vacuum cleaner.

• The vacuum cleaner should
not be used to absorb or
vacuum up liquids.

DON'TS

• Don’t charge the vacuum cleaner
outdoors or leave the charger
connected to the mains when
not in use.

• Don’t use this vacuum cleaner

ifithasbeendropped,damaged,

immersed in water or left outdoors.

• Don’t handle the charger plug
or use the vacuum cleaner with
wet hands.

• Do not use this vacuum cleaner
with a damaged cord or plug.
If the supply cord is damaged call
us on AU: 1300 361 505 / NZ:
0800 800 900 for your nearest
Dirt Devil authorised service agent.

• Don’t use the charger cord as

ahandle,pullthechargercord

around corners or sharp edges
or close a door over the charger
cord. Don’t unplug charger by
pulling on the charger cord.

• Don’t attempt to remove
blockages with sharp objects
as this may cause damage to
your vacuum cleaner.

• Don’t use the charger with
incorrect voltage as this may
result in damage or injury to the
user. The correct voltage is listed
on the ratings label.

2

WARNING

DON'TS CONTINUED...

•Don’tvacuumuphotcoals,
cigarettebutts,matchesor

smoking hot burning items or

DO'S

•Alwaysmakesurethelterand
dirtcontainerarettedcorrectly

before using your vacuum cleaner.

• Always turn off and unplug
the vacuum cleaner from the
charger before carrying out
any maintenance.

• Turn off all controls on the vacuum
cleaner before disconnecting or
connecting the charger.

• Take extra care when cleaning
on the stairs.

use in an area where there may

beharmfuluids(chlorine,bleach,

and ammonia drain cleaner).

• Always carry the vacuum
cleaner/handheld by the
correct carry handle.

• Store your vacuum cleaner

inacool,dryarea.

• Before any user maintenance

isundertaken,refertothe

appropriate section in the user
guide to understand necessary
precautions required.

• Always use the charger supplied
with the vacuum cleaner.

• Always protect the charger cord
from heated surfaces or near

openames.

• If charging the vacuum cleaner
through an extension cord use
only SAA approved 10amp
extension cords. Non-approved
cords may overheat. Care should
be taken to arrange the cord
so that the cord cannot be
tripped over.

• Always remove the charger
from the mains and charging
port on the vacuum cleaner
before using the vacuum cleaner
or carrying out any maintenance
or troubleshooting.

PLEASE KEEP INSTRUCTIONS
FOR FURTHER USE AND USE
ONLY AS INSTRUCTED IN
THIS GUIDE.

3

4

TABLE OF
CONTENTS

Overview 6

Quick Start Assembly 7

How to 8

Accessories 17

Troubleshooting 18

5

On/Off and suction

requirements

control switch

2-in-1 crevice tool/
dusting brush holder

Handle recline button

Handheld release button

LED Power/charge lights

Handheld On/Off button

Dirt container
release button

Floorhead

TECHNICAL SPECIFICATIONS

Model number:

Voltage:

Power:

DDST14V

14.4V

115 W

Charger Input:

Charger Output:

Battery:

Machine charging port

Floorhead
release button

100-240V ~ 50/60Hz

25V 0.5A

Rechargable Ni-MH

Dirt bin capacity:

Charge time:

Run time:

Weight:

0.4L

5 hours

Up to 25 minutes

3kg

Double

This product

Insulated

meets applicable

regulatory

6

Indoor

Use

Instructions

We reserve the right to make changes to technical and design specifications in the

Read

interest of continuous product improvement. © Dirt Devil.

PLEASE READ ‘BASIC SAFETY PRECAUTIONS’ BEFORE USE

CAUTION: Always switch off the vacuum cleaner before connecting or disconnecting the handheld/attachments
or removing and emptying the dirt container.

CAUTION: Ensure the battery is removed from the vacuum cleaner before it is scrapped. The vacuum cleaner must
be disconnected from the supply mains when removing the battery. The battery must be recycled or disposed of in
an environmentally sound manner.

IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does
overheat the thermostat will automatically turn the vacuum cleaner off. If this happens, switch the vacuum cleaner off.
Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to cool
for approximately 1 hour (if you have cleaned the filter please wait 24 hours for the filter to fully dry before putting
back into the machine). For best cleaning results, filters require cleaning at least every 3 to 6 months. If the vacuum
cleaner is blocked, switch off before removing the blockage.

CAUTION: This vacuum cleaner has a constantly rotating brushbar. Never leave the vacuum cleaner in one spot for
an extended period of time as this may damage the floor surface.

ASSEMBLE YOUR 2IN1 VACUUM CLEANER

QUICK START

1. Line up the fl oorhead with
the main body and push fi rmly
into place.

3. Store the 2-in-1 tool on board
the vacuum cleaner by pushing
the tool fi rmly into the tool holder
located on the handle.

2. Lift the handle in a hinge like

manner and secure onto the
main body.

4. Fix the wall clip to your wall using

the screw and wall plug provided.
During storage and charging,
secure your vacuum cleaner
handle into the wall clip.

NOTE: To fold the handle for storage, push in the handle recline button and fold handle all the way back.

77

CARRY YOUR 2IN1 VACUUM CLEANER

1. Make sure the handle is secured
in the upright position and use
the handle to carry the 2-in-1
vacuum cleaner.

2. Use the handle to carry as a

handheld vacuum cleaner.

CHARGE YOUR 2IN1 VACUUM CLEANER

NOTE: Initial charge is 5 hours, charging will be required before first use. The vacuum can be charged
with the handheld either attached to or detached from the main body.

1. Plug the charger
lead into the
charging port
located on the side
of the handheld
and then plug the
charger into
the mains.

CAUTION: To prolong battery life remove the vacuum from charge after 5 hours. Battery to be fully

depleted prior to next charge.

2. Once fully charged
the LED indicator
lights on the
handheld will
illuminate green.

3. When the vacuum
needs recharging
the LED lights on
the handheld will
illuminate red and
the machine will
cut out.

8

CAUTION

The brushbar will constantly rotate. Never leave the
vacuum cleaner in one spot for an extended period of time
as this may damage the floor surface. Dirt Devil cannot
be held responsible for damage to the floor surface if this
recommendation is not followed.

USE AS AN UPRIGHT VACUUM CLEANER

HOW TO

1. Unplug the charger from the
mains and from the side of
the handheld.

3. Slide the On/Off suction control
switch forward once for low
suction. The LED lights on the
handheld will illuminate green,
indicating the power is on and
the brushbar will spin.

2. Place foot on the floorhead
and pull the handle backwards
to recline.

4. Slide the On/Off suction
control switch forward again
for high suction.

5. Slide the On/Off suction control
switch all the way back to switch
the power and LED lights Off.

CAUTION: Always unplug the charger from the mains and charging port on the vacuum cleaner

before using or carrying out any maintenance of troubleshooting.

9

7

CAUTION

Always take extra care when cleaning stairs.
Always switch the handheld off before connecting
or disconnecting the accessories and before
returning the handheld to the main body.

USE AS A HANDHELD VACUUM CLEANER

1. Press the handheld
release button.

3. Slide the On/Off suction control
forward to switch the handheld
on. The LED lights will illuminate
green indicating the power is on.

2. Lift to remove the handheld
from the main body.

10

USE THE 2IN1 TOOL

CAUTION

Always switch the vacuum cleaner off before removing
any blockages.

HOW TO

1. The 2-in-1 converts into:

1

= Crevice tool

2

= Dusting brush

1 2

3. Before returning the handheld
to the main body, slide the On/Off
suction control backwards, to
switch the handheld off. Pull
to remove 2-in-1 tool from the
handheld nozzle.

2. For a more detailed clean, line up
the 2-in-1 tool the with the nozzle
on the handheld and push fi rmly
into place.

11

7

Always switch off the vacuum cleaner before carrying out any
maintenance or troubleshooting.

EMPTY THE DIRT CONTAINER

CAUTION

1. Press the handheld
release button.

3. Press the dirt container
release button.

2. Lift to remove the handheld
from the main body.

4. Pull to separate the dirt
container from the handheld.

5. Remove the filter from the dirt
container by gently pulling the
filter frame.

12

6. Hold the dirt container over a bin
allowing dirt/debris to fall out.

CLEAN THE FILTER

24hr

CAUTION

For best cleaning results filters require cleaning every
4-6 uses or as needed depending upon use.
Do not use your vacuum cleaner without the filter in place.

HOW TO

1. Press the dirt container
release button.

3. Remove the fi lter from the dirt
container by gently pulling the
fi lter frame.

2. Pull to separate the dirt
container from the handheld.

4. Tap the fi lter over a bin to remove
any dirt/debris. Wash the fi lter
under running water
(40 degrees max).

5. Leave for 24hrs or until fully
dry before replacing.

6. Refi t the fi lter making sure the
fi lter frame is correctly lined up
in the dirt container.

13

7

CAUTION

For best performance all terminals must be free from
dust and dirt.

CLEAN THE TERMINALS

1. Using a dry cloth or soft dusting brush remove any dust/debris from
terminals on main body and handheld.

CLEAR BLOCKAGES

1. Press the handheld
release button.

3. Press the floorhead
release button.

2. Lift to remove the handheld
from the main body.

4. Pull to remove the floorhead
from the main body.

CAUTION: Use a blunt instrument such as a broom handle or something similar when removing

a blockage from the main body or floorhead.

14

5. Remove any blockage from the
main body or floorhead.

CLEAR A BLOCKAGE FROM THE BRUSHBAR

1. Using a pair of scissors remove
any threads or hair caught around
the brushbar.

HOW TO

CAUTION: If the brushbar has been obstructed, the Motor Protection Sensor may have been
activated. Remove the handheld and floorhead and clear any obstruction from the brushbar. Replace
the handheld and floorhead, wait 30 minutes for the vacuum cleaner to reset itself and retry.

715

REPLACE THE BRUSHBAR

1. To release the brushbar pull
and lift the release lock located
underneath the floorhead.

3. Replace the brushbar. Fit the
inverted round end of the
brushbar first, then line up and
push the other side of brushbar
into the floorhead. Refit the
release lock.

2. Remove the brushbar lifting the
side of the brushbar nearest the
release lock first.

16

Pre-motor filter
Model: DDST14FLT

HOW TO / ACCESSORIES

717

PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION

Why does my vacuum
cleaner have no power?

Why isn’t my vacuum
cleaner charging?

The vacuum cleaner may need
recharging.

The handheld may not be
correctly fitted into the main body.

The terminals may have
gathered dust/debris.

The brushbar has been obstructed. If the brushbar has been obstructed,

The terminals may have
gathered dust/debris.

The charger cable may be damaged.

Go to 'How to charge your 2-in-1
vacuum cleaner'.

Go to 'How to assemble your
2-in-1 vacuum cleaner'.

Go to 'How to clean the terminals'.

the Motor Protection Sensor may
have been activated. Remove the
handheld and floorhead and clear any
obstruction from the brushbar.
Replace the handheld and floorhead,
wait 30 minutes for the vacuum
cleaner to reset itself and retry.

Go to 'How to clean the terminals'.

Check the charger cable for damage.
If damaged please contact our
Customer Service AU: 1300 361 505
NZ: 0800 800 900

Why won’t the vacuum
cleaner pick up?

Why won’t the
brushbar turn?

Why has the LED light
turned red?

The dirt container may be full or
the filters may be clogged.

There may be a blockage in the
vacuum cleaner.

The brushbar may not be turning.

The vacuum cleaner may need
recharging.

Low suction has been selected,
increase to high suction.

The brushbar has been obstructed. If the brushbar has been obstructed,

The vacuum cleaner needs
recharging.

Go to 'How to empty the dirt
container' or 'How to clean the filter'.

Go to ‘How to clear blockages’.

Go to 'How to clear a blockage from
the brushbar'.

Go to 'How to charge your 2-in-1
vacuum cleaner'.

Go to 'How to use as an upright
vacuum cleaner'.

the Motor Protection Sensor may
have been activated. Remove the
handheld and floorhead and clear any
obstruction from the brushbar.
Replace the handheld and floorhead,
wait 30 minutes for the vacuum
cleaner to reset itself and retry.

Go to 'How to charge your 2-in-1
vacuum cleaner'.

CAUTION: To reduce the risk of personal injury, unplug the charger from the mains and vacuum

cleaner before carrying out any maintenance or troubleshooting checks.

18

TROUBLESHOOTING

719

Distributed by Techtronic Industries Australia Pty. Ltd.

31 Gilby Road, Mt Waverley

Victoria, 3149, Australia

www.dirtdevil.com.au

Service Line:
AU: 1300 361 505 / NZ: 0800 800 900

LET’S GO.