Desa PD15EA User Manual
OUTDOOR PATIO TABLE UMBRELLA STAND AND
ELECTRIC FOOT WARMER OWNER’S MANUAL
MODELS PD15EA, PG15EA, PL15EA, AND PV15EA
1500 WATT 120V 60HZ 12.5 AMPS
IMPORTANT: Read and understand this manual
before assembling, or starting this product. When
using electrical products, basic safety precau
tions should always be followed to reduce the
risk of fire, electric shock, and injury to persons.
Keep this manual for future reference.
TABLE OF CONTENTS
Safety Information ............................................... 2
Pre-Operating Instructions .................................. 3
Product Identification ...........................................
Unpacking ........................................................... 4
Installation ........................................................... 4
Operation ............................................................. 4
Cleaning .............................................................. 5
Fill In For Your Records
Serial No. ________________________
(Located on bottom)
Date of Purchase: _________________
Save this manual for future reference.
For more information, visit www.desatech.com
4
Troubleshooting ................................................... 5
Wiring Diagram .................................................... 5
Replacement Parts .............................................. 6
Technical Service ................................................
Service Centers ................................................... 7
Warranty and Repair Service .............................. 8
US
Tested and certified
to UL1278 Standard
for Safety
6
SAFETY INFORMATION
IMPORTANT: Read this owner’s
manual carefully and completely
before trying to assemble or op
erate this product. When using
electrical products, the following
basic safety precautions should
always be followed to reduce the
risk of fire, electric shock, and
injury to persons.
WARNING: As with most electrical appliances, electrical parts
in this product are electrically live
even when switch is off.
1. Do not use this product if the power circuit
does not have ground fault circuit interrupt
(GFCI) protection. GFCI should be wired
into the homes electrical circuit by a qualified
electrician.
2. This product must be used on a grounded
supply circuit.
3. Product must be used on a 15 or 20 amp
maximum overcurrent protection circuit.
4. DO NOT use indoors or plug this product into
an indoor circuit.
5. Avoid the use of an extension cord. Extension
cord may overheat and cause risk of fire. If you
must have an extension cord, the cord shall be
minimum size of 14 awg and not rated less
than 1875 watts. Use only 3 wire cord type
(3 prong plug) marked for outdoor use.
6. Do not use 16 or 18 gauge extension cords.
Damage to household wiring and/or fire could
result.
7. Avoid overheating the cord. DO NOT run cord
under outdoor carpeting. DO NOT cover cord
with throw rugs, runners, or the like. Arrange
cord away from traffic area and where it will
not be tripped over.
8. Do not run cord through doorways, holes in
floors or walls.
9. DO NOT operate product with a damaged
cord or plug, or after the product malfunc
tions, has been dropped or damaged in any
manner. Return product to service center for
examination, electrical or mechanical adjust
ment, or repair.
10. Do not remove, bend or modify any metal
prongs or pins of cord.
2
-
www.desatech.com
11. Do not allow the legs of chairs or the table to
rest on the power cord.
12. Always unplug product after use.
13. When unplugging, be sure to pull by the plug
and not the cord.
14.
Keep electrical plug dry and off of wet
surfaces.
15. Do not place or store where product can fall or
be pulled into swimming pool or body of water.
If product falls into water, unplug immediately.
DO NOT REACH INTO WATER. If water is
above the air intakes (see Figure 3, page 4) or
product is totally immersed in water, dispose
of heater properly.
16. Do not use near or place where standing water
can occur.
17. Do not hose down or pressure wash.
18. For outdoor use only in temperatures above
freezing.
19. Use product only for intended outdoor use as
described in this manual. Any other use not
recommended by the manufacturer may cause
fire, electric shock, or injury to persons.
20. Do not operate this product in the rain.
21.
Keep combustible and flammable materials,
such as gasoline and paint thinner, at least 3 ft
(0.9 m) from all sides of the product. DO NOT
place combustible liquids above the product.
Avoid spilling combustible liquids on the
product.
22. This product has hot and arcing or sparking
parts inside. Do not use where flammable
vapors are present
23. DO NOT insert or allow foreign objects to
enter any ventilation or exhaust opening as
this may cause an electric shock or fire, or
damage the product.
24. To prevent a possible fire, DO NOT block
air intakes in any manner. DO NOT use on
soft surfaces such as grass, wet soil, or where
openings may become blocked.
25. Do not permanently block air exhaust in any
manner.
26. DO NOT locate product on top of carpet.
27. Warn children of the risk of death by electri
cal shock. Extreme caution is necessary when
any product is used by, or near children, or
-
animals.
28. DO NOT attempt to repair or adjust any
electrical or mechanical parts on this unit.
Unauthorized repairs or alterations of this
product may increase the risk of fire, electrical
shock or injury to persons. The inside of the
unit contains no user serviceable parts. All
servicing should be performed by qualified
personnel only.
113612-01B
-
SAFETY INFORMATION
RESET
TEST
WARNING
Continued
29. Use only in accordance with the local ordinances and codes.
30. This product is not to be used as the sole
support for an umbrella. Umbrella must be
supported by a table.
31. Do not use or install umbrella into product
at temperatures below freezing. A damaged
product could result in the risk of fire, electric
shock and injury to persons.
32. Do not use this at any elevation above floor
level. Do not place on a table.
33. Locate product so “ON” light can be easily seen
10 ft (3.05 m) around and 5 ft (1.52 m) above.
34.
If a table cloth is used on the table above the prod-
uct, secure it to prevent movement due to wind.
35. Do not use in temperatures above 75° F
(28.9° C). Nuisance tripping of manual reset
thermal protector can occur.
36. Take precautions to prevent spilling drinks on
product.
37. If the product will not operate, see specific
instructions in Troubleshooting, page 5.
38. Save these instructions for future reference.
This product contains and/or
generates chemicals known to
the state of California to cause
cancer or birth defects, or other
reproductive harm.
PRE-OPERATING
INSTRUCTIONS
GROUND FAULT INTERRUPTER
• Since 1971 the National Electric Code (NEC)
has required Ground Fault Circuit Interrupter
devices on all outdoor circuits.
•
If your residence was built before 1971, check with
a qualified electrician to determine if a Ground
Fault Circuit Interrupter protector exists.
• Do not use this product if the circuit does not
have a GFCI protection.
• Do not plug this product into an indoor circuit.
• Typical accepted GFCI devices are shown in
Figure 1.
• Avoid the use of an extension cord. Extension
cord may overheat and cause risk of fire. If you
must have an extension cord, the cord shall be
minimum size of 14 awg and not rated less than
1875 watts. Use only 3 wire cord type (3 prong
plug) marked for outdoor use.
113612-01B 3
www.desatech.com
Test and
Reset
Buttons
GFCI Cord
Adapter
Figure 1 - GFCI Options
PLUG ADAPTER
IMPORTANT: This product must be used on a
grounded supply circuit.
An adapter as shown in Figure 2 is available for
connecting three-prong grounding type plugs to
two-slot receptacles. The green grounding lug
extending from the adapter must be connected to
a permanent ground such as a properly grounded
outlet box.
Metal
Screw
Cover of
Grounded
Outlet Box
Figure 2 - Plug Adapter
PRODUCT
IDENTIFICATION
Body
Lighted
On/Off
Power Cord
Tip
Switch
Access to
Thermal
Limit Switch
Push
Rod
Figure 3 - Umbrella Stand Warmer
Switch
Thumb
Screw
Air Intake
(opening
to bottom
of warmer)
(Bottom
View)
Air Intakes
Warm
Air
Exhaust
UNPACKING
1. Remove all packing items applied to product
for shipment.
2. Remove all items from carton.
3. Check items for any shipping damage. If
product is damaged, promptly inform dealer
where you bought product.
INSTALLATION
1. Locate product under outdoor patio table on
hard, level, dry surface. Post of tip over switch
must be on solid surface for product to work.
Listen for the “click”. See Figure 3 for switch
location.
2. Slowly lower umbrella pole into product. Do
not drop pole, it may damage product.
3. Tighten thumb screw of product to secure pole.
Pole will be approximately 7 inches higher
than if used without this product.
4. Make sure the product is in the OFF posi
tion before plugging into a grounded GFCI
protected 120V 60 HZ outlet.
5. Avoid overloading your circuit by not using
other high wattage products in the same outlet.
At 1500 watts, this unit draw 12.5 Amps.
OPERATION
IMPORTANT: Review and understand the warnings in the Safety
Information section, page 2.
They are needed to safely oper
ate this product. Follow all local
ordinances and codes when
using this product.
1. Push lighted ON/OFF switch.
2.
The power light will remain lit during
operation.
3. Stay back from product until all water or
debris has blown clear.
4. Product will warm in a few minutes.
-
-
4
www.desatech.com
113612-01B
CLEANING
POWER PLUG
120V 60Hz
GREEN
BLACK
N
L
N
L
WHITE
ON/OFF
SWITCH
HEATING
ELEMENT
MOTOR
BLACK
MANUAL RESET
THERMAL LIMIT
SWITCH
TIP SWITCH
BLACK
GREEN
BLACK
BLACK
WHITE
WHITE
DURING SEASON CARE
Always unplug the product before moving or
cleaning.
1. Do not disassemble. Carefully wipe the exte
rior of unit with a soft, damp cloth.
2. After cleaning, be sure to completely dry the
unit with a cloth or towel.
AFTER SEASON CARE
Store product indoors in a dry location. No maintenance is required for this product.
6. Lightly push red button to reset switch.
7. Replace removed plug in hole. Perform a trial
operation.
8. If repeated resetting of the thermal limit switch
is required, have the product serviced by an
-
authorized service center.
Push Rod
TROUBLESHOOTING
CAUTION: Risk of electric
Access to
Thermal
Limit Switch
shock. Do not open. No user servicable parts inside. Take heater to
an authorized service center.
If your product fails to operate:
1. Make sure the electrical outlet GFCI or circuit
breaker and extension cord is working.
2. Check for operation of tip switch. The ON/
OFF switch light can be on but the tip switch
OFF. Move product until a “click” is heard.
To prevent damage of tip switch post, do not
slide product.
3. Look for obstructions around fan. If you find
an obstruction, turn the product OFF and
UNPLUG THE PRODUCT. Have the product
serviced by a qualified individual.
4. Check for tripped thermal protector. Motor
and heating element do not operate. Wait 10
minutes for product to cool. Push reset button.
See Thermal Limit Switch below.
THERMAL LIMIT SWITCH
If product is used in temperatures below 75° F
(28.9° C), the limit switch should not require
resetting unless there is a malfunction. If a malfunction does occur, have the product serviced by
an authorized service center.
Resetting Thermal Limit Switch
1. Unplug product.
2. Allow product to cool.
3. Turn product upside down.
4. Remove plug on bottom.
5. Insert provided plastic push rod through hole
and guide to small red button on thermal
limit switch (see Figure 4). A flashlight will
improve visability.
113612-01B 5
www.desatech.com
Figure 4 - Resetting Thermal Limit Switch
WIRING DIAGRAM
Loading...