The lightning flash with arrowhead symbol, within an equilateral triangle
is intended to alert the user to the presence of un-insulated “dangerous
voltage” within the products enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to the persons.
The exclamation point within an equilateral triangle is intend to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the appliance.
Correct disposal of this Product
(Waste Electrical & Electronic Equipment (WEEE)
Your product is designed and manufactured with high quality materials and
components which can be recycled and reused.
This symbol means that electrical and electronic equipment, at their endof-life should be disposed of separately from your household waste.
Please dispose of this equipment at your local community waste collection/
recycling center.
In the USA there are separate collection systems for used electrical and
electronic products. Please help us to conserve the environment we live in!
directives.
1
Safety Information
Safety Information
To ensure reliable and safe operation of this equipment, please read carefully all the
instructions in this user guide, especially the safety information below
Electrical safety
• The TV set should only be connected to a mains supply which matches that stated on
the label on the mains adaptor.
• To prevent overload, don't share the same mains supply socket with too many other
items of equipment.
- Do not place any connecting wires where they may be stepped on or tripped over.
- Do not place heavy items on the leads, which may damage them.
- Hold the Mains plug, not the wires, when removing from a socket.
- During a thunderstorm or while leaving the TV for long periods, disconnect the aerial
(if outdoor) and mains adaptor from the supply.
- Do not allow water or moisture to enter the TV or mains adaptor. Do NOT use in wet
or moist areas such as Bathrooms, steamy kitchens or near swimming pools.
• Pull the plug out immediately, and seek professional help if:
- the mains plug or cable is damaged.
- liquid is spilt onto the set, or if it is accidentally exposed to water or moisture.
- anything accidentally penetrates the ventilation slots.
- the set does not work normally.
- Do NOT remove the safety covers. There are no user serviceable parts inside.
You may invalidate the warranty. Qualified personnel only are permitted to service
this apparatus.
- To avoid battery leakage, remove exhausted batteries from the remote control
handset, or when not using for along period.
- Do NOT break open or throw exhausted batteries on a fire.
.
Physical safety
• Do NOT block ventilation slots in the back cover. You may place the TV in a cabinet,
but ensure at least 5cm (2") clearance all around the unit.
• Do NOT tap or shake the TV screen, you may damage the internal circuitry. Take good
care of the remote control, do not drop it or allow it to come into contact with liquids.
• To clean the TV use a soft dry cloth. Do NOT use solvents or petrol based fluids. For
stubborn stains, you may use a damp soft cloth with diluted detergent.
2
Accessories & Technical Specification
Accessories
123
456
789
CH.list
0
PICTURE SOUND SLEEP DISPLAY
VOL+
MUTE
VOL-
EXIT
OK
ROOT
TV/TXT HOLD NICAM/A2
A-B
SLOW
SUBTITLE
REPEAT
PROGRAM ANGLE TITLE D.MENU
INPUT
CH+
CH-
MENU
FAV
LANGUAGE
ZOOM
SIZEINDEX REVEALSUBPAGE
GOTO
SETUP
User’s Manua
l
Remote control
Mains adapterMains cable
* Note: The configuration of the components may look different from the following illustration
Technical Specification
- TV-System PAL BG/DK/I SECAM BG/DK
- Screen Size
- Resolution
- Aerial input
- Audio output power
- Power Consumption
22inch(diagonal)
1920x1080
2x3W
DC 12V 5A 60W
3
Product Introduction
Front View
Product Introduction
Please insert a12cm disc
according to the instruction
marked below the DVD slot.
LED Indicator
Remote Control Window
(keep clear)
1). (IR) Infrared Receiver: Receives IR signals from the remote control.
(Power on/Standby)LED Indicator: Press POWER to turn on and off.
Indicator on(Red) Standby mode
Indicator on Power on mode
The effective receiving range for the signal is 5-8 metres from the front of the remote
control window, and 30
0
to the left or right side and 200 above or below the remote control
window.
2).The functions of the buttons are described as bellows:
MENU: Press to display the OSD menu, press again to exit the menu.
CH+/-: Press to scan through channels.
VOL+/-: Press to adjust the volume.
INPUT: Press to display the input source menu.
PLAY: Play/pause the disc playing.
EJECT: Eject the disc.
POWER: Turn on/standby the TV set.
4
Connections
Connections
USB
SCART
POWER: Connect to the mains adaptor.
USB:Connect to USB device for multimedia
HDMI: Connect it to the HDMI of DVD or other equipment.
VGA: For PC display.Connect it to the D-Sub 15 pins analog output connector of the PC.
PC-IN: Connect it to the audio output terminal of PC.
SCART: Connect them to the SCART video output terminal of DVD.(used in component source)
Headphone: Connect it to your headphone or other audio equipment.
COAX:Output to audio amplifier
RF: Connect antenna or cable 75 Ohm coaxial to receive TV signal.
R/L in: Connect them to the audio output terminal of DVD.(shared with YPbPr)
VIDEO: Connect it to video output terminal of DVD.
YPbPr: Connect them to the YPbPr video output terminal of DVD.(used in
component source)
5
Remote Control
Remote Control
The remote control is using Infra-Red(IR). Point it towards the front of the LCD TV. The remote
control may not work correctly if it is operated out of range or out of angle.
INPUT
POWER : Turn on/standby the TV.
INPUT : Source select.
123
456
789
CH.list
0
PICTURE SOUND SLEEP DISPLAY
VOL+
VOL-
EXIT
MUTE
MENU
OK
ROOT
TV/TXTHOLD NICAM/A2
A-B
SLOW
SUBTITLE
REPEAT
PROGRAM ANGLETITLE D.MENU
ZOOM
SIZEINDEXREVEALSUBPAGE
GOTO
LANGUAGE
SETUP
CH+
CH-
FAV
0-9, -/-- : Choose channel.
: Go to program you latest program.
CH/LIST: Display the programs list.
PICTURE: Select the picture mode.
SOUND : Select the sound mode.
SLEEP: Time shutting down.
DISPLAY: Display playing status
CH+/-: Scan the channel.
VOL+/-:Volume up/down.
MUTE: Silence status.
Exit from the current menu.
EXIT:
MENU : TV system menu.
Cursor up/down keys in OSD menu
Cursor left/right keys in OSD menu
OK: Comfirm button
ROOT: Come back to the home page.
TV/TXT: Teletext on/off
HOLD
: Hold or carry on the current subpage
NICAM/A2:NICAM/A2 select.
SUBPAGE: Go to subpage
INDEX: Direct recall of page 100
SIZE: Press to see top half of page double size, Press again to see the
bottom half of page double size.
Press again for normal size
REVEAL: Reveal any hidden text, for example-quiz answer.
PROGRAM: Edit the program and play.
ANGLE: Select DVD picture angle.
D.MENU
: DVD play list/Disc menu.
TITLE: DVD title.
6
Remote Control
Remote Control
123
456
789
INPUT
0
PICTURE SOUND SLEEP DISPLAY
VOL+
VOL-
EXIT
CH.list
MUTE
MENU
OK
ROOT
FAV
CH+
CH-
: Load/eject DVD disc.
: Play/Pause program
: Stop program
: fast reverse
: fast forward
: previous chapter
: next chapter
A-B: Select and play the preferable paragraph of DVD program
by pressing this key twice at the beginning and end of it.
SLOW: Play DVD programs at slow speed.
ZOOM: Adjust picture size in USB mode.
LANGUAGE: Select DVD disc language.
SUBTITLE: Turn on/off the subtitle display in DTV mode
and DVD mode.
REPEAT : Repeat playing the title or chapter.
GOTO : Play your favorite title/chapter/track.
SETUP
: DVD system setup.
COLOUR BUTTONS : Short cuts-follow the coloured links in the text.
TV/TXTHOLD NICAM/A2
A-B
SLOW
SUBTITLE
PROGRAM ANGLETITLED.MENU
REPEAT
ZOOM
SIZEINDEXREVEALSUBPAGE
GOTO
LANGUAGE
SETUP
7
Loading...
+ 22 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.