DEMI 3-3PA User guide

Page 1
DEM Part Number 3-3PA

10GHz Linear Amplifier

Specifications

Frequency range: 10.0 - 10.5 GHz.
Power Input for rated power out: 10 mW for linear operation
Return Loss >10dB@ 10.368 GHz
DC requirements: 13.8 volts DC@ 2.2 amps. for nominal output
16 volts DC absolute maximum 10Volts Minimum
Connectors: SMA(F) only
Size: 2" L x 4" W x 2" H Standard
1.5" L x 4.1" W x 2" H Optional
Active devices: FM5061VF (Eudyna)
Keying Option: PTT - H (1.5-15Volts for transmit)
PTT - L (Ground for transmit)
The Down East Microwave Inc. 3-3PA linear amplifier is a simple gain block for the amateur 3 cm band. It will provide >3 Watts saturated output power with 10mW of drive. It requires external T/R switching and can be used by itself or as a driver for a higher power amplifier. The amplifier requires a single 13.8 volts DC supply at 2.2 amps, but will operate at reduce ratings down to 10 volts and up to 16 volts. The unit is provided with an internal negative bias supply and keying circuit for ease of use.
To achieve maximum performance the amplifier should be mounted in a well ventilated area with heat sink fins in the vertical position for optimum cooling, or bolted to a heat sink if the optional unit is ordered. It is advisable but not necessary to use circulators and band pass filters when available. This will prevent stray oscillations and needless waste of power by amplifying local oscillator frequencies or generating high power out of band spurious signals. This amplifier is a perfect match for our 10368-144 transverters. Optional TR switching to key the amplifier directly with the transverter is available. Please contact DEMI with any question and for transverter/amplifier package deals.
/Built/3-3pa.doc 1 Rev A 4/13/2007
Page 2
All resistors and capacitors are chip components unless specified. C1 1.0ρF C12 2.2µF can C2 1000ρF C13 0.1µF C3 0.1µF C14 10.0µF C4 2.2µF can C15 10.0µF C5 2.2µF can C16 1000ρF C6 100µF can C17 10.0µF C7 0.1µF C8 0.1µF R3 5.1K C9 0.1µF R4 5.1K C10 1000ρF R6 51 C11 1.0ρF R7 3 10 watt
Pin Out: 1 VGG 2 RF in 3: N.C. 4: VDD 5: RF Output 6: VDD
3-3PA Component List
VR1 78M05 Q2 2N2222 D1 1N4000 D2 1N914 or 1N4148 D3 CZ5348B K1 G5V-5
R2 200 POT IC1 NMA0505S
IC2 FMM5061VF PCB board
3
2
1
4
5
6
/Built/3-3pa.doc 2 Rev A 4/13/2007
Page 3
/Built/3-3pa.doc 3 Rev A 4/13/2007
Page 4
E5
+
E4
E9
+
E11
E7
+
+
E8
D3
E10
E1
+
+
+
E6
/Built/3-3pa.doc 4 Rev A 4/13/2007
Loading...