Delonghi H770715 Instruction manuals
7
IMPORTANT INSTRUCTIONS
EN
When using electrical appliances, basic
precautions should always be followed to
reduce risk of fire, electric shock, and
injury to persons, including the following:
1. Read all instructions before using this
heater.
2. If your radiator is equipped with a
polythene tape used as carry handle,
remove it before connecting appliance to the outlet.
3. This heater is hot when in use. To
avoid burns, do not let bare skin
touch hot surfaces. Use handle when
moving this heater. Keep combustible
materials, such as furniture, pillows,
bedding, papers, clothes, and curtains at least 3 feet (90 cm) from the
front and top of the heater and keep
them away from the sides and rear.
4. Extreme caution is necessary when
any heater is used by or near children
and whenever the heater is left operating and unattended.
5. Always unplug heater when not in
use.
6. If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
7. Do not operate any heater with a
damaged cord or plug or after the
heater malfunctions, has been dropped or damaged in any manner. If
heater has leaked any oil, discontinue using the heater and contact the
service center as indicated in the
instruction leaflet. Return heater to
authorized service facility for examination, electrical or mechanical
adjustment, or repair.
8. Do not use outdoors. Household use
only.
9. This heater is not intended for use in
bathrooms, laundry areas and similar
indoor locations. Never locate heater
where it may fall into a bathtub or
other water container.
10. Do not run cord under carpeting. Do
not cover cord with throw rugs, runners, or the like. Arrange cord away
from traffic area and where it will
not be tripped over.
11. To disconnect heater, turn controls to
off, then remove plug from outlet.
12. Connect to properly polarized outlets
only.
13. Do not insert or allow foreign objects
to enter any ventilation or exhaust
opening as this may cause an electric
shock, fire, or damage the heater.
14. To prevent a possible fire, do not
block air intakes or exhaust in any
manner. Do not use on soft surfaces,
like a bed, where openings may become blocked.
15. A heater has hot or arcing or
sparking parts inside. Do not use it
in areas where gasoline, paint, or
flammable liquids are used or stored.
16. Use this heater only as described in
this manual. Any other use not
recommended by the manufacturer
may cause fire, electric shock, or
injury to persons.
17. To prevent overload and blown fuses,
be sure that no other appliance is
plugged into the same outlet (receptacle) or into another outlet (receptacle) wired into the same circuit.
18. It is normal for the heater’s plug and
cord to feel warm to the touch. A
plug or cord which becomes hot to
the touch or becomes distorted in
shape may be a result of a worn electrical outlet. Worn outlets or receptacles should be replaced prior to
further use of the heater. Plugging
heater into a worn outlet /receptacle/
may result in overheating of the
power cord or fire.
19. Do not use an extension cord becau-
se it may overheat and cause a risk
of fire. However, if you have to use
8
HOW TO USE YOUR HEATER
“EASY WHEEL”SYSTEM
Turn the radiator upside-down on a rug or a soft surface in order to prevent damaging the paint
finish. Fully unfold the castors by turning them outwards (Fig. 1).
Turn the radiator back to its upright position.
CAUTION
Always operate the heater in upright position only (wheels on the bottom, controls on top). Any
other position could create hazardous situation!
an extension cord, the cord shall be
No. 14 AWG minimum size and
rated not less than 1875 watts, and
has to be used only for supplying
power to this heater.
20. Be sure that the plug is fully inserted
into an appropriate outlet. Please
remember that outlets also deteriorate due to aging and continuous use:
check periodically if signs overheating or deformations are evidenced
by the plug. Do not use the outlet and
CALL your electrician.
21. Check that neither the appliance nor
the power cable have been damaged
in any way during transportation.
22. Make sure that no pieces of polystyrene or other packaging material have
been left between one element of the
appliance and another. It may be
necessary to pass over the appliance
with a vacuum cleaner.
23. When switching on the appliance for
the first time, allow it to run at full
power for about two hours to get rid
of the unpleasant smell. Make sure
that the room in which the appliance
is located is well ventilated during
this operation. It is normal for the
appliance to emit small cracking
sounds when you turn it on for the
first time.
CAUTION: to prevent electric shock
match wide blade of plug to wide
slot, then fully insert.
SAVE THESE INSTRUCTIONS
For Household use only
fig. 1
Loading...