De'Longhi GB-5711010191 Owner's Manual

DRAGON HM3

We were thinking of you

when we thought of it

IMPORTANT
DO NOT OPERATE WITHOUT READING
INSTRUCTIONS FIRST

Spare copies of this leaflet can be obtained
from your dealer

Proudly distributed by

De’Longhi Australia Pty Limited

P.O. BOX 4540
CASULA MALL NSW 2170
Customer Service Ph: 1800 126 659
Fax: [phone]
www.delonghi.co.au
e-mail: [e-mail]

De’Longhi New Zealand Limited

25 Carbine Road
Mt Wellington
Auckland, New Zealand
P.O. Box 58-056 Botany
MANUKAU 2163
Customer Service Ph: 0508 200 300
Fax: [phone]
www.delonghi.co.nz
e-mail:[e-mail]

Fig.1

2

Thank you for choosing this De’Longhi radiator. To get
the very best out of your new radiator it is advisable to
read these instructions before using it. This will ensure
that you gain optimum results and use the appliance
safely.

General instructions

Take the radiator out of its packing box and remove any poly­styrene pieces or any other packaging material that might be
lodged inside it.
Make sure that the radiator has not been damaged during
transit and that the mains cable is in working order. Do not
operate the radiator if damaged.

“Easy wheel”system

Turn the radiator upside-down on a rug or a soft surface in order
to prevent damaging the paint finish. Fully unfold the castors by
turning them outwards (Fig. 1). Turn the radiator back to its upright
position.

Electrical connection

- Before plugging the radiator into the mains, check that
your supply voltage is the same as that shown on the rating
plate of the radiator.

- If using more than one appliance at a time, it is important
to ensure that the ring main is adequate to cope with the
power requirements.

- It is important to ensure that the socket is adequately
earthed.

- THIS APPLIANCE COMPLIES WITH DIRECTIVE
2004/108/EEC ON RADIO INTERFERENCE SUPPRES­SION.

How to use it

Switching on

Plug the radiator in and position the thermostat slider to
maximum and turn the radiator on as follows using the power
selector:

• Turn the power selector to position 1 to select minimum
output (the light on the left will come on).

• Turn the power selector to position 2 to select medium
output (the light on the right will come on).

• Turn the power selector to position 3 to select maximum
output (both lights will come on).