DeLonghi ELECTRIC STOVE Instructions Manual

INSTRUCTIONS

ELECTRIC STOVE

Australia

Po Box 4156

MILPERRA BC NSW 1891

Customer Service Ph: 1800 126659
Fax: [phone]
e-mail:

[e-mail]

Proudly distributed by

De’Longhi New Zealand Limited

25 Carbine Road
Mt Wellington
Auckland, New Zealand

PO Box 58-056
Greenmount
Manukau 2141
Auckland, New Zealand

Customer Service Ph: 0508 200 300
Fax: [phone]
e-mail:[e-mail]

2

Description of appliance

B

H

M

O

N

P

Q

A

L

I

C

D

E

G

F

DESCRIPTION OF APPLIANCE
A) Fire effect shield
B) Door
C) Function slider
D) Hot air output grille
E) Thermostat dial
F) Coal/pebbles/logs support shelf
G) Flame effect dimmer

H) Decorative flue
I) Wall flange marked "wall"
L) Stove flange marked "stove"
M) Wall screw
N) Stove screw
O) Drilling template
P) Hole cover
Q) Fixing plug

3

Thank you for choosing this De’Longhi heater. To get the very best out of your new heater it
is advisable to read these instructions before using it. This will ensure that you gain optimum
results and use the appliance safely.

General instructions

Your stove is designed for use throughout your living area, such as against a wall or in a corner, to
add instant warmth and ambiance.
Position the fire so that the plug socket is accessible.
Always ensure there is sufficient airflow, otherwise the operation of the stove will be compromised.

Placing the pebbles/coal/logs

Depending on which stove you have purchased you will find pebbles, coal or logs packed with your
stove. Once the stove is placed in your chosen location, unpack the pebbles/coal/logs from the
accessory box and arrange inside the stove on the support shelf (F).
Arrange the pebbles/coal/logs as you wish using as many as you require. If your stove has
pebbles, we suggest spreading the smaller ones across the shelf as a base. The 3 large pebbles
should then be placed on top with the medium ones used to fill any gaps where light could esca­pe.

Operating the stove

The stove is controlled by the function slider.

Tur ning on the Flame Effect

The fire effect can be on whether or not the heating is on ( position).

Heat Levels

For minimum heat, set the slider on the minimum power position I.
For maximum heat, set the slider on the maxmum power position II.

Adjusting the thermostat

When the room has reached the required temperature, turn the thermostat dial (E) slowly until a
"click" is heard and no further. This temperature will be regulated automatically and kept con­stant by the thermostat.

Off

Maximum powe

r

Minimum power

Flame Effect only

Slider