DeLonghi Electric Focal Point Fire User Manual

BURANO ACERO

Electric Focal Point Fire

De’Longhi; February 2004 Issue 3

Instructions for use

Please retain for future reference

Thank you for choosing to purchase a De’Longhi fire. Please read the
instructions carefully in order to enjoy your product fully.

GENERAL INSTRUCTIONS

Remove the fire from the packaging, checking that neither the fire nor the
power cable has been damaged during transport. Do not operate the fire if
damaged.
The pebbles can be found in one of the two long brown boxes that fit down
either side of the fire, so ensure that the accessories are removed before
discarding the boxes.

INSTALLATION OF THE FIRE

Your fire is designed for use against a flat wall surface, and a spacer frame
is supplied to enable it to fit flush. Alternatively you can use within an
existing chimney or as part of a fireplace mantel and surround suite. The
rebate depth is standard at 2

Position the fire so that the plug socket is accessible.

IMPORTANT: Access must be allowed for the fire to be serviced,
which involves the heater being moved forward in order to access
the rear. Sufficient mains lead must be available to allow the fire to
be moved for access when servicing.

3

/4 inches (7cm) which should fit perfectly.

ELECTRICAL CONNECTION (UK Only)

Your appliance comes fitted with a plug and will incorporate a 13 amp fuse. If it does not fit your socket,
the plug should be cut off from the mains lead and an appropriate one fitted as below.
WARNING: Very carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 amp
socket elsewhere in the house as this could cause a shock hazard. With alternative plugs not incorporating
a fuse the circuit must be protected by a 15 amp fuse.
If the plug is a moulded-on type, the fuse cover must be refitted when changing the fuse using a 13amp
Astra approved fuse to BS1362. In the event of losing the fuse cover, the plug must not be used until a
replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct
replacement fuse cover is that marked on the base of the plug.

WARNING- THIS APPLIANCE MUST BE
EARTHED

IMPORTANT

The wires in the mains lead are coloured in accordance
with the following code;

Green and yellow: EARTH
Blue: NEUTRAL
Brown: LIVE

As the colours of the wires in the mains lead may
not correspond with the coloured markings
identifying the terminals in your plug, proceed as
follows:
The green and yellow wire must be connected to
the terminal in the plug marked with the letter E or

the earth symbol
and yellow.
The blue wire must be connected to the terminal
marked with the letter N or coloured black.
The brown wire must be connected to the terminal
marked with the letter L or coloured red.

or coloured green or green

Should you wish to connect the fire to a fused spur, this must be carried
out by a competent electrician in accordance with the IEE wiring
regulations.

Where the inset fire is being used in an existing chimney, it is important
that the chimney is blocked off to prevent airflow problems within the fire.
Where a chimney is not blocked off sufficiently the heater may cut out and
the flame effect stop, or work poorly.