Delonghi DEX210, DEX214F, DEX216F, DEX212F Instruction manuals

Page 1
INTRODUCTION
Read these instructions carefully before using the appliance. Failure to follow these instructions may result in injuries and equipment damage. The manufacturer is not liable for damages resulting from failure to follow these instructions for use.
SAFETY Symbols used in these instructions
Important warnings carry these symbols. These warnings must be strictly observed. Failure to observe these indications could result in electric shocks, serious injuries, re or damages to the appliance.
Danger!
Failure to observe the warning may result in life threatening injuries by electric shock.
Caution!
Failure to observe the warning may result in injuries or equip­ment damage.
Please note!
This symbol identies important advice or information for the user.
FUNDAMENTAL SAFETY WARNING
Caution!
• The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person respon­sible for their safety.
• Children should be supervised to ensure that they do not play with the appli­ance.
FOR EUROPEAN MARKET ONLY:
• This appliance can be used by children aged from 8 years and above and per-
sons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concern­ing use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appli­ance. Cleaning and user maintenance shall not be made by children without supervision. Keep the appliance and its cord out of reach of children aged less than 8 years.
Danger!
Because the appliance runs on electricity, electrical shocks can­not be excluded. Therefore, please observe the following safety instructions:
If the power cord is damaged, it must
be replaced by the manufacturer or the manufacturer’s Customer Experience in order to avoid all risk.
• Do not touch the appliance with wet hands or feet.
• Do not touch the plug with wet hands.
• Make sure that the socket used is freely accessible at all times, enabling the appliance to be unplugged when necessary.
Unplug directly from the plug only.
Never tug the power cord, because it could damage the
cord.
To disconnect the appliance completely you must unplug it from the mains socket.
If the appliance is faulty, do not attempt to repair.
Turn it o, unplug from the mains socket and contact
Customer Experience.
Never move the appliance by pulling on the power cable.
• The appliance must not be modied in any way, as any modications may be extremely dangerous.
Do not use an extension cable.
• The appliance must be installed in accordance with the rules on household appliances in force in the country concerned.
• The appliance must be connected to an ecient earth system. Have your electrical circuit checked by a qualied electrician.
9
Page 2
Caution!
• After unpacking, make sure the appliance is complete and undamaged.
• Keep all packaging material (plastic bags, polystyrene foam) out of reach of children.
• Use the appliance on a at surface.
• Do not use the appliance in case of obvious damage. Con­tact Customer Experience.
Problems and repairs
In the event of problems, rst try and resolve them by reading the information given in the "Troubleshooting" section on page 13
If the appliance requires repair, always contact Customer Expe­rience - see enclosed guarantee. Always insist on original spare parts. Repairs carried out by unauthorized personnel may be dangerous and invalidate the guarantee.
Appropriate use
This is a household appliance only. Use this appliance only as described in this instruction manual. These instructions are not intended to cover every possible con­dition and situation that may arise. Common sense and caution must be used when installing, operating and maintaining any electrical appliance.
Specic information regarding appliances with R290 refrigerant gas
Thoroughly read all of the warnings.
• When defrosting and cleaning the appliance, do not use any tools other than those recommended by the manufacturing company.
• The appliance must be placed in an area without any continuous sources of ignition (for example: open ames, gas or electrical appliances in operation).
Do not puncture and do not burn.
Refrigerant gases can be odourless.
The appliance must be installed, used and stored in an area that is greater than 4 m2.
• This appliance contains R290 refrigerant gas.
(For more details on the refrigerant, see back cover).
• R290 is a refrigerant gas that complies with the European directives on the environment. Do not puncture any part of the refrigerant circuit.
• If the appliance is installed, operated or stored in a non­ventilated area, the room must be designed to prevent the accumulation of refrigerant leaks resulting in a risk of re
or explosion due to ignition of the refrigerant caused by electric heaters, stoves, or other sources of ignition.
• The appliance must be stored in such a way as to prevent mechanical failure.
• Individuals who operate or work on the refrigerant circuit must have the appropriate certication issued by an accredited organisation that ensures competence in handling refrigerants according to a specic evaluation recognized by associations in the industry.
Repairs must be performed based on the recommendations from the manufacturing company.
Maintenance and repairs that require the assistance of
.
other qualied personnel must be performed under the supervision of an individual specied in the use of am-
mable refrigerants.
• The materials used for packaging can be recycled. You are therefore recommended to dispose of them in special dif­ferentiated waste collection containers.
Do not use the appliance outdoors.
Do not obstruct the entrances and exits of air.
Do not use the appliance in laundry rooms.
Electrical connections
After transporting the appliance, wait at least an hour before turning it on. Before plugging the appliance into the outlet, check that:
• The mains voltage corresponds to the operating voltage stated on the rating plate.
• The mains socket and the electrical supply line are ade­quate for the required load.
• The power outlet matches the plug. If this is not the case, have the plug replaced by a qualied electrician
The outlet is properly grounded.
Operating instructions
Read these instructions carefully before using the appliance.
• Keep these instructions.
If the appliance is transferred to other owners, they should
also be given these instructions.
• Failure to follow these instructions may result in injuries and equipment damage.
The manufacturer is not liable for damages resulting from
failure to follow these Instruction for Use.
Please refer to the guarantee leaet for contact details.
Please note!
Keep these Instructions for Use. If the appliance is transferred to other owners, they should also be given these instructions.
10
Page 3
INSTALLATION
Position the appliance in the room to be dehumidied. A free space of at least 50 cm must be left at the front of the dehu­midier, so as not to block the air outlet. For ecient ventilation a space of about 5-10 cm should be left at the back of the ap­pliance. The condensate can be drained in one of the following ways:
a) Draining into the tank
The condensate can be drained directly into the tank. The tank can be easily removed (Fig.1).
b) Continuous external draining
If the appliance is to be operated for long periods but you are unable to empty the tank regularly, you are recommended to use continuous draining.
1) Remove the continuous drain cap by turning it counter­clockwise then remove the rubber stopper from the spout 2 (Fig. 2).
2) Apply the accessory tube to the spout as shown in Figure 3.
3) Make sure the end of the hose is no higher than the spout. Otherwise the water will ow into the tank of the appli­ance (Fig. 4).
Make sure there are no kinks in the hose.
HOW TO DEHUMIDIFY
Connect the appliance into an outlet.
Check that the "tank full/tank missing" indicator light ( ) is turned o, otherwise empty the tank or position it correctly.
To turn the appliance on, press the ON/STAND BY button
.
Press the “MODE” (B2) button to select the desired
humidity ( , , , ). The appliance will adjust the humidity level according to
your choice:
Approx. Approx. Approx.
Selecting , the “dry” function is activated, ideal to speed up the drying of laundry.
• If the humidity in the room is greater than the set humidity, the appliance will start to dehumidify and will stop functioning only when the desired level of humidity is reached.
60% 50% 40%
Please note!
environment humidity environment humidity environment humidity
DESCRIPTION
(page 3)
Appliance description (page 3 - A ) A1. Control panel A2. Condensate collection tank A3. Lifting handle A4. Air intake grill A5. Dust Air lter or silver-ion air lter (on certain
models only)
A6. Air outlet grill A7. Condensate drain hose (approx. 1 m) A8. Anti-allergen lter (on certain models only)
Control panel description (page 3 - B ) B1. ON/STAND-BY button B2. MODE button B3. Tank full/tank missing indicator light B4. Dehumidication/frost protection function light. B5. Set humidity level
INDICATOR LIGHTS Tank control light (Tank control system)
This dehumidier is equipped with a device that monitors the correct functioning of the appliance. The corresponding indicator light, located on the control panel, turns on to warn the user when:
1. the tank is full:
empty the tank
2. the tank is missing:
reposition the tank
3. the tank is positioned incorrectly:
position it properly
4. in continuous drain:
the hose is obstructed or the dierence in level is too great (the water continues to be discharged into the tank)
remove the obstruction.
Once the cause has been eliminated, the light goes out and the appliance resumes operation.
Low temperature operation indicator light
When the room temperature is too low, the electronic low tem­perature operation device is activated. The device makes the ap-
11
Page 4
pliance operate by alternating dehumidication cycles and fan only cycles, thus avoiding the formation of frost. For frequent use in cold environments, it is recommended to heat the room at the same time, even slightly. This allows the dehumidier to operate in conditions that ensure better performance and faster dehumidication.
Please note!
• The appliance is equipped with a security device (delay of 3 minutes) that protects the compressor against too frequent starts and stops.
• When star ted up, or when power is restored, the ap­pliance operates in the mode selected before it shut down.
CLEANING AND MAINTENANCE
Always remove the plug from the power socket before perform­ing any cleaning or maintenance operations. For safety reasons, never wash the dehumidier using a water jet.
Cleaning the cabinet
• Clean the appliance using a damp cloth then dry with a dry
cloth.
• Never use petrol, alcohol or solvents to clean the appliance.
• Never spray the appliance with insecticides or similar. These
could cause the plastic parts to warp.
Cleaning the dust air lter or silver-ion air lter (on certain models only)
If the lter is dirty, air circulation is compromised and the ef­ciency of dehumidifying is decreased. It is therefore good practice to clean the lter at regular intervals. The frequency depends on the environment and the duration of operation. If the unit is used constantly or systematically, you are recom­mended to clean the lter once a week.
• To remove the air lter, remove the grill and extract the lter
by pulling it (see Fig. 5).
• Use a vacuum cleaner to remove dust accumulations from
the lter. If the lter is very dirty, rinse well with lukewarm water. The temperature of the water should not exceed 40˚C. After washing the lter, allow it to dry completely before re­inserting it.
If present, the silver-ion air lter, besides retaining powder
particles, has also an ecient antibacterial action. In addi­tion, it greatly reduces irritants such as pollen and spores.
The lter is treated with small particles of silver (on the scale
of millionths of a millimetre) which are able to block the multiplication of and destroy any bacteria or spores coming into contact with them.
Anti-allergen lter (on certain models only)
Some models are equipped with an anti-allergen lter that can notably reduce the concentration of allergens transported by air in a quick and ecient way. To apply the lter, remove it from the packaging and insert it into its place in the grill at the back of the appliance, as shown in Figure 6. It is recommended to replace the lter every 2 years.
If the appliance is not used for long periods
• After unplugging the appliance from the power socket, empty the tank.
• Clean and reposition the lter.
• Cover the appliance with a plastic bag to protect it from dust.
DISPOSAL
The appliance must not be disposed of with house­hold waste, but taken to an authorised waste separa­tion and recycling centre.
TECHNICAL SPECIFICATIONS
Power supply voltage See rating plate
Absorbed power “
Frost protection device Yes
Fan speeds 1
Air lter Yes
Anti-allergen lter (only on certain models) Yes
Tank capacity 2.1 litres
Operation limits:
temperature 2°C-30°C
relative humidity 30-90%
12
Page 5
TROUBLESHOOTING
Check the following points before calling your local authorised Service Centre.
PROBLEMS CAUSE SOLUTION
The appliance is operating in dehu­midifying mode, but the humidity does not decrease
The appliance does not work for ap­prox 3 minutes after start-up
The appliance does not work
The lter is blocked
The temperature or humidity in the room is too low
The room is too big for the dehumidi­fying power of the appliance or there are too many sources of humidity (pots of boiling water, etc.)
The humidity set point is too high
The safety device has tripped Wait for 3 minutes to pass and restart
The appliance is not plugged in
There is no current
The appliance is set on low humidity level
Clean the lter
In certain conditions, it is normal for the ap­pliance not to dehumidify . Verify the opera­tion limits of the appliance in the "Technical Specications" section. In certain cases, it is recommended to heat the environment
Decrease the humidity set point
Plug into the mains
Check the power supply
Set the appliance to a greater humidity level
The tank is full of water
The tank is not positioned correctly
13
Empty the tank
Gently place the tank into the correct position
Loading...