DeLonghi CPC206AU, CPC306AU, CPC505AU Operating And Installation Manual

OPERATING AND INSTALLATION MANUAL

SINGLE SPLIT AIR-CONDITIONER
AND HEAT PUMP

Please carefully read this
manual before operating the
appliance.

R410a

eco

INDEX

SINGLE SPLIT

1English 11/2002

Safety standards 2

Identification of the parts 4

Remote control 6

Operating modes 8

AUTO mode 9

TIMER mode 9

DRY mode 10

SLEEP mode 10

Maintenance 11

Troubleshooting 12

Installation instructions 13

Installation of the indoor unit 15

Installation of the outdoor unit 19

Venting the air 19

Note 20

Useful information 20

U AI

U AI

U A

I

U AI

U A

I

U AI

U A

I

U AI

U AI

U A

I

AI

A

I

AI

A

I

U AI

U A

I

U User I Installer A Service

SINGLE SPLIT

2 English 11/2002

Use the power supply voltage shown on the rating
plate. Keep the power switch or plug clean. Connect
the power cable correctly and securely to the out­let, avoiding the risk of electric shock or fire due to
insufficient contact.

Check that the outlet is suitable for the plug, oth­erwise have the outlet replaced. Do not use the
power switch or pull out the plug to switch the
appliance off when operating. This may cause fires
due to sparks,etc.

The user must contact qualified personnel to
earth the appliance, in compliance with the legis­lation in force, and to install a thermal-magnetic
circuit breaker.

Do not bend, pull or press the power cable, as it
may break.Electric shock or fire are usually caused
by damaged power cables.
The power cable must only be replaced by special­ist technicians.

Do not use power supply cables that are too
long,or multiple adapters.

Do not operate the air-conditioner with wet
hands;this may cause electric shock.

Do not modify or alter the characteristics of the
appliance in any wa y.
Contact the Service Centres authorised by the
Manufacturer for all repairs.Incorrect repair may
cause electric shock,etc.

Make sure the appliance is disconnected from
the power supply when not used for extend­ed periods, and before performing any clean­ing or maintenance operations.

Do not install the appliance in environments
where the air may contain gases,oil or sulphur,
or near sources of heat.

Check that the base of the outdoor unit is
installed securely.

This appliance must only be used by adults; do
not allow children to play with the appliance.
Do not climb onto or rest objects on the out­door unit.

Never insert sticks or tools into the appliance.
This may cause injuries.

Do not block the air inlet or outlet of either the
indoor or outdoor unit. Extended exposure to cold air is a health risk.

If smoke or a smell of burning is detected,imme­diately disconnect power and contact the Service
Centre.

SAFETY STANDARDS AND WARNINGS

U I A

SINGLE SPLIT

3English 11/2002

Keep the appliance at least 50cm from flamma­ble substances (alcohol, etc.) or from pres­surised containers (e.g.spray cans).

Selecting the most suitable temperature will avoid
damaging the appliance.

The direction of air flow must be adjusted correct­ly.The louvers must be adjusted downwards in
heating mode,and upwards in cooling mode.

Do not leave doors and windows open when the
air-conditioner is operating f or long periods.

Do not aim the air stream directly at plants or
animals. Do not spray water onto the air-conditioner .

This appliance has been designed to air-condition
the home and must not be used for other pur­poses,such as drying clothes, cooling food,etc.

If the appliance is used in areas without the
renewal of fresh air, precautions must be taken
to prevent any leaks of refrigerant gas from
stagnating in the environment and creating the
risk of fire. Do not rest heavy or hot objects on the appliance.

The packing materials are recyclable.It is therefore
recommended to place them in suitable containers
for separate waste disposal.
At the end of its working life, take the air-condi­tioner to a special waste disposal centre.

Only use the air-conditioner as shown in this
booklet. These instructions are not intended to
cover every possible situation that may arise.
Common sense and prudence must be applied
in the installation,operation and conservation of
all household appliances.

Lowers

the inside
temperature
by 5°C from

the outside

temperature

※ Working temperature range

Maximum cooling

Maximum heating

Minimum cooling

Minimum heating

36

Indoor side DB(℃)

30

16

16

45

Outdoor side DB(℃)

27

18

-10

SINGLE SPLIT

4 English 11/2002

IDENTIFICATION OF THE PARTS

AUTO
TEST
RUN
STOP

AUTO
STOP

1

4

5

11

10

7

9

6

8

12

4

4

14

13

2

3

Air inlet

INDOOR UNIT

OUTDOOR UNIT

The above figure represents a simplified layout of the appliance and may not correspond to the
appearance of the unit actually purchased.

U I A

Air outlet

Air inlet

Air outlet

1Front panel
2 Air filter
3 Electrostatic filter (optional)
4 Manual switch
5 Cable panel
6 Activated carbon filter
7 Louvers
8 Signal receiver
9 LED display
10 Power plug
11 Drain hose
12 Remote control
13 Handle
14 Air outlet grill

4

AUTO

STOP

RUN

TEST

SINGLE SPLIT

5English 11/2002

1

2

3

4

5

AUTO
TEST
RUN
STOP

1. Manual switch

This is used to start the appliance if the remote con­trol is not working.*

2. Heating indicator

This comes on when the appliance is in heating mode.

3. Cooling indicator

This comes on when the appliance is in cooling
mode.

4. Operation indicator

This comes on when the appliance is operating.

5. Signal receiver

Receives the signals from the remote control.

OPERA TION AND DISPLA Y

The shape and the position of the switches and
indicators may change according to the model,
howe v er their functions r emain the same.

Power on when grill open.

*This operation must be carried out by spe­cialist technicians.

REMOTE CONTROL

SINGLE SPLIT

6 English 11/2002

3
4

1

5
6

7

10

2

8

9

1. Liquid crystal display

Displays all the operating modes.

2. MODE button

Used to select the operating mode.

3. FAN button

Used to set the fan speed, in sequence , to automatic,
low,medium,high.

4. SLEEP button

Used to set or cancel SLEEP mode.

5. SWING button

Used to start or stop the movement of the vertical
louvers.

6. TIMER ON button

When the appliance is off, this button is used to
switch the air-conditioner on automatically.

7-8. ROOM TEMPERATURE SETTING buttons

Used to set the room temperature.

9. TIMER OFF button

When the appliance is on, this button is used to
switch the air-conditioner off automatically.

10. button

Used to switch appliance on or off.

Meaning of the symbols shown on the liquid
crystal display:

Automatic fan speed
Low fan speed
Medium fan speed
High fan speed
Cooling indicator
Dehumidification indicator
Fan only operation indicator
Heating indicator
Automatic mode indicator
SLEEP indicator
Louver swing indicator

The display on the remote control remains on even when the unit is off.

The remote control sends signals to the appliance.

U I A