
Dell™ PowerVault™ DL4000 Backup to Disk Appliance
Two (2) hot-swappable 2.5-inch SAS drives
Eight (2) hot-swappable 2.5-inch Nearline SAS drives
Number of Enclosures Supported
Interoperability Guide
This document provides information about the supported hardware and software versions for the Dell
PowerVault™ Backup to Disk Appliance system.
NOTE: The versions specified in this document use the same format as found on dell.com/support/downloads/ and may differ
Supported Hardware
This section lists the hardware supported by PowerVault DL4000 Backup to Disk Appliance systems. Where
applicable, firmware and driver versions are also listed.
BIOS Versions
from the version information displayed in the Windows® Device Manager or Dell™ OpenManage™ Server Administrator.
Hard Drives (Internal)
RAID
RAID Level
Storage Enclosures
NOTE: To connect or disconnect the redundant SAS cable(s), the DL4000 system must be powered off.
Hard Drives (External)
Dell PowerVault Backup to Disk Appliance Interoperability Guide l 1

Broadcom 57800S Quad-Port 1GbE NDC
Intel I350 Quad-Port 1GbE NIC
Microsoft Windows Server 20
Network Interface Controllers (NIC)
00
RAID Controllers
NOTE: Dell does not support upgrading internal RAID controllers. The internal controller shipped with the system is the only
00
supported configuration.
Max Number
of Controllers
0P 1
0 1
Display Resolution
The minimum display resolution is 1280x1024.
-0001
-0001
Supported Software
This section lists the supported operating systems and applications on the PowerVault DL4000 Backup to Disk
Appliance.
NOTE: Running applications other than those listed in this document on the PowerVault DL4000 Backup to Disk Appliance is not
Operating System
00
2 ׀ Dell PowerVault Backup to Disk Appliance Interoperability Guide
supported.
NOTE: Clustering is not supported on the PowerVault DL4000 Backup to Disk Appliance.
System
12 Standard Edition

Dell™ OpenManage™ Server Administrator
Applications
Backup Software
See the following tables for information about the supported versions of backup software. The required version
is determined by the system and installed RAID controller(s).
AppAssure
System RAID Controller 5.3.1
DL4000
PERC H710P, PERC H810
Appliance Software Stack Release
See the following table for information about the supported versions of the appliance software stack. The
required version is determined by the system, the installed RAID controller, and (if applicable) HBA.
System RAID Controller 1.x
Dell PowerVault Backup to Disk Appliance Interoperability Guide l 3

Information in this document is subject to change without notice.
© 2013 Dell Inc. All rights reserved.
Reproduction of these materials in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.
Trademarks used in this text: Dell, PowerVault, OpenManage, and the DELL logo are trademarks of Dell Inc.; Microsoft, Windows, Active
Directory, Virtual Server, Exchange, and Windows Server are either trademarks or registered trademarks of Microsoft Corporation in the
United States and/or other countries.
Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their
products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
2013 - 03 Rev. A00
4 ׀ Dell PowerVault Backup to Disk Appliance Interoperability Guide