
N8700-D
Drop-In Individually Controlled Heated Electric Food Wells
Models
• N8717-D  Individually heated food wells, accommodates one 12” x 20” pan
• N8731-D  Individually heated food wells, accommodates two 12”x 20” pans
• N8745-D  Individually heated food wells, accommodates three 12”x 20” pans
• N8759-D  Individually heated food wells, accommodates four 12”x 20” pans
• N8773-D  Individually heated food wells, accommodates five 12”x 20” pans
• N8787-D  Individually heated food wells, accommodates six 12”x 20” pans
Project __________________________________
Item ____________________________________
Quantity ________________________________
CSI Section 11400
Approved _______________________________
Date ____________________________________
N8700-D Drop-In Individually Controlled Heated Electric Food Wells
N8787-D
Specifications
Top shall be one-piece 18-gauge stainless steel, 
with 0.65" (1.7cm) overhang around perimeter and 
die-stamped 19.87" x 11.87" (50.5cm x 30.2cm) 
openings with depressed edges. Formed well below 
each opening shall be 6.25" (15.9cm) deep. Each 
well shall have an individual temperature control 
and 1000 watt heating element attached to bottom of well. Each well shall be equipped with a 
.5" female N.P.T. drain located in right rear corner. 
All drains manifold to a .5" gate valve at the left. 
Exterior housing shall be 20-gauge gal va nized steel. 
Unit shall be insulated on sides and between wells 
with 1.00" (2.5cm) fiberglass; bottom shall have 
2.00" (5.1cm) blanket insulation.
Standard Features
• Top is constructed of 18-gauge 
stainless steel
• Flush mounted die stamped drawn 12” 
x 20” individual 20-gauge wells
• Wells depressed slightly into the top to 
hold in condensation
• Standard 1/2” stainless steel drain(s)
• Non-marring press fit top gasket
• Must be hard wired in the field
• Wet and dry operation
• 11.87” x 19.87” single hot food wells are 
manifolded together standard to one 
main gate valve
• Unit shall be insulated on all sides with 
1” of fiberglass and bottom to have 2” 
of fiberfrax blanket insulation
• Individual infinite temperature controls 
standard wired to one main control 
panel with 4’ of conduit and wire. Field 
install control panel at location
• Galvanized exterior body
• Available for quick shipment
• One year parts and 90 day labor 
standard warranty
Options & 
Accessories
• Adapter plates and bars
• Single- or double-service flip-up 
sneezeguards
• 220 volt, 50 cycle electrical 
system*
• Telescoping covers
• Omit drains and manifold
* Inclusion of this option will alter 
electrical specifications of the unit
Unit shall have all individual controls wired to 
a control panel for mounting in counter or at a 
remote location; 4' (1.2 m) length of wiring and 
conduit are provided. Unit shall have a three-wire 
electrical junction box to allow hard-wiring at 
installation.
980 S. Isabella Rd. 
Mt. Pleasant, Michigan 48858
Phone: 800-733-8948 or 989-773-7981 
Fax: 800-669-0619
www.delfield.com
 

11.87" 
30cm
A
A –1.30" 
A – 3cm
Remote Control Detail
26"
66cm
24.65" 
63cm
19.87" 
51cm
NOTE: Not To Scale
Plan View
NOTE: Not To Scale
Cutout Dimensions: 
Length varies, see chart below 
Height 4.62” (11.7cm) 
Depth 7.00” (17.8cm)
9.5"
24cm
NOTE: Not To Scale
Elevation View Right End View
6.25"
16cm
6.36”
16cm
* 3” clearance is required between outside body of installed drop-in and combustible materials.
Specifications
Model A 
(Length)
N8717-D 17.88” 
Drop-In Individually Controlled Heated Electric Food Wells
N8731-D 31.75” 
N8745-D 45.63” 
N8759-D 59.5” 
N8773-D 73.38” 
N8787-D 87.25” 
N8700-D
Deleld reserves the right to make changes to the design or specications without prior notice.
980 S. Isabella Rd. 
Mt. Pleasant, Michigan 48858
(45.4cm)
(80.6cm)
(115.9cm)
(151.1cm)
(186.4cm)
(221.4cm)
Counter Cutout 
Dimensions
16.88” X 25” 
(42.8cm x 63.5cm)
30.75” x 25” 
(78.1cm x 63.5cm)
44.62” x 25” 
(113.3cm x 63.5cm)
58.5” x 25” 
(148.6cm x 63.5cm)
72.37” x 25” 
(183.8cm x 63.5cm)
86.25” x 25” 
(219.1cm x 63.5cm)
Phone: 800-733-8948 or 989-773-7981 
Fax: 800-669-0619 
www.delfield.com
Control Panel Cutout 
Dimensions
4.62” x 7” x 7” 
(11.7cm x 17.8cm x 17.8cm)
4.62” x 10.31” x 7” 
(11.7cm x 26.2cm x 17.8cm)
4.62” x 14.5” x 7” 
(11.7cm x 36.8cm x 17.8cm)
4.62” x 18.69” x 7” 
(11.7cm x 47.5cm x 17.8cm)
4.62” x 22.88” x 7” 
(11.7cm x 58.1cm x 17.8cm)
4.62” x 27”x 7” 
(11.7cm x 68.6cm x 17.8cm)
Printed in the U.S.A. 
DS8700 
02/12
# Of Food 
Wells
Volts/Hertz 
/Phase
1 115/60/1 8.3 1000 41lbs 
2 115/60/1 16.6 2000 99lbs 
3 208-230/ 
4 208-230/ 
5 208-230/ 
6 208-230/ 
60/1
60/1
60/1
60/1
Amps Watts Ship 
Weight
15.0/16.0 3000/ 
4000
20.0/22.0 4000/ 
4800
24.0/27.0 5000/ 
6000
29.0/32.0 6000/ 
7200
(107kg)
(19kg)
(45kg)
134lbs 
(61kg)
166lbs 
(75kg)
186lbs 
(84kg)
236lbs