Please read this manual completely before attempting to install or operate this equipment! Notify carrier of damage! Inspect all
components immediately.
Refrigerated Work Tables, Salad Tables & Freezer Bases
Important Information
CAUTION
Read Before Use
Please Save These Instructions!
July 2013
International F18 Series Service and Installation Manual
Important Warning And Safety Information
WARNING Read This Manual Thoroughly Before Operating, Installing, Or Performing Maintenance On The Equipment.
WARNING Failure To Follow Instructions In This Manual Can Cause Property Damage, Injury Or Death.
WARNING Do Not Store Or Use Gasoline Or Other Flammable Vapors Or Liquids In The Vicinity Of This Or Any Other
Appliance.
WARNING Unless All Cover And Access Panels Are In Place And Properly Secured, Do Not Operate This Equipment.
WARNING This Appliance Is Not Intended For Use By Persons Who Lack Experience Or Knowledge, Unless They Have
Been Given Supervision Or Instruction Concerning Use Of The Appliance By A Person Responsible For Their
Safety.
WARNING This Appliance Is Not To Be Played With.
WARNING Do Not Clean With Water Jet.
WARNING Do Not Use Electrical Appliances Inside The Food Storage Compartment Of This Appliance.
CAUTION Observe the following:
•Minimum clearances must be maintained from all walls and combustible materials.
•Keep the equipment area free and clear of combustible material.
•Allow adequate clearance for air openings.
•Operate equipment only on the type of electricity indicated on the specification plate.
Even though most equipment is shipped crated, care should be
taken during unloading so the equipment is not damaged while
being moved into the building.
1. Visually inspect the exterior of the package an skid or
container. Any damage should be noted and reported to
the delivering carrier immediately.
2. If damaged, open and inspect the contents with the carrier.
3. In the event that the exterior is not damaged, yet upon
opening, there is concealed damage to the equipment
notify the carrier. Notification should be made verbally as
well as in written form.
4. Request an inspection of the concealed equipment. This
should be done within 10 days from receipt of the
equipment.
5. Check the lower portion of the unit to be sure legs or
casters are not bent.
6. Also open the compressor compartment housing and
7. Freight carriers can supply the necessary forms upon
8. Retain all crating material until an inspection has been
Uncrating the Equipment
First cut and remove the banding from around the crate.
Remove the front of the crate material, use of some tools will
be required. If the unit is on legs remove the top of the crate as
well and lift the unit off the skid. If the unit is on casters it can
be "rolled" off the skid.
visually inspect the refrigeration package. Be sure lines are
secure and base is still intact.
International F18 Series Service and Installation Manual
Serial Number Location
The serial number on all self-contained F18 Series refrigerated
work tables and freezer bases is located on the electrical
specifications tag affixed inside the compressor section next
to the pressure control.
On remote refrigerated bases with doors, the tag is inside
the unit on the coil side. On remote refrigerated bases with
drawers, the tag is affixed to the drawer divider. On remote
freezer bases, the tag is located on the inside back of the unit.
Always have the serial number of your unit available when
calling for parts or service. A complete list of authorized
Delfield parts depots is available at www.delfield.com.