Page 1
DE102
OPERATING INSTRUCTIONS
PLL AM - FM STEREO RECEIVER
AM / FM STEREO
30 MEMORY PRESETS
BASS / STEREO SELECTABLE
TEMPERATURE INDICATOR
AUTO CUT OFF WITH LOWER POWER
WEEKDAY INDICATOR
BATTERY INDICATOR
STYLISH DESIGN
24H / 12H SELECTABLE
DUAL CLOCK
1 HOUR POWER OFF
MANUAL TUNING / QUICK TUNING / PRESETTING
/ MONO
AUTO
De102
OPERATING OPERATING INSTRUCTIONSINSTRUCTIONS
Page 2
Thank you for purchasing DE102, DEGEN PLL AM /
FM Stereo Receiver! It will give you many hours of
reliable service and listening pleasure.
Before operating the receiver, please read this manual
carefully and retain it for future reference.
INTRODUCTION
CONTENTS
Location of Controls............................................................1
LCD Identification..............................................................2
Battery Operation................................................................3
Reset..................................................................................4
Temperature Indicator.........................................................5
Power / Band.......................................................................5
Tuning in to a Station...........................................................6
Manual Tuning..................................................................6
Quick Tuning....................................................................6
Listening to preset stations................................................7
Using Antenna....................................................................7
Sound Quality Selection......................................................8
Presetting Stations..............................................................9
Clock Set...........................................................................10
Adjust the Clock...............................................................10
12H / 24H.........................................................................10
Weekday..........................................................................11
Dual Clock.......................................................................11
Cautions............................................................................12
Specifications....................................................................
13
DE102
DEGEN
AM-FM STEREO RECEIVER
0
P
R
ES
E
T
S
BA
S
S
.S
T
E
R
EO
.M
O
N
O
1
2
3
4
5
6
7
8
9
10
11
12
13
13
1
2
3
4
5
6
7
8
9
10
11
12
LOCATION OF CONTROLS
Battery Compartment (Back Side)
Reset ( Inside the Battery Compartment)
LCD Display
Power / Band
Carrying Strap
Earphone Jack
Volume
Memory / Week / Temperature
Store / Time
Buckle
Scan / Hour
Scan / Minute
Mono/ Stereo / Bass
1
Page 3
2
WEEKDAY
PM
LOCAL
AM
FM
MHz
KHz
STEREO
TEMPERATURE
1
2
3
4
5
6
7
8
9
88:88
8
1
2
3
4
5
6
7
8
9
Week day Indicator
AM Band / AM
FM Band
PM
Local Time
Battery Indicator
Temperature Indicator
Stereo
Preset Number / Week day
LCD INDENTIFICATION
Slide the battery cover in
the direction of the arrow.
Insert two AAA batteries
according to the marking
inside the
compartment.
Slide back the battery
cover, make sure that it
snap in place.
+
-
+
-
BATTERY OPERATION
Do not mix different types together (Alkaline, CarbonZinc, Nickel Cadmium etc.), or old batteries with new
ones.
When the unit is not being used for a long period of time,
remove the batteries to avoid damage from battery
leakage and corrosion.
If battery leakage occurs, wipe the battery compartment
with a soft cloth before inserting the new ones.
BATTERY INDICATOR
The battery charge is shown at 4 levels in the display.
Full
Empty
3
Page 4
POWER / BAND
When the batteries become weak, battery indicator flashes.
If batteries get too weak for proper operation, the unit
will automatically shut off with special integrated circus.
Replace the batteries immediately to prevent memories
losing after the power automatically turns off.
Turn off the unit and then replace the batteries with fresh ones
within 1 hour.
If the unit operates erratically, reset the unit by press RESET
inside the battery compartment to resume normal operation.
Note that reset will erase all of the memories including clock
setting.
RESET
LOCAL
WEEKDAY
RESET
0:00
1
2
Withdraw the batteries, press
RESET inside the
compartment for above 0.5
second.
2
Install the batteries, clock
flashes and reset to 0:00.
4
Press POWER / BAND to turn on the
unit, the FM station you stoped listen
last operation is heard.
LOCAL
WEEKDAY
18:00
5
FM
MHz
STEREO
89.9
AM
Khz
1071
1. FM
2. AM
Press POWER / BAND in FM mode,
unit turns into AM mode, the AM station
you stoped listen last operation is heard.
3. Clock Mode
Press POWER / BAND in AM mode,
unit turns off into Clock mode, weekday
indicates in the display.
4
4
4
Turn off the unit into Clock Mode if you do not want to listen
to the broadcast. It hardly consumes any power in Clock Mode.
5
TEMPERATURE
8
30
c
Press MEMO when the unit is off,
temperature indicates in the display
for 5s.
TEMPERATURE INDICATOR
Page 5
ÊÖ¶¯ËÑË÷
×Ô¶¯ËÑË÷
TUNING IN TO A STATION
1. Manual Tuning
Press SCAN button(+ /- ) to tune in to a clear
reception.
FM Step: 0.1MHz AM Step: 9KHz
Headphones cord functions as antenna for the unit, plug
the headphone connector into earphone jack before
tuning, or you can not tune in to any stations.
Manual tuning is more suitable for weak signal broadcast.
When the receiving FM Stereo station is strong enough
(and sound quality set to STEREO or BASS), Stereo
indicates in the display.
2. Quick Tuning
Keep SCAN button (+ / - ) pressed until frequency indicator
changes, unit starts to tune in to the stations automatically. When a
station is tuned in, scanning stops and the tuned station is heard.
Methods
11
12
Quick Tuning is more suitable for strong signal broadcast,
it may not stop if broadcast signals are weak.
If tuning become slowly in a frequency range, try manual
tuning to see if there are some weak stations.
If there is a station you wish to skip during scanning, press and
hold SCAN button(+ or- ) to skip this station.
Press SCAN (+ or- ) button while quick tuning, scanning
will stop immediately.
11
12
11
12
11
12
¼ÇÒäµç̨
Press POWER / BAND to select the
desired band.
Press MEMO to tune in to the preset
station of last operation. The frequency
and preset number shows in the display.
3. Listening to Preset Stations
There are 30 memories, 20 assigned to FM with preset number
0...19 and 10 assigned to AM with 0...9. Remember all the preset
station numbers for the convenience of later listening.
(Refer to page 9 for information on presetting stations.)
FM
MHz
STEREO
89.9
FM MHz
STEREO
99.1
5
FM
MHz
STEREO
1 00.4
6
2
Repress MEMO to tune in to the next
preset station.
8
8
7
6
Headphone cord functions as FM antenna,
keep it extended to find the position which
gives the best reception.
USING ANTENNA
FM Reception
DE102
D
EG
EN
AM-FM ST
EREO
RECEIVER
0
P
RE
S
E
T
S
B
A
S
S
.
S
T
E
R
E
O
.
M
O
N
O
Page 6
FM
MHz
STEREO
100.4
FM
MHz
STEREO
100.4
9
FM MHz
STEREO
1 00.4
6
FM
MHz
STEREO
100.4
7
FM 0-19 + AM 0-9 = 30 Presets
You can preset up to 20 stations under the preset number (0-19)
on FM and 10 stations under the preset number (0-9) on AM:
PRESETTING STATIONS
Tune in to a desired station with
manual tuning or quick tuning .
9
Press STORE / TIME into
memory mode, preset number
flashes in the display.
9
Press STORE / TIME to
memorize the station. The
corresponding number will
indicate in the display.
If you do not have any operation in each step for 5s,
memory mode will automatically released and the station
is not preset into the unit.
If a station is already stored, the new station with the
same preset number replaces the old one.
8
8
Press MEMO to select a proper
preset number, preset number
increases cyclically pressing
MEMO .
8
9
SOUND QUALITY SELECTION
MONO: weak signal broadcast, voice program, mono broadcast.
STEREO: strong signal broadcast, music, FM Stereo broadcast.
BASS: strong music broadcast, bass stereo.
Set sound quality selection to different
position according to the receiving broadcast.
MONO/ ST/ BASS
When listening to a stereo broadcast, normally set
MONO/ST/BASS to STEREO.
If you are listening to the stereo music and prefer to a
bass effect, set the switch to BASS.
If the stereo reception is too weak or noisy, or you are
listening to voice program, set the switch to MONO.
Magnetic antenna inside the unit
functions as AM antenna, it is
strongly effected by the reception
direction.
When listening to AM broadcast,
reorient the unit to find the
position which gives the best
reception.
AM Reception
1 Hour Power Auto off
After listening for 1hour, the unit automatically turns off to avoid
power wasting. If you want to continue listening, turn on the unit.
DE
102
D
E
G
E
N
AM
-FM STEREO
RE
CE
IVER
0
P
R
E
S
E
T
S
B
A
S
S
.S
T
E
R
E
O
.
M
O
N
O
DE102
DEGEN
AM-FM STEREO RECEIVER
0
PRESETS
BASS.STEREO.MONO
13
13
Page 7
10
11
Make sure to press STORE / TIME after clock setting,
otherwise setting is failed.
In step 2, hour or minute will step up continuously if you
press and hold + or - until you release the button.
LOCAL
WEEKDAY
18:00
5
LOCAL
WEEKDAY
19:01
5
Press + to cyclically increase the hour
and - to cyclically increase the minute.
11
12
Press and hold STORE / TIME for 2s
into Clock Set mode when unit is off, ":"
in the clock indicator stops flashing.
9
Press STORE / TIME to store the clock
setting.
9
9
1. Adjust the Clock
11
12
CLOCK SET
11
LOCAL
WEEKDAY
18:00
5
2:00
6
WEEKDAY
Cl2
12
You can preset dual clock - CL1(local) and CL2 in the unit with
independent clock and weekday.
When the unit is off, press
+ and - together for
above 2s.
Clock number indicates in the
display for a short time and then
new clock shows in the display.
4. DUAL CLOCK
Repeat the same procedure to change the clock to CL1(Local).
12
11
LOCAL
WEEKDAY
18:00
5
LOCAL
WEEKDAY
18:00
6
3. WEEKDAY
When the unit is off, press MEMO
for above 2s until WEEKDAY
flashes in the display.
Press + to change the weekday
upward or - to downward.
Press MEMO to store the setting.
8
8
Make sure to press MEMO after weekday setting,
otherwise setting is failed.
8
2. 12H / 24H
LOCAL
WEEKDAY
MEMO
WEEKDAY
PM
LOCAL
11
8
18:00
5
12H
6:00
5
Press and hold MEMO and
+ together for above 2s
when the unit is off.
Clock mode indicates in the
display for a short time and
then clock with the new mode
shows in the display.
Page 8
Avoid using earphones at high volume, if you experience a
ringing in your ears, reduce volume or discontinue use.
Shut down the radio before sleeping.
Do not use earphones while driving or cycling, it can also be
potentially dangerous to play your earphones at high volume
while walking, especially at pedestrian crossing.
Notes On Headphones
CAUTIONS
On Handling
Avoid exposure to temperature extremes, direct sunlight, moisture,
sand, dust or mechanical shock.
Should anything wrong with the radio, please remove the battery
and have the unit checked by qualified personnel before operating
it any further.
When the unit is not being used for a long period of time, remove
the batteries to avoid damage form battery leakage and corrosion.
The LCD display may become hard to see or slow down when
using the unit at high temperatures (above 40 C) or at low
temperatures (below 0 C). At room temperature, the display will
return to its normal operating condition.
The product may not operate normally, when the ESD (8kv) applied
on the metal coated buttons. It is necessary to reset manually.
SPECIFICATIONS
12
13
FM 87.0 - 108.0 MHz
MW 531 - 1602 KHz
1. Frequency Range
3. Memory Stations (30)
2. Noise Limit Sensitivity
FM 10 V
MW 1.5mv/m
FM 20 (0 - 19)
MW 10 (0 - 9)
5. Power Supply: 2 AAA Batteries
6. External Earphone: D 3.5mm
7. Dimensions: Approx. 45 83 19 mm
8. Mass: Approx. 45 g (excl. Battery)
4. Bass Boost (100Hz) 9dB
Loading...