Dee Zee DZ372531HD User Manual
3" SIDEBARS BODY BOLT MOUNT
(W)
INSTALLATION INSTRUCTIONS
SIDE BAR
CHEVY SILVERADO/GMC SIERRA 1500 CREW CAB 2014
PART #DZ 372531/DZ 372533
CHEVY SILVERADO/GMC SIERRA 1500 CREW CAB 2014
Page 1 of 4 8-5-13 (DP)
3" SIDEBARS BODY BOLT MOUNT
Qty
Description
Qty
Description
1
Driver/Left Sidebar
4
1/2” x 2” Hex Bolts
1
Passenger/Right Sidebar
4
1/2” Lock Washers
1
Driver/Left Front Mounting Bracket
4
1/2” x 1-1/2" OD x 1/8" Flat Washers
1
Passenger/Right Front Mounting Bracket
2
8-1.25mm x 25mm Hex Bolts
2
Center Brackets (left or right)
2
8mm Lock Washers
1
Driver/Left Rear Mounting Bracket
2
8mm x 24mm x 2mm Flat Washers
1
Passenger/Right Rear Mounting Bracket
Driver/Left rear
Mounting Bracket
Driver/Left front
Mounting Bracket
(2) Center Mounting
Brackets
Passenger/Right front
Mounting Bracket
Passenger/Right rear
Mounting Bracket
Front
Driver/Left Sidebar
Passenger/Right Sidebar
CHEVY SILVERADO/GMC SIERRA 1500 CREW CAB 2014
PARTS LIST:
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTALLATION
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS
RECOMMENDED.
1. Start installation on the front, driver side of the vehicle. Remove the front body mount bolt, (Figure 1).
2. Select the driver side front Mounting Bracket. Insert the factory body mount bolt through the Mounting
Bracket, factory washer and up into the mount. Snug but do not fully tighten the body bolt at this time,
(Figure 2). VERY IMPORTANT! To prevent unnecessary noise, adjust the position of all
Mounting Brackets so that once tightened, the Mounting Brackets cannot come in contact with
the factory steel body mount bracket.
3. Repeat Step 2 for Center Mounting Bracket installation, (Figures 3 & 4).
4. Move toward the rear of the vehicle. Remove the factory body mount bolt as described in Step 1.
Select the driver side Rear Mounting Bracket, (Figure 5). Bolt the rear Mounting Bracket in place as
described in Step 2.
5. With assistance, position the Sidebar up to the front and rear Mounting Brackets. Attach the Sidebar to
the Brackets with the included (2) 1/2” x 2” Hex Bolts, (2) 1/2” Flat Washers and (2) 1/2” Lock Washers,
(Figures 6 & 7). Do not tighten hardware at this time.
6. Attach the center Mounting Bracket to the Sidebar with the included (1) 8mm x 25mm Hex Bolt, (1)
8mm Lock Washer and (1) 8mm Flat Washer, (Figure 8). Do not tighten hardware at this time.
7. Level and adjust the Sidebar, tighten all hardware and check all mounting locations for clearance
between factory steel body mount brackets and Mounting Brackets. Once satisfied with fit, tighten all
hardware.
8. Repeat Steps 1 - 7 for passenger Sidebar installation.
9. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Page 2 of 4 8-5-13 (DP)
Loading...