Dee Zee DZ372299 User Manual

INSTALLATION INSTRUCTIONS
3"/4" BENT END SIDEBARS
09-12 FORD F-150 REGULAR AND SUPERCAB
Regular Cab complete installation
3"/4" BENT END SIDEBARS
09-11 FO R D F-150 REGULAR AND SUPERCAB
Page 1 of 5 11/19/08 (DP)
PARTS LIST:
1
Driver/Left Sidebar
4
1/2” Lock Washers
1
Passenger/Right Sidebar
4
12mm x 32mm OD x 3mm Flat Washers
1
Driver/Left Front Mounting Bracket
4
12mm Lock Washers
1
Passenger/Right Front Mounting Bracket
4
12mm Hex Nuts
2
Support Brackets
4
10-1.50mm x 30mm Hex Bolts
1
Driver/Left Top Mounting Bracket
4
10-1.50mm x 35mm Hex Bolts
1
Passenger/Right Top Mounting Bracket
6
10mm x 30mm OD x 2.5mm Flat Washers
1
Driver/Left Rear Mounting Bracket
8
10mm x 20mm OD x 2mm Flat Washers
1
Passenger/Right Rear Mounting Bracket
8
10mm Lock Washers
2
12mm x 40mm x 10mm Nut and Bolt Plate
6
10mm Hex Nuts
2
12mm x 40mm Bolt Plates
4
8-1.25mm x 30mm Hex Bolts
4
12mm Plastic Retainers
4
8mm x 24mm OD x 2mm Flat Washers (Outer)
2
10mm Plastic Retainers
4
8mm x 16mm OD x 1.6mm Flat Washers (Inner)
4
1/2" x 2” Hex Bolts
4
8mm Lock Washers
4
1/2” x 1-1/4” OD x 3/32” Flat Washers
4
8mm Hex Nuts
PROCEDURE:
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. DRILLING MA Y B E REQUIRED. ASSISTANCE RECOMMENDED.
2. Starting at the front of the driver side of the vehicle, remove the two small hex bolts and the
metal clips holding the bottom of the fender to the body, (Figure 1A). NOTE: Use a small flat screwdriver to spread the clip apart for easy removal. Due to body panel misalignment from the factory, it may be necessary to open these holes slightly with a 3/8" drill bit, (Figure 1B).
Passenger/Right Front Mounting Bracket
Passenger/Right Rear Mounting Bracket
12mm x 40mm x 10mm Nut and Bolt Plate
12mm x 40mm Bolt Plate
Passenger/Right Top Bracket
Drive/Left Top Bracket
(2) Front Support Straps
Driver/Left Rear Mounting Bracket
Driver/Left Front Mounting Bracket
Passenger Sidebar illustrated
Front
Loading...
+ 4 hidden pages