Deep SEA Electronics DSE892 User Manual

DEEP SEA ELECTRO NI CS

053-148

DSE8 9 2 S NMP GAT EWAY
INS T AL L ATION INS T R U CT I ONS

The DSE892 SNMP Gateway® communicates with the connected controller(s) monitoring the
instrumentation and operating state. If the data changes, this can be used to generate SNMP
TRAP messages for receipt by a third party SNMP manager and / or email to one or two
addresses.

®

ISSUE 1

SETUP

You may wish to consult your company IT
department before making changes to your PC
network settings.

Connect the DSEGateway® ethernet port directly
to your PC Ethernet port.
You can use either a ‘straight through’ or
‘crossover’ network cable.

Set the PC IP address as shown.

Using Google Chrome, Microsoft Internet
Explorer or Mozilla Firefox, enter the IP address
of the gateway.

Enter the username and password of the
Gateway.

NOTE:- Username and Password are

both CASE SENSITIVE.

For further details refer to the following DSE
publications available from our website :
www.deepseaplc.com

057-179 DSE892 SNMP Gateway Operator Manual

Factory Settings

IP Address Username Password

192.168.1.100 Admin Password1234

Deep Sea Electronics Plc.

Tel:[phone]

Fax: [phone]

Email: [e-mail]

Web: www.deepseaplc.com

Deep Sea Electronics Inc.

Tel: [phone]

Fax: [phone]

TOLL FREE (USA only) :

Telephone: [phone]

Email: [e-mail]

Web: www.deepseausa.com

LED STATUS

TO MEET UL APPROVALS,

PLEASE USE A

U

L LISTED LIMITED

DIMENSIONS

TYPICAL WIRING DIAGRAM

Overall size 85 mm x 149 mm x 51 mm
Mounting type DIN rail or chassis mounting
Din rail type EN 50022 35mm type only

Mounting holes M4 clearance
Mounting hole
centres
Maximum Ambient
Operating
Temperature

(3.35” x 5.85” x 2.01”)
Indoor Use Only

73 mm x 137 mm
(2.89” x 5.39”)
50ºC
(122ºF)

POWER SUPPLY (8V DC -36V DC)