Deep SEA Electronics DSE2130 User Manual

053-033
ISSUE 2

DEEP S E A E L E C T R O NI C S

2130 Input Expansion Installation Instructions

Introduction

DSE2130 input expansion module is used in conjunction with supported DSE controllers to provide
additional input functionality (4 x analogue inputs and 4 x digital inputs). The inputs are configured in
the ‘host controller’, the DSE2130 module is not itself configured apart from the ‘ID switch’ detailed
below.
For further details on configuring the ‘host controller’ you are referred to the relevant configuration
software manual.

Controls and indications

ID Switch

Power on /
Link lost LED

LED Indications

Function Colour Action

Power on / Link lost RED Steady when DC supply is connected and data is being received

from the host controller.
Flashing when the DC supply is connected and the data
connection to the host controller is not operating.

ID switch

The rotary ID switch is used to select the ‘Identification’ of the 2130 expansion module as the host
controller is capable of giving instructions to a number of 2130 expansion modules at the same time
(consult relevant modules instructions for further details on number of supported expansion units).

The enclosure cover must be unclipped and removed to gain access to the switch. The switch should
be operated using a small screwdriver and set to match the required address.

NOTE : The ID must be set to be a unique number, different from the ID of any other 2130 input
expansion module connected on the DSEnet.

NOTE : The selection of the ID of other types of expansion modules WILL NOT interfere/clash
with the ID of the 2548. For instance if the 2548 is set to ID 4, it is acceptable to have a different
type of expansion module (for instance 2130) set to ID 4 also.

Typical wiring diagrams

Web:

www.deepseaplc.com

Dimensions

NOTE : Configuration of the inputs is performed in the host controller. For details of
connection to the analogue inputs when configured as ‘digital’, refer to the operator manual.

Overall size 133.9mm x 76.4mm x 48.9mm (5.27” x 3.01” x 1.93”)
Mounting type DIN rail or chassis mounting
Din rail type EN 50022 35mm type only
Mounting holes M4 clearance
Mounting hole centres 122.5mm x 64.5mm (4.82” x 2.54”)

Deep Sea Electronics Plc.

LO CALL (from UK BT landlines) :

Telephone [phone]

Email: [e-mail]

Tel:[phone]

Fax: [phone]

Deep Sea Electronics Inc.

Phone: [phone]

Fax: [phone]

TOLL FREE (USA only) : Tel: [phone]

Email: [e-mail]

Web: www.deepseausa.com

Deep Sea Electronics Plc.

(Far East)

Tel:[phone]

Fax: [phone]

Email: [e-mail]

Web: www.deepseaplc.com