Page 1
Features
Single-in-Line Package (SIP)
Fully SMD-design
Isolated Single and Dual Output
I/O-Isolation 1‘000 VDC
High Efficiency up to 83 %
Pin-compatible with other Manufacturers
100% Burn-in (8 h)
2 Year Product Warranty
DC/DC Conver ter
TMH Series 2 Watt
The TMV series are ultra miniature, isolated 2 W DC/DC-converters
in a Single-in-Line package (SIP). Requiring only 1.5 cm2 board
space they offer the ideal solution in many space critical applications
for board level power distribution. The use of SMD-technology makes
it possible to offer a product with high performance at low cost.
Models
Ordercode Input voltage Output voltage Output current max. Efficiency typ.
TMH 0505S 5 VDC 400 mA 76 %
TMH 0512S 12 VDC 165 mA 80 %
TMH 0515S
TMH 0505D ± 5 VDC ±200 mA 77 %
TMH 0512D ±12 VDC ± 80 mA 79 %
TMH 0515D ±15 VDC ± 65 mA 79 %
TMH 1205S 5 VDC 400 mA 78 %
TMH 1212S 12 VDC 165 mA 82 %
TMH 1215S
TMH 1205D ± 5 VDC ±200 mA 79 %
TMH 1212D ±12 VDC ± 80 mA 82 %
TMH 1215D ±15 VDC ± 65 mA 82 %
TMH 2405S 5 VDC 400 mA 77 %
TMH 2412S 12 VDC 165 mA 81 %
TMH 2415S
TMH 2405D ± 5 VDC ±200 mA 79 %
TMH 2412D ±12 VDC ± 80 mA 81 %
TMH 2415D ±15 VDC ± 65 mA 82 %
5 VDC ±10%
12 VDC ±10%
24 VDC ±10%
15 VDC 130mA 80 %
15 VDC 130mA 83 %
15 VDC 130mA 82 %
www.tracopower.com Page 1
Page 2
DC/DC Conver ter
TMH Series 2 Watt
Input Specifications
Input current no load /full load 5 Vin models 50 mA / 510 mA typ.
12 Vin models 20 mA / 200 mA typ.
24 Vin models 10 mA / 100 mA typ.
Surge voltage (1 sec. max.) 5 Vin models 9 V max.
12 Vin models 18 V max.
24 Vin models 30 V max.
Reverse voltage protection 0.3 A max.
Reflected input ripple current can be reduced by ext. 1–3.3 µF polyester film
capacitor
Input filter internal capacitors
Output Specifications
V oltage set accuracy ± 3 %
V oltage balance (dual output models) ± 1 % max.
Regulation – Input variation ± 1.2 % / 1 % change Vin
– Load variation 20 – 100 % ± 10 % max.
Ripple and noise (20 MHz Bandwidth) 5 Vin models 75 mV pk-pk max.
12 /24 Vin models 150 mV pk-pk max
Temperature coefficient ± 0.02 % / °C
Short circuit protection limited 1 sec. max.
Capacitive load – Single output models 470 µF max.
– Dual output models 390 µF max.
General Specifications
T emperature ranges – Operating –40 °C ... +75 °C
– Case temperature +95 °C max.
– Storage –40 °C ... +105 °C
Humidity (non condensing) 95 % rel H max.
Reliability, calculated MTBF (MIL-HDBK-217E) >2’000’000 h @ 25 °C
Isolation voltage Input/Output 1‘000 VDC
Isolation capacity Input/Output 80 pF typ.
Isolation resistance Input/Output >1‘000 Mohm
Switching frequency 80 kHz typ. (Frequency modulation)
Frequency change over line and load ± 30 % max.
All specifications valid at nominal input voltage, full load and +25°C after warm-up time unless otherwise stated.
www.tracopower.com Page 2
Page 3
DC/DC Conver ter
TMH Series 2 Watt
Physical Specifications
Case material non conductive black plastic
(flammability to UL 94-V0)
Package weight 2.7 g (0.1 oz)
Soldering temperature max. 260°C / 10 sec
Outline Dimensions mm (inches)
0.5
(0.02)
2.3
2.54
±
0.5
(0.09
±0.02
)
5.08
(0.1)
1 2 54 6
Tolerances ±0.25 (0.01)
pins ±0.05 (0.002)
2.54
19.5
(0.77)
(0.1)
(0.2)
Bottom view
0.5
(0.02)
2.54
(0.1)
(0.13)
3.2
0.5
(0.02)
0.5
(0.02)
(0.01)
0.25
(0.4)
10.2
(0.05)
1.25
(0.3)
7.5
Pin-Out
Pin Single Dual
1 +Vin (Vcc) +Vin (Vcc)
2 –Vin (GND) –Vin (GND)
4 –Vout –Vout
5 No pin Common
6 +Vout +Vout
Specifications can be changed without notice
Jenatschstrasse 1 • CH-8002 Zurich • Switzerland
Tel. +41-1284 2911 • Fax +41-1201 1168 • e-mail: sales@traco.ch • internet: http://www.tracopower.com
Rev. 06/00
Page 3
Loading...