Danfoss TP6000M, TP6000MA Installation guide

Installation and Setting Instructions
+
or
-
TP6000M & TP6000MA Electronic Programmable Thermostats
Specication
Power supply: 230 volt powered models -
210-250 Vac, 50/60Hz
Temperature range: Off-5-30°C
Temperature accuracy: ± 0.5°C
Current rating of contacts: 10mA - 3A resistive, 1A inductive
Switching action: Voltage free SPDT contacts,
Type 1B
Time accuracy: ± 1 minute
Memory retention: 15 days
IP rating: IP30
Dimensions (mm): 130 x 100 x 38 (W x H x D)
Control pollution situation: Degree 2
Rated impulse voltage: 2.5 KV
Ball pressure test: 75°C
Applications
Ordering Details
Type Code No. Description
TP6000M 087N728600 5/2 day programmable room thermostat
with built-in sensor
TP6000MA 087N728700 5/2day programmable room thermotat
with remote sensor
1
2
Installation
1. Thermostat Location 2. Unpacking the Thermostat
3. Separating the Wallplate
4. Fitting the Thermostat to the Wall
5. Wiring Access - Incorrect
6. Wiring Access - Correct 7. Cable Size
Max cable size
1.5mm
2
Wiring Connections DIL Switch Settings (see rear of circuit board)
Fitting the Thermostat to the Wallplate
ON/OFF
4 EVENTS
EACH DAY *
CHRONO­PROPORTIONAL
2 EVENTS EACH DAY
Ensure unit is rmly in place
3
Danfoss can accept no responsibilty for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also
applies to products already on order provided that such alterations can be made without subsequent changes being necessary in specications already agreed.
Danfoss Randall Limited
Ampthill Road, Bedford, MK42 9ER Tel: (01234) 364621 Fax: (01234 219705 Email: danfossrandall@danfoss.com Website: www.danfoss-randall.co.uk
4
Part No: 33075v04 10/07
Loading...