Danfoss TP4000 Data sheet

Datasheet
TP4000 Range Programmable Room Thermostats
Features
The TP4000 programmable thermostat combines the functions of a timeswitch and a thermostat into a stylish, easy to use controller that allows the user to programme up to 6 time and temperature events each day. This exibility allows the operation of the heating system to match the lifestyle of the user, providing dierent temperatures at dierent times of the day. Being battery powered and available in hard wired or wireless versions the TP4000 is easy to install and operate.
Programming is achieved using just ve buttons which during normal operation can also be used to override the programme or to change the display.
The TP4000 is a 24 hour unit which repeats the programmed events each day of the week. The product is battery powered and is designed for use in hard­wired installations.
During normal operation, the programmed temperature can easily be overridden to temporarily increase or decrease the room temperature, in this mode the thermostat reverts to normal programmed operation at the next event time. The thermostat can also be set by the user to control the temperature at a constant value. There is also a convenient programmable frost setting which allows the user to easily step out of programmed operation mode into frost protection mode.
• 24 hour programmable thermostat
• For use in hard-wired or wireless systems
• Up to 6 time and temperature events each day
• Battery powered for ease of installation
• Many user overrides, including thermostat and frost protection mode.
The product is delivered with a set of factory pre-set programmes that meet most user requirements, these can be easily modied or reprogrammed to suit the specic demands of a user.
© Danfoss HS | 09/2015 | 050v04 VDRMB402
1
Datasheet
Load
ErP
4
Thermostat Specications
TP4000 Range of Programmable Room Thermostat
Features TP4000 TP4000-RF + RX1 TP4000-RF
Order Code 087N791900 087N792100 087N792000
Hard-wired, with built in sensor
Wireless, with built in sensor
Wireless, with built in sensor + RX1 receiver
24 hour programmable thermostat
6 time and temperature events repeated each day
Factory pre-set times and temperatures (can be changed to suit user demands)
Temperature Range O, 5°C to 30°C
Programmable frost protection function Yes
Control type Chrono-proportional
Switching dierential ±1°C
Power Supply 2 x AA/MN1500/LR6 Alkaline batteries
Transmission frequency (RF Models) N/A 433.92MHz
Transmission range N/A 30 Metres Max
Memory Back-up Events retained for life of product.
Switching action of output relay SPDT (voltage free) N/A
Switch rating of output relay 3(1)A, 10-230V N/A
Dimensions, mm 110 wide x 88 high x 28 deep
Design standard EN 60730-2-9 (EN 300220 for RF)
Setting Time Temperature
1 2 3 4 5 6
Time retained for 1 minute whilst changing batteries
06:30 08:30 11:30 13:30 16:30 22:30
20°C 15°C 20°C 15°C 21°C 15°C
ErP Class
Wiring
Product
Class
Table stand for TP4000RF Code No 087N710700
ERP Class
The products represented within this document are classied according to, and allow completion of, the Energy Related Product (ErP) Directive System Package che and the ErP system data label. ErP Labelling obligation is applicable from 26th September
2015.
ErP Class Product Function and ErP Description Additional eciency gain
TPI Room Thermostat, for use with on/off output heaters
IV
Hard Wired Models Wireless Models
1 2 3
NC
OFF
COM
NO
An electronic room thermostat that controls both thermostat cycle rate and in-cycle on/o ratio of the heater proportional to room temperature. TPI control strategy reduces mean water temperature, improves room temperature control accuracy and enhances system eciency.
RX1
ELECTRONICS
N L
ON
1 2
COM
3
ZONE
1 ON
2%
4
ZONE 1 OFF
Heating
RX2 and RX3
ELECTRONICS
Danfoss Ltd.
Ampthill Road Bedford MK42 9ER Tel: 01234 364621 Fax: 01234 219705 Email: ukheating@danfoss.com
A
B
N
C 1
L
2
COM
3 4 5
ZONE
ZONE
1 OFF
1 ON
ZONE
2 ON
Website: www.heating.danfoss.co.uk
Danfoss can accept no responsibility for possible errors in catalogues, brochures, and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products already on order provided that such alterations can be made without subsequent changes being necessary in specifications already agreed. All trademarks in this material are property of the respective companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
2
© Danfoss HS | 09/2015 | 050v04 VDRMB402
TERMINAL 6 RX3 ONLY
6
ZONE
3 ON
Loading...