Danfoss SE, SES, SEK-LK, REAK, SE-RG Installation guide

NEODUL® Thermal insulation for drinking water storage tanks & heaters
Series: SE, SES, SEK-LK, REAK, SE-RG (up to 4000l volume)
Assembly:
1 2
VI.JV.E2.02 © Danfoss 04/2018
1
NEODUL® Thermal insulation for drinking water storage tanks & heaters
Series: SE, SES, SEK-LK, REAK, SE-RG (up to 4000l volume)
3 4
5 6
7
• Assembly stand-ring and lower ring insulation before placing the tank on site (1)
• Pre-bend insulation (shell parts) before starting assembly (2)
• place enclosed fleece-ring on the connections (pipes)
• Assembly insulation (2)
• Hook closure bar should be in the last section (3+4)
• Put cover insulation on top (5)
• Place enclosed rosettes from outside into the recesses of shell part(s) for connections (pipes) (6)
2
VI.JV.E2.02 © Danfoss 04/2018
NEODUL® Thermal insulation for drinking water storage tanks & heaters
Series: SE, SES, SEK-LK, REAK, SE-RG (up to 4000l volume)
Removal (Deassembly) of Neodul-insulation:
1. remove cover part
2. remove top insulation
3. remove all the accessories (caps, rosettes etc.)
4. by tapping/pressing the shell-jacket in the direction of the hook strip it is now possible to loosen the tension of the closed insulation
5. loosen the profile edge by compression the hook strip with both hands
6. open hook strip completely from t the top to the bottom
VI.JV.E2.02 © Danfoss 04/2018
3
NEODUL® Thermal insulation for drinking water storage tanks & heaters
4
VI.JV.E2.02
Produce d by Danfoss A/S © 04/ 2018
Loading...