Danfoss RAE Installation guide

Danfoss Radiator Thermostat RAE

Installation Guide

Fitting the snap-lock sensor

1. Prise the green protec­tive cap off the valve.

2.Offer sensor onto valve
ensuring that scale
pointer is at top.

Removing the snap-lock sensor

2. Turn sensor to max.

1. prise out
antitheft lock
with Danfoss
tool or a small
screwdriver.

setting.

3.Press the sensor firmly
onto valve until snap­lock "clicks"

3. Hold outer ring whilst
turning inner ring anti­clockwise to release
snap-lock mechanism.
The sensor can now be
separated from the
valve.

4. If required firmly press
anti-theft lock into inner
ring to prevent unauthor­ised removal

Resetting the snap-lock

4. Having removed sensor
from valve, ensure sen­sor is set to max.

5. Hold outer ring whilst
turning arrow mark on
inner ring towards scale
pointer until stop.

Adjusting temperature control range

T I II III IIII I

8 12162024 28°C

Setting the upper limit:

e.g. III as the highest pos­sible temperature selec­tion:

1. Turn the head to max.
position

2. Keep the limiter tab to
the right of the black
scale pointer pressed
down with a small
screwdriver.

3. Turn the head round to
III and release the tab.

2 3 2 3

 I II III IIII I

8 12162024 28°C

Setting the lower limit:

e.g. II as the lowest possi­ble temperature selection:

1. Turn the head to min.
position.

2. Keep the limiter tab to
the left of the black scale
pointer pressed down
with a small screwdriver.

3. Turn the head to II. You

can now release the tab.