Danfoss EKC Installation guide

Instructions

EKC front panel mounting kit

Code No.

027R9790

Fits to Danfoss EKC controlles

Enclosure rating: IP 67 (∼ NEMA 6)

027F0309

027R9790

Assembled view of metal mounting parts from inside electrical box.

Metal mounting parts

Remove plastic tabs in the front panel.

Two screws

Metal mounting parts

Front panel

Remove 8 tabs to
t a EKC controller

Front view after
plastic tabs removed

© Danfoss A/S (AC-AKC / frz), 11-2007 DKRCI.PI.FO0.A1.02 / 520H2518 1

Cutting of rectangular hole in the electrical box.

Making of holes to drill in the electrical box and nal assembly.

Front panel

Four holes

Metal mounting parts

EKC

DIN Rail

Thread cutting screws

Install the front panel from outside of the electrical box.

Install the metal mounting parts on top of the front
panel from inside of the electrical box.

Mark the four 4,5 mm (11/64 in.) holes

Assemble front panel and metal mounting parts with the
4 pcs of thread cutting screws.

Please observe that EKC can be installed by removing the
2 screws that holds the DIN rail.

2 DKRCI.PI.FO0.A1.02 / 520H2518 © Danfoss A/S (AC-AKC / frz), 11-2007