Danfoss EKA 166 Data sheet

Data Sheet

Display

Accessory

Type EKA 166
For AK-PC 7xx controllers

Application:

This display can be used with AK-PC 710/AK-PC
781 compressor controllers.

Features:

The LEDs on the panel correspond to the
connected compressors and condensers.
There are LEDs for the following functions:

• Compressors

• Fans

• Speed control

• Optimisation

• Alarm

• Load limitation

• Heat recovery

• Injection is active

If a compressor is stopped because of a safety
cutout the corresponding LED will ash.

The optimisation LED will light up when the
regulation reference is 2 K or above the set
point.

AI000086415223en-000201

Features

Description

Power supply

From controller

Display operation

Display accuracy in measuring range: 0.1%
LED, three digits, control buttons

Electrical connection

Connector

Ambient conditions

-10 – 55 °C (operating)

-40 – 70 °C (transport)

20 – 80% RH, non condensing

No shock load or vibration

Mounting

Front panel

Enclosure

IP 65

Display, Accessory

Functions

The display shows P0 or Pc and the control loop status relative to the neutral zone.
During normal operation the light-emitting diodes in the display will indicate where regulation is taking place:

• Highest + second highest: ++Zone

• Second highest: Zone

• None: Neutral zone

• Second lowest: –Zone

• Lowest + second lowest: – – Zone

When the display shows the evaporation pressure the condensation pressure can be shown briey by pressing the
lowermost key.

Product specication

Technical data

Table 1: Technical data

© Danfoss | Climate Solutions | 2021.03 AI000086415223en-000201 | 2