Danfoss DML, DMLE, DCL, DCLE Installation guide

Installation guide

Danfoss

23Z7016.10

ELIMINATOR® Hermetic ﬁlter drier Type DML / DMLE / DCL / DCLE

Refrigerants:

A1: R134a, R404A, R407C, R507, R22, R410A. A2L: R32, R444B, R452B, R454B, R1234yf.

023R9514

A3: R290, R600a. For other refrigerants, please contact Danfoss representative.

Connector type Filter size (cu.in) Connector size (DML/DCL) PS / MWP

Solder pure copper DML/DCL : 1.5, 03, 05, 08,16, 30, 38, 60.

Solder Cu-plated

Flare, Flare O-ring and Face seal

DMLE/D CLE: 1.5, 03, 05, 08,16, 30, 60

DML/DMLE/DCL /DCLE: 41 cu.in

DML/DMLE/DCL /DCLE: 75 cu.in

DML/D MLE/DCL/D CLE: 3 to 60 cu.in

DML/DMLE/DCL /DCLE: 75 cu.in

DML/D CL: 3 to 60 cu.in DMLE/D CLE: 05, 08 cu.in

DML/D CL: 1/4"" - 1 1/8 "" ODM / OD F DMLE/D CLE: 1/4"" - 1 1/8 "" ODF"

DML/D CL: 1/2 - 5/8"" ODF DMLE/D CLE: 1/2 - 1 1/8"" ODF

DML/D CL: 3/4" - 1 1/8" ODM / ODF

DML/D CL: 3/4"" - 1 1/8"" ODM / ODF DMLE/D CLE: 7/8"" - 1 1/8"" ODF

DML/D CL: 1/4"" - 1 1/8"" ODM / O DF DMLE/D CLE: 1/4"" - 1 1/8"" ODF

DML/D CL: 7/8"" - 1 1/8"" ODF DMLE/D CLE: 7/8"" - 1 1/8"" ODF

DML/D CL: 1/4" - 3/4" DMLE/D CLE: 1/4" ; 3/8"

Temperature range:

: -40 °C / -40 °F

min

: 70 °C / 160 °F

max

DML/D CL (A1 refrige rants) : 46 bar (667 psig) DMLE/D CLE (A2L refrige rants) : 50 bar (725 psig)

DML/D CL (A1 refrige rants) : 35 bar (500 psig) DMLE/D CLE (A2L refrige rants) : 50 bar (725 psig)

DML/D CL (A1 refrige rants) : 46 bar (667 psig) DMLE/D CLE (A2L refrige rants) : 50 bar (725 psig)

023R9514

Solder connectors (cu-plated / pure copper) with a diameter below 25 mm are approved for A3 refrigerants. Connection sizes below 25mm are approved for A2L. Filter size of 75 cu.in shall not be used with A3 refrigerants.