Danfoss DLE4CN Data sheet

Datasheets

DLE4CN

Energy-optimized LBP/MBP Compressor

R290, 115-127V 60Hz

General

Code number (pre-assembled CSIR start equipment) 102H3483 Approvals UL984 Compressors on pallet 80

Application

Application LBP/MBP Frequency Hz 50 60 Evaporating temperature °F – -31 to 45 Voltage range V – 95 - 135 Max. condensing temperature continuous (short) °F – 131 (149) Max. winding temperature continuous (short) °F – 257 (275)

Cooling requirements

Frequency Hz 50 60 Application 90°F – – – S S – 100°F – – – S S – 110°F – – – F

Remarks on application: For evaporation temperatures higher than 32 °F do not run compressor at condensing temperatures higher 122 °F in steady state operation.

Motor

Motor type CSIR LRA (rated after 4 sec. UL984), HST | LST A 16.7 12.4 Cut in Current, HST | LST A 16.7 20.2 Resistance, main | start winding (77°F) Ω 3.7 6.0

LBP MBP HBP LBP MBP HBP

2F2

This product is approved for R290 regarding explosion safety according to standard EN 60335-1 and EN 60335-2-34

S = Static cooling normally sufcient

–

O = Oil cooling F

= Fan cooling 1.5 m/s

(compressor compartment temperature equal to ambient temperature) F2 = Fan cooling 3.0 m/s necessary

SG = Suction gas cooling normally sufcent

– = not applicable in this area

Design

Displacement cu.in 0.24 Oil quantity (type) .oz. 7.8 (polyolester) Maximum refrigerant charge oz. 5.3 Free gas volume in compressor .oz. 49.5 Weight without electrical equipment lbs. 17.6

Dimensions

Height inch

Suction connector location, I.D. in. | angleC 0.320-0.327 | 18°

material | comment Copper | Rubber plug

Process connector location, I.D. in. | angleD 0.252-0.259 | 61°

material | comment Copper | Rubber plug

Discharge connector location, I.D. in. | angle E 0.252-0.259 | 25°

material | comment Copper | Rubber plug

Oil cooler connector location, I.D. in. | angleF –

material | comment –

Remarks:

A 6.90 B 6.64 B1 – B2 –

DEHC.ED.200.A1.22 | 1

ASHRAE LBP 115V, 60Hz, fan cooling F

Danf already on order pro All trademarks in this material are property of the respec

Evap. temp. in °F -49 -40 -30 -20 -13 -10 0 10 14 20 30 32 40 41 45 50 59 Capacity in BTU/h 449 600 724 782 1002 1266 1385 1579 1946 2027 2375 2421 2614

Power cons. in W 119 136 148 153 171 188 194 204 218 221 231 232 236

Current cons. in A 1.72 1.78 1.85 1.88 2.01 2.14 2.20 2.28 2.40 2.43 2.50 2.51 2.54

EER in BTU/Wh 3.76 4.41 4.89 5.11 5.88 6.75 7.13 7.75 8.92 9.18 10.30 10.50 11.10

ASHRAE MBP/HBP 115V, 60Hz, fan cooling F

Evap. temp. in °F -49 -40 -30 -20 -13 -10 0 10 14 20 30 32 40 41 45 50 59 Capacity in BTU/h 402 536 647 699 895 1130 1235 1407 1733 1805 2112 2153 2323

Power cons. in W 118 135 146 152 169 186 192 201 216 218 228 229 233

Current cons. in A 1.72 1.78 1.85 1.88 2.01 2.14 2.20 2.28 2.40 2.43 2.50 2.51 2.54

EER in BTU/Wh 3.40 3.99 4.42 4.61 5.30 6.09 6.43 6.99 8.04 8.27 9.28 9.41 9.98

EN 12900 LBP 115V, 60Hz, fan cooling F

Evap. temp. in °F -49 -40 -30 -20 -13 -10 0 10 14 20 30 32 40 41 45 50 59

Capacity in W 138 181 217 233 296 371 404 458 560 582 678 690 743

Power cons. in W 120 134 144 148 162 174 178 184 193 194 198 198 199

Current cons. in A 1.72 1.77 1.82 1.85 1.93 2.00 2.03 2.06 2.08 2.08 2.06 2.06 2.04

COP in W/W 1.14 1.35 1.50 1.57 1.83 2.13 2.26 2.48 2.91 3.00 3.43 3.49 3.74

EN 12900 MBP 115V, 60Hz, fan cooling F

Evap. temp. in °F -49 -40 -30 -20 -13 -10 0 10 14 20 30 32 40 41 45 50 59

Capacity in W 127 167 200 216 275 345 376 427 523 544 634 646 695

Power cons. in W 122 137 148 153 168 182 188 195 206 208 214 215 217

Current cons. in A 1.72 1.78 1.84 1.87 1.97 2.07 2.11 2.16 2.22 2.23 2.25 2.25 2.25

COP in W/W 1.03 1.21 1.35 1.41 1.63 1.89 2.00 2.19 2.54 2.62 2.96 3.01 3.21

Accessories for DLE4CN Figure Code number Test conditions

EN 12900

LBP MBP

Starting relay 1/4 in. spade connectors a2 117U7022 Condensing temperature 104°F 113°F

Start. capacitor 240 µF 1/4 in. spade connectors c 117U5023 Ambient temperature 90°F 90°F

Cover b 103N0492 Suction gas temperature 68°F 68°F

Cord relief d 103N1010 Liquid temperature no subcooling

Mounting accessories Code number

Bolt joint for one comp. Ø: 3/4 in. 118-1949

Bolt joint for one comp. Ø: 5/8 in. 118-1946

Snap-on for one comp. Ø: 5/8 in. 118-1947

oss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products

vided that such alterations can be made without subsequential changes being necessary eady agreed.

ASHRAE

LBP MBP

130°F 130°F

90°F 90°F

90°F 95°F

90°F 115°F