FEATURES
3
1) FRONT MOUNT THERMOSTAT: Easy access control
knob controls the desired temperature inside the freezer. The
proper food storage temperature is -18°C (0°F). The motor turns
on as soon as the temperature rises above the desired level.
2) DEFROST DRAIN: For easy removal of melted ice during
defrosting. It is recommended that you defrost your freezer once
or twice a year.
3) RUST RESISTANT INTERIOR: Aluminum liner for long
lasting durability. (not pictured)
1
2
CAUTION: The hinge of a chest freezer is under tension. You
must excercise EXTREME CAUTION when attempting to
remove, replace, and/or adjust
OPERATING INSTRUCTIONS
STARTING
THE FREEZER
The freezer is ready to operate as received, when connected to the power supply. After connecting to power
supply, close lid and allow freezer to operate. The unit will run from 1 to 2 hours (possibly longer, depending
on conditions) before operating temperature is reached. It will then start and stop (cycle) at fairly regular
intervals. It is recommended that food not be placed in the freezer until you are satisfied that it is operating
regularly and no final adjustments are necessary.
Once your freezer is starting and stopping (cycling) regularly, it is ready to freeze and store foods. The proper
food storage temperature is -18°C (0°F). Do not operate freezer attemperatures below -19°C (-3°F), as this
does not improve food preservation and only results in longer unit (cycle) running time.
It is not advisable to freeze more than 25 kg.(50 lbs.) of food in any 24 hour period. It will take 15 or more
hours of unit running time to freeze this amount of food.
When adding fresh, unfrozen food packages, store them against the walls. The sensing bulb of the thermostat
is fastened to the liner wall on the “insulation side”of the freezer. In view of the value of the contents of your
freezer, it is advisable to inspect contents and check freezer operation regularly.
SETTING
TEMPERATURE
CONTROL
The temperature of the freezer compartment is controlled by adjusting/setting the
thermostat control knob, located on the front of the freezer cabinet. To start the freezer
and achieve maximum cooling quickly;
• Turn the temperature control knob clockwise to the furthest (maximum) setting on the darker blue (wide)
section of the graduated control dial.
Fig. 14
Fig. 15
• Allow the freezer to run at this setting for 3-4 hours.
• When maximum cooling is achieved, turn back the
temperature control knob setting to the 2 o’clock position
on the graduated blue control dial. See Fig.14.
• To turn off the freezer (no cooling), rotate the control
knob to the “0”(off) position. See Fig.15.