2
Here are the features of your new refrigerator.
Take a moment to know all the features and convenience it was designed to
provide. Numbers match those in the illustration on page 1.
§
Ice tray
Fill tray 3/4 full to allow expansion of water during freezing. Place tray in
freezer chest. To release cubes, twist lid slightly.
§
Shelf
Both shelves can be removed by pulling forward. The shelf can be placed
in either of two (higher or lower) positions.
§
Vegetable Crisper
May be used for vegetable storage. Both the crisper and its cover are
removable for easy cleaning. Simply slide forward to remove.
CAUTION: 1. Confirm your voltage before inserting the power supply cord
into the socket.
2. Contact the earthing conductor to this unit with an
attachment earthing screw.
3. DonÕt make it spill to this unit.
4. DonÕt work with flammable spray, such as painting, near this
unit.
5. DonÕt put ignitable materials, such as elther, benzine, LP,
Gas, alcohol, etc., into this unit.
6. Precaution to the leakage of any gas equipment near this
unit
7. Precaution not to hold on to the door of this unit by children.
8. Precaution not to reinsert the power supply cord within 5
minutes after release it from socket. If not, a trouble may be
occured to compressor.
1
NAMES OF PARTS
! FREEZER SHELF
@ ICE BOX
# ICE TRAY
$ TEMP CONTROL DIAL
% LAMP SWITCH
^ SHELF
& CRISPER COVER B
* VEGETABLE
CRISPER
( FREEZER POCKET
) EGG POCKET
1 BOTTLE POCKET(S)
2 BOTTLE POCKET(L)
3 ADJUST FOOT
@
!
#
$
%
^
&
*
(
)
1
2
3
To change temperature
To start refrigerator
43
HOW TO INSTALL
HOW TO CLEAN
Cleaners: The cleaners noted below are available.Never use harsh, abrasive
cleaners, heavy-duty cleaners, or solvents on any surface.
Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains
and for periodic waxing, use silicon wax.
Freezer chest
: When refrigerator needs defrosting set TEMPERATURE
CONTROL at OFF. Do not use sharp instruments.
Refrigeration Section: Wash shelves drawers and other removable parts in
warm sudsy water, rinse and dry. Wash interior with
baking soda solution (3 Table spoons to one quart of
water) or warm sudsy water.
Magnetic Door Seals: Wash with warm sudsy water.
The Finishing Touch: Replace all parts and return TEMPERATURE
CONTROL to desired setting.
Location
Leveling
Install refrigerator in a convenient location away from extreme heat and cold.
Allow sufficient clearance between the refrigerator and side wall so the door will
open for a fully usable interior. Refrigerator is not designed for recessed
installation.
Level refrigerator so it rests solidly on the floor without rocking. There are two
leveling glides, one at each front corner. Turn to the left to raise a corner, to the
right to lower it. Use shims under rear corners, if necessary.
§ If you want, the refrigerator door to close when not held open, adjust glides
so that the front of the refrigerator is raised. However, front corners must
be level with each other, and rear corners with each other.
§ If you want, the refrigerator door to remain motionless when open, adjust
the leveling glides so that all four corners are level with each other.
NOTE : Make sure all packing material is removed. If the shipping tape has
left a residue on the door, touch the residue lightly with the
adhesive side of tape or with isopropyl alcohol (most rubbing
alcohol is this type).
Do not use a solvent, such as lighter or cleaning fluid, nor an
abrasive cleanser.
HOW TO OPERATE
1. TEMPERATURE CONTROL
Temperature is controlled automatically. The TEMPERATURE CONTROL at
the front side of the refrigerator section determines the amount of cooling
your appliance receives.
Many factors influence the internal temperature of the refrigerator section
and freezer section.
§ The temperature and humidity of the home.
§ The frequency of door openings and the amount of warm food placed in
the refrigerator.
§ The combination of foods and containers stored in the refrigerator
For these reasons, you may want to adjust the control to suit the season
and your needs. When adjusting the temperature:
§ Turn TEMPERATURE CONTROL toward PULL DOWN for colder
temperature in refrigerator and freezer sections, and toward MIN for
warmer temperature in both sections.
§ Allow approximately 12 hours or overnight for temperature to stabilize.
Then check to see if further adjustments are necessary.
Set
TEMPERATURE CONTROL at MED.
To turn off refrigerator
Disconnect the power supply cord. Remove ice tray and food. Leave
doors ajar for air circutation and dehumidification of both sections.
Freezer section
Refrigerator Section
6
WHAT TO DO...
1. When out of operating for a long time
§ Remove the power supply cord.
§ Dry your refrigerator opening the door for 2-3 days.
2. When you get ready to move.
§ Securely fasten removable interior parts (or move and package them
separately)
§ Do not lay your refrigerator horizentally, or compressor may be damaged.
When you need service: Before you call for service make sure you
need it, check a few things noted below for yourself first.
If refrigerator is not operating:
§ Is the power supply cord unplugged?
§ Is home fuse blown or circuit breaker off?
If refrigerator is warmer than usual:
§ Has the door been open frequently or for a long period?
§ Is refrigerator overcrowded preventing good air circulation?
§ Is the hot thing stored without cooling?
§ Is the clearance between side and rear plate of the refrigerator and the
wall allowed sufficiently?
If there are unusual sounds:
§ Is refrigerator placed on the level?
§ Are foreign objects behind the refrigerator?
§ Are dishes on refrigerator shelves vibrating?
If so, rearrange the dishes.
5
¡ IN WINTER
¡ PULL DOWN
2. DEFROSTING THE REFRIGERATOR
Turn TEMPERATURE CONTROL toward
IN WINTER for colder tomperature in both
sections.
After you finish cooling food, turn
TEMPERATURE CONTROL towerd MED.
Turn TEMPERATURE CONTROL toward
PULL DOWN, when you want to cool food
in high speed.
After you finish cooling food, turn
TEMPERATURE CONTROL towerd MED.
PULL DOWN
It is defrosted automatically in the refrigerator section. You donÕt need to defrost
the refrigerator section.
§§
ö
Time to defrost
Moisture from food within the refrigerator and in outside air that enters the
refrigerator when the door open, will condense against the cold
refrigerating plate and turn instantly to frost. As this frost builds up to a
depth of more than 1/4 inch, it acts as insulation and actually reduces the
refrigerating effect, In case of this time, defrost the freezer section.
§ How to defrost the freezer compartment
1) Please remove ice tray and freezer shelf, then empty freezer.
2) Set the TEMPERATURE CONTROL at OFF
with the freezer door opened.
In 30 to 40 minutes, the frost the freezer wall
will begin to melt and can be easily removed.
Removed the frost wipe the freezer bottom.
using a cloth.
NOTE : Never use a knife and a sharp object to remove ice tray or frost
because this might damage the surface of the freezer
compartment, this is a danger of piercing through the thin
aluminum refrigerating plate and losing the hermetic charge.
¡ If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or a simmilary qualified person in order to avoid a hazard.
¡ The appliance is not intended for use by young children or infirm persons without
supervision.
¡ Young children should be supervised to ensure that they do not play with the
appliance.
§
Changing the internal light bulb
Disconnect the refrigerator from the main supply by removing the plug.
Replace the bulb with one of the correct type and size(15 watt SES E14 base).
Loading...