Page 1
Document # PGCI-019
COMBINATION INSTALLATIONS
Revised 09/12/14 Page 1/2
Drop-In Cooktop/
Single Wall Oven
WARNING
• Observe all governing codes and ordinances during
planning and installation. Contact your local building
department for further information.
• All appliances must be installed in accordance with the
accompanying installation instructions.
All tolerances: +1/16” (+1.6 mm), -0 unless otherwise stated
PRELIMINARY
Combustible material,
non-combustible material
recommended
C
Non-combustible material
Drop-in cooktop, approved models:
DCT, ETT, MET, RGC, RNCT
or SGM series only
All tolerances: +1/16” (+1.6 mm), -0 unless otherwise stated
NOTE: When installing a gas cooktop, the width of the cooktop
must be equal to or wider than the wall oven width.
NOTE: See following page for dimension key and notes.
B
Cutout depth
D
E
Front of countertop
Cabinet face
*
PLANNING
GUIDE
Dacor DTO[V], DYO[V] or RNO[V]
series single wall oven
Wall oven
platform,
see wall oven
planning guide
24" (61.0 cm)
Minimum interior cabinet depth
*DYO series only: 1" (2.5 cm) min.
CUTAWAY SIDE VIEW
A
Minimum from
finished
countertop to
oven platform
36"
(91.4 cm)
typical
counter height
Cabinet face
All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
Page 2
Document # PGCI-021
COMBINATION INSTALLATIONS
Revised 09/12/14 Page 2/2
Drop-In Cooktop/
Single Wall Oven
Cooktop/Wall Oven
Model No.
DCT series cooktop
with DTO[V] wall oven
DCT series cooktop
with DYO[V] wall oven
DCT series cooktop
with RNO[V] wall oven
ETT, MET series cooktop
with DTO[V] wall oven
ETT, MET series cooktop
with DYO[V] wall oven
ETT, MET series cooktop
with RNO[V] wall oven
RGC series cooktop
with DTO[V] wall oven
RGC series cooktop
with DYO[V] wall oven
RGC series cooktop
with RNO[V] wall oven
RNCT series cooktop
with DTO[V] wall oven
RNCT series cooktop
with DYO[V] wall oven
RNCT series cooktop
with RNO[V] wall oven
SGM series cooktop
with DTO[V] wall oven
SGM series cooktop
with DYO[V] wall oven
SGM series cooktop
with RNO[V] wall oven
*Based on a front cabinet thickness of 3/4” (7.0 cm)
A Min. B C Min. D Min. E Min.* Notes
30 7/8”
(78.4 cm)
31 3/4”
(80.6 cm)
30 7/8”
(78.4 cm)
32 5/8”
(82.8 cm)
33 1/2”
(85.1 cm)
32 5/8”
(82.8 cm)
30 7/8”
(78.4 cm)
31 3/4”
(80.6 cm)
30 7/8”
(78.4 cm)
32 3/8”
(82.2 cm)
33 1/8”
(84.1 cm)
32 3/8”
(82.2 cm)
30 7/8”
(78.4 cm)
31 3/4”
(80.6 cm)
30 7/8”
(78.4 cm)
19 5/8”
(49.8 cm)
19 5/8”
(49.8 cm)
19 5/8”
(49.8 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
19 3/4”
(50.2 cm)
3 1/4”
(8.3 cm)
3 1/4”
(8.3 cm)
3 1/4”
(8.3 cm)
2 1/4”
(5.7 cm)
2 1/4”
(5.7 cm)
2 1/4”
(5.7 cm)
2 7/8”
(7.3 cm)
2 7/8”
(7.3 cm)
2 7/8”
(7.3 cm)
1 1/8”
(2.9 cm)
1 1/8”
(2.9 cm)
1 1/8”
(2.9 cm)
2 7/8”
(7.3 cm)
2 7/8”
(7.3 cm)
2 7/8”
(7.3 cm)
1 5/8”
(4.1 cm)
1 5/8”
(4.1 cm)
1 5/8”
(4.1 cm)
1”
(2.5 cm)
1”
(2.5 cm)
1”
(2.5 cm)
1 7/8”
(4.8 cm)
1 7/8”
(4.8 cm)
1 7/8”
(4.8 cm)
2 3/4”
(7.0 cm)
2 3/4”
(7.0 cm)
2 3/4”
(7.0 cm)
1 7/8”
(4.8 cm)
1 7/8”
(4.8 cm)
1 7/8”
(4.8 cm)
3/4”
(1.9 cm)
3/4”
(1.9 cm)
3/4”
(1.9 cm)
1”
(2.5 cm)
1”
(2.5 cm)
1”
(2.5 cm)
3/4”
(1.9 cm)
3/4”
(1.9 cm)
3/4”
(1.9 cm)
2 3/4”
(7.0 cm)
2 3/4”
(7.0 cm)
2 3/4”
(7.0 cm)
3/4”
(1.9 cm)
3/4”
(1.9 cm)
3/4”
(1.9 cm)
Provide ventilation through cabinet, 7 square
inches minimum. Location may vary.
Minimum 2 inches of space between front of
chassis and back of cabinet required, below
counter-top. See RNCT Planning Guide.
Cooktop model SGM464GG is not approved for
this application.
PLANNING
GUIDE
All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
Loading...