Dacor HWO130FS Planning Guide
Document # PG01-015
J
RNO, RNOV
Revised 11/25/14 Page 1/3
Renaissance® 27” and 30” Wide
Single Wall Ovens
Product tolerances: ±1/16” (±1.6 mm) unless otherwise stated
Top of
K
Utility
cutout
C
A
chassis
B
PLANNING
GUIDE
WARNING
• Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
• This appliance must be installed in accordance with the
F
G
H
D
accompanying installation instructions.
2 3/8”
(6.0 cm)
1 7/8”
(4.8 cm)
Conduit:
60” (152 cm)
Control panel
front
L
E
M
Top of
chassis
long
Control panel
side view
Model
RNO[V]127
21 1/2”
(54.6) cm
RNO[V]130
* To top of chassis notch behind control panel
Epicure
(Order kit #AROVH30S)
Handle Dimensions
ELECTRICAL SPECIFICATIONS
Model
RNO[V]127
RNO[V]130
*** Two 120 Vac hot (L1 and L2), one neutral, one ground
The above specifications are for reference only. See the appliance data
plate for exact specifications.
(A) Overall
Width
26 7/8”
(68.3 cm)
29 7/8”
(75.9 cm)
Dedicated Circuit
Requirements
240 Vac 60 Hz., 4-wire,***
240 Vac 60 Hz., 4-wire,***
(B) Chassis
Width
25 1/2”
(64.8 cm)
28 1/2”
(72.4 cm)
30 Amp.
30 Amp.
Millennia
(C) Overall
Height
27 3/4”
(70.5 cm)
27 3/4”
(70.5 cm)
Flush
Total Connected Load
240 Vac 60 Hz,
19.0 Amp., 4.7 kW
240 Vac 60 Hz,
24.5 Amp., 6.0 kW
(D)* Chassis
Height
27 3/8”
(69.5 cm)
27 3/8”
(69.5 cm)
(E) Control
Panel
Overlay
3/8”
(1.0 cm)
3/8”
(1.0 cm)
(F) Utility
Cutout Width
6 1/2”
(16.5 cm)
* 7/8” (2.2 cm) for models RNO[V]127B, RNO[V]130B, RNO127W and RNO130W
All specications subject to change without notice.
(G) Utility
Cutout Height
5”
(12.7 cm)
(H) Utility
Cutout Depth
7 7/8”
(20.0 cm)
(J) Control
Panel Depth
3/4” *
(1.9 cm)
(K) Chassis
Depth
24”
(61.0 cm)
(L) Control
Panel Notch
Depth
1/2”
(1.3 cm)
(M) Notch
Height
3/4”
(1.9 cm)
Phone: (800) 793-0093www.dacor.com
Document # PG01-015
RNO, RNOV
Revised 11/25/14 Page 2/3
Renaissance 27” and 30” Wide,
Single Wall Oven
Cabinet tolerances: +1/16” (+1.6 mm) -0, unless otherwise stated
36” typ.
(91.4 cm)
N
Recommended
electrical
1” (2.5 cm) min.
location
to bottom of
cabinet door
CUTOUT DIMENSIONS - STANDARD UNDER COUNTER INSTALLATION
1 1/2”
(3.8 cm)
typical counter
PLANNING
GUIDE
1“ (2.5 cm) min. to combustibles
R
P
3/4” (1.9 cm)
support platform
SINGLE WALL OVEN
Minimum interior cabinet depth: 24” (61.0 cm)
1“ (2.5 cm) min.
to combustible floor
Recommended
electrical
location
4” typical toe kick
Model
RNO[V]127
RNO[V]130
R
P
1” (2.5 cm) min.
to top of
cabinet door
4” typical toe kick
CUTOUT DIMENSIONS - STANDARD WALL INSTALLATION
Alternate
electrical
SINGLE WALL OVEN
support platform
location
3/4” (1.9 cm)
31 1/4” (79.4 cm)
recommended
(N) Minimum
Cabinet
Width
27”
(68.6 cm)
30”
(76.2 cm)
(P) Cutout Width
25 5/8” (65.1 cm)
minimum (recommended)
26 1/8” (66.4 cm)
maximum
28 5/8” (72.7 cm)
minimum (recommended)
29 1/8” (74.0 cm)
maximum
(R) Minimum Cutout
Height
27 1/2”
(69.9 cm)
27 1/2”
(69.9 cm)
All specications subject to change without notice.
Phone: (800) 793-0093www.dacor.com
Loading...