Dacor ESG366LP, ESG486LP User Manual

ESG366, ESG486
Hood
ESG366: 42" (1067mm) Recommended
36" (914mm) Minimum
ESG486: 54" (1372mm) Recommended
48" (1219mm) Minimum
10" (254mm)
Min. to
combustible side
wall, both sides
See Page 4
1 1/2" (38mm)
Typical Countertop
18"
(457mm)
30" (762mm)
Minimum
36"
(914mm)
28 1/4"
(717mm)
7 3/4"
(197mm)
Utilities
Location
C
L
6"
(152mm)
ESG366:
24" (610mm)
ESG486: 30" (762mm)
10"
(254mm)
15 1/2"
(393mm)
See Page 4
Revised 02/29/08
36”, 48” Wide,
PLANNING
1/2
NOTES:
1. If cabinet storage space is to be provided directly above the cooktop, the risk of personal injury may be reduced by installing a ventilating hood that projects horizontally a minimum of 5 inches (127mm) beyond the face of the cabinets.
2. Access to the underside of the cooktop, the electrical connection, the gas shut-off valve and the pressure regulator must be provided for inspection and service.
Plan the installation so that the electrical connection, gas shut-off valve, and pressure regulator are accessible from the front of the cabinet, and that all of the minimum dimensions are provided. Dimensions apply to all models unless otherwise noted. Locate the electrical supply box within reach of the included 48 inch (1219mm) long flexible cord so the connection is accessible when the cooktop is in place.
GUIDE
CABINET DIMENSIONS
Model No.
ESG366
ESG366LP Liquid
ESG486
ESG486LP Liquid
NOTES:
Electrical
Circuit
Required
120 Vac,
60 Hz,15 Amp
Connected
1. Factory installed liquid propane (LP) special ordered.
2. Cooktop is supplied with a 48” (1219mm) power cord, with a three prong grounded plug.
3. Utilities are located in the right rear corner of the cooktop.
Web: http://www.Dacor.com Corporate Phone: 800-793-0093
Total
Load Gas Type
Natural
0.25 Amps (0.03 Kw)
Gas and Electrical Requirements
Propane
Natural
Propane
Manifold
Pressure
4” Water
Column
10” Water
Column
4” Water
Column
10” Water
Column
4. Utlities may be located in the right rear corner of the cabinet below the cooktop. (Recommended)
5. See the Combination Installation (CI) Section if installing with a downdraft, or warming oven.
Specifications are subject to change without notice. See installation instructions for additional details.
Min. Gas
Supply
pressure
5” Water
Column
11” Water
Column
5” Water
Column
11” Water
Column
Approximate
Shipping
Weight
128 lbs.
149 lbs.
4.1
ESG366, ESG486
22"
(559mm)
3 1/2"
(89mm)
1 1/8"
(286mm)
5/8"
(16mm)
ESG366: 35 7/8" (911mm)
ESG486: 47 7/8" (1216mm)
ESG366: 34 3/4" (883mm)
ESG486: 46" (1168mm)
Non-combustible rear wall
C
L
22" (559mm)
3" (76mm) Typical
ESG366: 5/8" (16mm)
ESG486: 1” (25mm)
ESG366:
17 3/8" (441mm)
ESG486:
23" (584mm)
ESG366:
17 3/8" (441mm)
ESG486:
23" (584mm)
ESG366:
36" (914mm)
ESG486:
48" (1219mm)
Countertop
Cutout for gas and electrical
locations
C
L
Non-combustible rear wall
C
L
Drill two 1/2" (13mm) holes through
support shelf for cooktop mounting bolts
ESG366
16 5/8" (422mm)
ESG486
20 13/16" (529mm)
ESG366
16 5/8" (422mm)
ESG486
20 13/16" (529mm)
8" (203mm)
6" (152mm)
24" (610mm)
12 9/16"
(319mm)
Combustible rear wall material
26 1/2" (673mm)
To bullnose
27" (686mm)
To knob
7 3/4" (197mm)
Top of finished counter
1" (25mm)
Minimum
Cooktop platform
2 1/2" (64mm)
Min. to combustible surface
Combustible rear wall material
Optional Stainless Steel
Dacor Backsplash ESG366: AEB3609 or AEB3612 ESG486: AEB4809 or AEB4812
21 3/8"
(543mm)
28 3/16"
(716mm)
5/8" (16mm)
2 Places
ESG366 - 36" (914mm)
ESG486 - 48" (1219mm)
ESG366 -33 7/8" (860mm)
ESG486 - 43 1/2" (1105mm)
3" (76mm)
Backsplash
Max.3/4" (19mm)
1/4" (6mm)
Min. flat ledge
Vertical non-combustible surface rear wall
2 13/16"
(71mm)
7/16" (11mm) ESG366
1 5/8” (41mm) ESG486
Revised 02/29/08
BASE CABINET PREPARATION
NON-COMBUSTIBLE REAR WALL
TOP VIEW
36”, 48” Wide,
PLANNING
2/2
GUIDE
Web: http://www.Dacor.com Corporate Phone: 800-793-0093
CUTOUT DIMENSIONS WITH
COUNTERTOP VENT
COUNTERTOP PREPARATION
NON-COMBUSTIBLE REAR WALL
OVERALL DIMENSIONS CLEARANCE
TO COMBUSTIBLE REAR WALL
Specifications are subject to change without notice. See installation instructions for additional details.
4.2
Loading...