Dacor ER48D, ER36D User Manual

RANGE MODELS: ER36D and ER48D

DANGER:

Instructions:

Backguard Kits

PN AERB36/48 -D3 -D9

INSTALLATION

INSTRUCTIONS

Electric shock and explosion hazard! Before installation,
disconnect power at the circuit breaker or fuse box and turn
off the gas supply valve.

Style and size varies with kit

Preliminary

For Review Only

STEP 1: Make sure you have access to the back of the range so that you

can tighten the screws into place.

STEP 2: Disconnect power to the range at the junction or fuse box.

STEP 3: Turn off the gas at the gas supply valve.

WARNING: Do not disassemble the range until it has cooled.

STEP 4: Remove the screws on the front and back of the existing trim.

Slide the trim off the unit.

Existing Trim Removal

Part No. 101491 Rev. D-1

STEP 5: Remove the backguard from the box.

STEP 6: To avoid scratches, place small scraps of

thin cardboard on the rear of the side pan­els where the backguard piece will make
contact. Place the new piece over the back

of the range. Give special attention to the
front ange of the backguard, which must t

between the stainless steel side panels and
over the top of the existing stainless steel
trim piece.

STEP 7: Fasten the backguard and the stainless steel

trim piece in place with the ve (5) existing

chrome plated screws.

STEP 8: Secure the rear of the backguard to the back

of the range with the eight (8) existing hex

screws.

Stainless Steel
Trim Piece

Front of
Range

Spill Tray

Front Flange
of Backguard

Cooktop
Chassis

Range Side View

Back of
Backguard

Range Back
Cover

Backguard

Chrome Plated
Screw, 5 Places

Hex Screw,
8 Places

Backguard Installation

STEP 9: Position the range in the cabinet and turn on the gas at the gas

supply valve. Turn on power to the range at the junction or fuse
box.

Dacor Corporation ● 1440 Bridge Gate Drive, Diamond Bar, CA 91765 ● Tel: [phone] ● FAX: [phone] ● www.Dacor.com