Dacor DYWS4 Installation Manual
WINE DISPENSING SYSTEM MODEL: DYWS4
IMPORTANT: The wine dispensing utilizes a thermo-electric cooling system that can normally
cool the bottle bay to a temperature 25°F less than the ambient air outside the unit. This trim kit
limits system air circulation slightly, limiting the cooling capability to 22°F less than ambient. Be
sure that this limitation is acceptable before installing this kit.
Parts Included with kit
(8) #8 x 3/8 Phillips
head screws (PN 83263)
Trim Kit
Part Number AWSTK24
(9) #10 x 1/2 Phillips
head screws (PN 83022)
(8) Flat head Phillips head
screws (PN 107578)
INSTALLATION
INSTRUCTIONS
(8) Fiber washers
(PN 83555)
Top trim bracket
Left trim
piece
Bottom
trim piece*
Top trim
piece*
Right trim
piece
(1) Base divider
Bottom left trim
bracket
(2) Base supports
Bottom right trim
bracket
Foam Strips
(1 long, 2 short)
*The top and bottom trim pieces are identical, but
installed in the opposite orientation from each other.
Part No. 107554 Rev. A
Tools Required
29”
(73.7 cm)
1 5/8” min.
(4.1 cm)
both sides
21”
(53.3 cm)
24” min.
(61.0 cm)
1 1/2” min.
(3.8 cm)
1 1/2” min.
(3.8 cm)
Wine Dispensing System Trim Kit Instructions
PencilTape measure
Introduction
For proper fit, the cutout dimensions
shown are required. The spacing above
and below the cutout are critical for
ventilation purposes. Failure to provide
proper ventilation will result in poor wine
cooling. Consult the Wine Dispensing
System Installation Instructions
for additional cabinet requirements
(electrical requirements etc.).
Phillips head
screwdriver
Drill with 3/32” drill bit
(for drilling pilot holes)
Page 2
Wine Dispensing System Trim Kit Instructions
Installation Instructions
STEP 1 Peel the protective backing off of the longest of the 3 foam strips and at-
tached it to the base divider as shown.
STEP 2 Attach the (2) base pieces to the base divider using (4) #8 x 3/8 screws. The
foam strip attached in step 1 goes toward the base pieces as shown below.
Foam strip
Base Assembly
Page 3
Loading...