Cyberhome CH-DVD 300 Quick Setup Guide

CH-DVD 300 Quick Setup Guide

Connect the DVD Player to

1

your TV

 Use the AV (Audio/Video) cable

provided to connect the DVD player to
your TV as shown in the diagram.

 Your TV must be equipped with AV

inputs like those pictured to the right in
order to connect this unit.

 If your TV does not have AV inputs, you

will need a RF Modulator to connect this
player to your TV's antenna/cable input.
RF Modulators are available at major
electronics retailers.

Plug-in the Power Cord

2

 Plug the DVD player's electrical

plug into a wall socket or power
strip.

TV

ANTENNA / CABLE IN

VIDEO R - AUDIO - L

COAXIAL

Turn on the DVD Player and your TV

3

 Press the POWER BUTTON on the front panel to turn the

DVD player on. The POWER LED should now change
from RED (STANDBY MODE) to GREEN (ON).

Select the VIDEO INPUT on your TV

4

 The goal is to see the DVD player's splash screen on your

TV. To do this, select the Video Input channel on your TV
that corresponds with the input the player is plugged into.
This procedure differs among TVs, but is normally done by
pressing the VIDEO IN or INPUT button on the TV's remote
control to select the Video Input.

 When the DVD player's splash screen appears on your TV,

you're ready to go!

CH-DVD 300

R

L

VIDEO

S-VIDEO

Y

Pb/Cb

PROGRESSIVE SCAN
COMPONENT VIDEO OUT

Pr/Cr

POWER LED

TM