Cta Aut-vhfm User Manual

Instructions:

Tablet

4

AUT-VHFM

1.Attaching Foam Pad to Tablet Holder

1mm Foam Pad

Use this table to determine the appropriate
foam pad to use with your tablet.

Note: sizes refer to total tablet size with or without a case.

Foam Pad

Vehicle Headrest Flex Mount

for 7-14 Inch Tablets

5mm
Foam
Pad

10mm
Foam
Pad

Thickness

1mm 0.67-1.06in

5mm 0.51-0.91in

Thickness:

17-27mm

/

13-23mm

/

Select the appropriate foam pad according to the
thickness of your tablet (or tablet in its case), then
press adhesive side into center of the tablet holder.

10mm 0.31-0.71in

2.Installing Vechicle Headrest Security Flex Mount to your Vechicle Headrest

x4

1. Screw both BASE of the calmp on the
headrest sopport with the M4*25 screw and Allen Key.

3.Adjusting the Flex Arm

2. Repeat Step 1 to screw up 4 screws and
make sure you have installed it securely.

8-18mm

/

Package Contents:

Vehicle Headrest Flex Mount

Foam Pads

Hex. Allen Key M4x25 Screw x 4

1. Twist the SCREW KNOB(both or Either)
anticlockwise to release the connection.

2. Adjust the arm to your favorite position and then
tighten the SCREW KNOB clockwise .

4. Installing your Device and Adjusting the Tablet holder

360 rotation˚

1.Press quick release button on side of tablet holder to release the
adjustable end. Insert tablet corner against the spring arm, then push
adjustable arm down against opposite corner. Be sure it is as snug
as possible.

Caution

Please be sure to fasten all the screws were tightened securely while using the stand.

!

Not for use while driving.
Max loading :1KG

2.Tablet holder rotates 360 degrees for
custom viewing angles.