Cretors NCD Service Manual

3243 North California Avenue, Chicago, IL 60618

NACHO CHEESE

DISPENSER

NCD-M-A/E-S

SERVICE MANUAL

120 Volt,

Single Phase, 60 Cycle

230 Volt,

Single Phase, 50 Cycle

1/5/2005

READ

safety instructions before operating or servicing this machine

and UNDERSTAND these operating, servicing, and

1

BEGIN SERIAL NO. 01030000

TABLE OF CONTENTS

I. Safety Alert Symbol . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

II. Safety First . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

III. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

IV. Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

A. Electrical
B. Size

V. Purpose of Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

VI. Control Panel. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

VII. Installation Instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4

A. Location
B. Power Supply
C. Unpacking

VIII. Service Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5

IX. Trouble Shooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6

NCD-M-A/E-S

1/5/2005

2

BEGIN SERIAL NO. 01030000

NCD-M-A/E-S

I. SAFETY ALERT SYMBOL

The symbol shown below is used to call your attention to instructions concerning your personal
safety and the safety of others. Watch for this symbol. It points out important safety precautions
and procedures. It means ATTENTION! Become Alert! Your personal safety is at risk! Read the
message that follows and be alert to the risk of personal injury or death.

II. SAFETY FIRST

The information in this manual is essential for safe installation and service of
your Cretors machine. The manual must be read and understood before
installing, or maintaining equipment, or equivalent training must be
provided.

"The employer must instruct each employee in the recognition and avoidance
of unsafe conditions, regulations applicable to his work environment to
control and eliminate any hazards or other exposure to illness or injury".
Ref.: 29 CFR 1926.20 (b)(4)(a)(2)

It is understood that safety rules within individual companies vary. If a
conflict exists between the safety procedures contained in this manual and
the rules of a using company, the more stringent rule should take precedence.

III. INTRODUCTION

This manual is filled with time-saving and money-saving information regarding your Cretors
machine. There is nothing, however, more important than the safety aids and warnings that are
found throughout this document. The Safety Alert Symbol is used to identify topics of primary
safety concern wherever they appear. A separate section has been included which deals exclusively
with operation and accident prevention.

If, after reviewing this manual, anything is unclear or technical problems are encountered, contact
the distributor from whom you purchased your machine. For assistance and if there are any
additional questions, feel free to contact our Customer Service Department at the address and/or
phone number listed on the last page of this manual. Always have the model and serial number of
your machine available to assist in obtaining the correct information.

1/5/2005

3

BEGIN SERIAL NO. 01030000