Cretors AGR6 Installation Manual

NT/GR/T2-A/E-O

3243 North California Avenue, Chicago, IL 60618

NUGGET
GOLDRUSH PLUS
T-2000 POPCORN MACHINES
OPERATION MANUAL

120 Volt
Single Phase, 60 Cycle

100/120 Volt
Single Phase, 50/60 Cycle

230 Volt
Single Phase, 50 Cycle

READ and UNDERSTAND these operating and safety

instructions before operating this popcorn machine

NGT-M-A July 11, 2000

1

BEGIN SERIAL NO. 00000000

NT/GR/T2-A/E-O

SAFETY FIRST

The information in this manual is essential for the safe installation and
maintenance of your Cretors popcorn machine. The manual must be read
and understood before installing and operating of this equipment, or
equivalent training must be provided.

"The employer shall instruct each employee in the recognition and
avoidance of unsafe conditions and the regulations applicable to his work
environment to control or eliminate any hazards or other exposure to illness
or injury". Ref.: 29 CFR 1926.20 (b)(4)(a)(2)

It is understood that safety rules within individual companies vary. If a
conflict exists between the safety procedures contained in this manual and
the rules of a using company, the more stringent rule should take
precedence.

NGT-M-A July 11, 2000

2

BEGIN SERIAL NO. 00000000

NT/GR/T2-A/E-O

I INTRODUCTION

This manual is filled with time-saving and money-saving information regarding your Cretors
popcorn machine. There is nothing, however, more important than the safety aids and warnings
that are found throughout this document. The Safety Alert Symbol is used to identify topics of
primary safety concern wherever they appear. Furthermore, a separate section has been
included which deals exclusively with operation and accident prevention.

If, after reviewing this manual, anything is unclear or technical problems are encountered,
contact the dealer from whom you purchased your machine for assistance and if there are any
additional questions, feel free to contact our Customer Service Department at the address and/or
phone number listed on back cover of this manual. Always have the model and serial number of
your machine available to assist in obtaining the correct information.

II SAFETY ALERT SYMBOL

The symbol shown below is used to call your attention to instructions concerning your personal
safety and the safety of others. Watch this symbol. It points out important safety precautions. It
means "ATTENTION! Become Alert! Your personal safety is involved!" Read the message that
follows and be alert to the risk of personal injury or death.

III PURPOSE OF MANUAL

This instruction manual is intended to familiarize owners with the
operation and safety procedures associated with your Cretors popcorn
machine.

This manual should be kept available to operating personnel.

A person who has not read and understood all operating and safety
instructions is not qualified to operate the popcorn machine.

NGT-M-A July 11, 2000

3

BEGIN SERIAL NO. 00000000

NT/GR/T2-A/E-O

IV PRODUCT IDENTIFICATION

CRETORS POPCORN MACHINE:

NUGGET COUNTER MODEL: NT6
GOLDRUSH PLUS MODELS: GR6, AGR 6
T-2000 MODELS: T-2000 AT2C

V PRINCIPLES OF POPCORN MACHINE OPERATION

Theory and Observations of Popcorn Machine Operation

1. The efficient production of popcorn requires the presence of popcorn kernels, heat,
and oil. The purpose of the oil is to distribute the heat throughout kernels evenly
and quickly. If the heat is not distributed evenly and quickly, the kernels may burn
instead of pop.

2. In order to pop corn in oil, the kettle, oil and parts near the heating elements are

NGT-M-A July 11, 2000

necessarily and unavoidably heated to temperatures high enough to pop
popcorn. The temperature control uses a sensing thermostat located inside the
kettle to maintain the kettle at an operating temperature of approximately 450° F
(232 °C). Contact with these surfaces will burn and scald you. Do not touch the
kettle, oil or parts in the direct vicinity of the heating elements.

3. The kettle is provided with an agitator to assist in the quick and even distribution
of heat throughout the kernels.

4. The oil is heated to high temperatures in a kettle provided with electric heating
elements to reach proper popping temperature. An operator is required in the
vicinity of the kettle only when handling corn or dumping popped corn from the
kettle. Neither of these operations requires direct contact with the kettle. Direct
contact with the hot oil, kettle, or heating elements could result in serious burns
or scalds. Keep away from the kettle whenever possible. Use the handle when
dumping the kettle, and use the provided cups when necessary to measure corn,
oil and salt.

5. As the popcorn pops, it will push the lid open and discharge into the cabinet.
When the corn finishes popping, the corn remaining in the kettle can be removed
by manually lifting the cover. Then pull down on kettle handle, pull towards you
and then lift handle up to dump the popcorn into the popcorn case.

6. The popper case is provided with a heat lamp to keep the popcorn crisp and
warm. Additionally, the Goldrush and T-2000 has a thermostatically controlled
heat pad.

4

BEGIN SERIAL NO. 00000000