Crestron PW-1830RU
Power Pack
Operations Guide
Crestron PW-1830RU Power Pack
Power Pack: PW-1830RU
Description
The PW-1830RU is capable of powering a regulated 18-volt Crestron® product from a
standard AC receptacle (120 VAC, 60 Hz or 220 - 240 VAC, 50 Hz). It is designed for indoor
use only.
NOTE: Only connect this power pack to a Crestron device that is rated at 18 volts
(regulated) and no more than 3 amps. Plugging this power pack into a Crestron device that
has a different rating could damage the device or the power pack.
Specifications
Crestron suggests that only this power pack be used with designated Crestron products. In the
event another compatible power pack (not supplied by Crestron) is required, the
specifications for the PW-1830RU are as follows.
Input/Output Specifications
INPUT SPECIFICATION OUTPUT SPECIFICATION
120 VAC 60 Hz or 220-240 VAC 50 Hz 18 VDC, 3 A, regulated
Setup
Complete the following steps to properly setup and connect the power pack. Refer to the
illustration at the conclusion of the procedure.
1. Attach the line cord (supplied) to the IEC320 connector on the power pack.
2. Insert other end of the line cord into an active AC receptacle.
3. As shown in the following diagram, insert the PW-1830RU locking connector
plug into the PWR port of the Crestron device.
1 • Power Pack: PW-1830RU Operations Guide – DOC. 6392
Loading...