Crestron PW-1280RU User Manual

Crestron PW-1280RU
Power Pack
Operations Guide

Crestron PW-1280RU Power Pack

Power Pack: PW-1280RU

Description

The PW-1280RU is used to power certain Crestron Isys i/O™ touchpanels from a standard
AC receptacle (120V, 60 Hz or 220V – 240V, 50 Hz). It is designed for indoor use only. The
PW-1280RU can only be used with the following devices:

• TPMC-15-CH • TPMC-17-CH • TPMC-15-QM • TPMC-17-QM

• TPMC-15-CH-L • TPMC-17-CH-L • TPMC-15-QM-L • TPMC-17-QM-L

• TPMC-L-IMC

CAUTION: Plugging this power pack into a Crestron device that is not listed above could
damage the device or the pack.

Specifications

Following are specifications for the PW-1280RU.

Input/Output Specifications

120VAC 60Hz or 220 to 240 VAC 50Hz 12.5 VDC 7.92 A (min), regulated

Setup

INPUT SPECS OUTPUT SPECS

Complete the following steps to properly setup and connect the power pack.

1. Attach the line cord (supplied) to the IEC320 connector on the power pack.

2. Insert other end of the line cord into an active AC receptacle.

3. As shown in the following diagram, insert the PW-1280RU plug into the PWR
port of the touchpanel or the PWR IN port of the TPMC-L-IMC.

1 • Power Pack: PW-1280RU Operations Guide - DOC. 6401