CREEK 4330 SPECIFICATION
POWER OUTPUT (both channels)
POWER OUTPUT (one channel)
POWER OUTPUT (one channel)
Not recommended for use into more than two pairs of 8 Ω loudspeakers.
TOTAL HARMONIC DISTORTION (20 Hz to 20 kHz) |
< 0·05% 20 Hz to 20 kHz |
|
FREQUENCY RESPONSE |
3 Hz to 25 kHz - 1 dB |
|
SLEW RATE |
> 40 V per μS |
|
INPUT SENSITIVITY (passive) |
350 mV Line level inputs |
|
SIGNAL TO NOISE RATIO (‘A’ weighted) |
> 100 dB |
|
SEPARATION (line input) |
> 60 dB at 1 kHz |
|
MM SENSITIVITY AND IMPEDANCE (when fitted) |
3.5 mV |
47kΩ |
MC SENSITIVITY AND IMPEDANCE (when fitted) |
0.75 mV |
1kΩ |
POWER CONSUMPTION (at idle) |
< 40 W |
|
POWER CONSUMPTION (full power 10% THD) |
200 W |
|
WEIGHT |
4·5 Kgs, |
10 lbs |
SIZE |
|
420 x 60 x 230 mm |
|
|
16·5” x 2·4” x 9'' |
MAINS VOLTAGE |
@ 60Hz |
100V Japan, 115V North America |
|
@ 50Hz |
230/240V Europe, Asia and UK |
MAINS VOLTAGE AND FREQUENCY IS INTERNALLY SET FOR THE COUNTRY OF USE
Creek Audio Ltd reserve the right to change or modify the specification of its products without prior warning.
Designed and made in the UK.
Creek Audio Ltd
2 Bellevue Road, Friern Barnet, London N11 3ER, England
Tel: 00 44 + (0)181-361 4133 |
Fax: 00 44 + (0)181-361 4136 |
E-mail: mcreek@ibm.net |
Internet: www.creekaudio.co.uk |
Creek 4330
& 4330R
Operating Instructions
Thank you for purchasing the 4330 amplifier. You are now in possession of a State of the Art Integrated Amplifier. The functions and operation of the 4330 are extremely simple.
the following notes are provided to explain all aspects of its design and use.
MAINS CONNECTION
When unpacking the amplifier please keep the packing material in a safe place for possible future use. In the pack there is a separate mains cable suitable for connecting to the mains supply in the country of use. The IEC socket end of the cable should be firmly inserted into the connector on the rear panel marked "Mains Input".
Remember, do not overload the mains wall socket with too many plugs or adaptors. The high quality performance of the amplifier will be impaired if the electrical supply to it is in poor condition. If in doubt, consult a qualified electrician or your dealer. The "Mains Input" connection is also fitted with a fuse, specifically suited to the supply voltage of the country of use. The correct value is clearly marked on the rear panel next to the Mains Input.
Should it be necessary to replace the fuse, ensure that you use the same type as specified on the rear panel. i.e: 5 x 20mm cartridge type T 1·6A surge resisting for 220-240V 50Hz AC, T 3·15A surge resisting for 110-120V 60Hz AC or a T 4A surge resisting for 100V (Japan).
Loading...