Craftsman 315.PP2020, 315.PP2030 Owner's Manual
19.2 VOLT
LITHIUM-ION
BATTERY PACK
315.PP2020 315.PP2030
To register your Craftsman product, please visit:
http://www.sears.com/craftsman
Use this battery pack for Craftsman 19.2V Lithium-ion
cordless products only. Refer to the Operator’s Manual
provided with product. Always mention the model number
above when communicating with us regarding this battery
pack.
SAFETY RULES
WARNING! Read and understand all instructions.
Failure to follow all instructions listed below, may
result in electric shock, fire and/or serious personal
injury.
Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in
operating condition. Be aware of possible hazards
when not using your battery tool or when changing
accessories. Following this rule will reduce the risk of
electric shock, fire, or serious personal injury.
Do not place battery tools or their batteries near
fire or heat. This will reduce the risk of explosion and
possibly injury.
Do not crush, drop or damage battery pack. Do not
use a battery pack or charger that has been dropped
or received a sharp blow. A damaged battery is subject
to explosion. Properly dispose of a dropped or damaged
battery immediately.
Batteries can explode in the presence of a source
of ignition, such as a pilot light. To reduce the risk of
serious personal injury, never use any cordless product
in the presence of open flame. An exploded battery can
propel debris and chemicals. If exposed, flush with water
immediately.
Do not charge battery tool in a damp or wet location.
Following this rule will reduce the risk of electric shock.
Charge only with Craftsman 19.2V dual-chemistry
battery chargers. Use of other chargers may result in
personal injury, fire, or damage.
Do not charge battery in an area of extreme heat or
cold. It will work best at normal room temperature.
To reduce the risk of serious personal injury, do not
store outside or in vehicles.
Under extreme usage or temperature conditions,
battery leakage may occur. If liquid comes in
contact with your skin, wash immediately with soap
and water. If liquid gets into your eyes, flush them
with clean water for at least 10 minutes, then seek
immediate medical attention. Following this rule will
reduce the risk of serious personal injury.
When battery pack is not in use, keep it away from
other metal objects like: paper clips, coins, keys,
nails, screws, or other small metal objects that can
make a connection from one terminal to another.
Shorting the battery terminals together may cause
sparks, burns, or a fire.
Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning,
or when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
Always remove battery pack before storing the
device.
Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Failure to do so could
result in objects being thrown into your eyes and other
possible serious injuries.
Keep battery pack dry, clean, and free from oil and
grease. Always use a clean cloth when cleaning.
Never use brake fluids, gasoline, petroleum-based
products, or any solvents to clean battery pack.
Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If you
loan someone this tool, loan them these instructions.
CALIFORNIA PROPOSITION 65
WARNING: This product may contain chemicals,
including lead, known to the state of California to
cause cancer, birth defects or other reproductive
harm. Wash hands after handling.
OPERATION
C3 ENERGY INDICATOR
See Figure 1.
Some tools feature a C3 indicator window. When the
315.PP2020 or 315.PP2030 Craftsman 19.2 V lithium-ion
battery pack is installed into the tool and has charge, the
tool’s C3 indicator light will glow.
BATTERY GAUGE
See Figure 1.
To display the amount of charge left in the battery, press
the battery gauge button.
Ifthe battery gauge indicator light glows green, the
battery pack is fully charged.
If it glows yellow, it has a usable charge remaining but
will soon require recharging.
If it glows red, the battery requires recharging.
LITHIUM-ION BATTERY PACKS
Lithium-ion batteries deliver fade free power for their
entire run time. Lithium-ion tools will not gradually lose
power due to decreasing battery charge. Instead, power
from the battery pack will drop from full to zero once the
full charge has been drained from the battery. Once this
happens, recharging of the battery is required.
It is not necessary to drain the battery pack completely
before recharging.
BATTERY PROTECTION FEATURES
Lithium-ion battery packs are designed with features that
protect the lithium-ion cells and maximize battery life.
English
OPERATION
If the tool stops during use, release the trigger to reset
and resume operation. If the tool still does not work, the
battery needs to be recharged.
COLD WEATHER OPERATION
The lithium-ion battery pack can be used in temperatures
down to 5° F (-15° C). Put the battery pack on a tool
and use the tool in a light duty application. After about
a minute, the pack will warm up and begin operating
normally.
CHARGING THE BATTERY PACK
See Figure 1.
Battery packs are shipped in a low charge condition to
prevent possible problems. Therefore, you should charge
prior to first use. If the charger does not charge the battery
pack under normal circumstances, return both the battery
pack and charger to your nearest Authorized Service
Center for electrical check.
Charge the battery pack only with the recommended
charger.
Refer to charger operator’s manual for charging
instructions.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the battery pack may
become hot. A hot battery pack may be placed directly
onto the charger port but charging will not begin until
the battery temperature cools to within acceptable
temperature range. When a hot battery pack is placed
on the charger, the charger may indicate the pack is
not ready to charge. Please refer to charger operator’s
manual. When the battery pack cools, the charger will
automatically begin charging.
C3 ENERGY
INDICATOR
WINDOW
PP2030
DEPRESS LATCHES
TO RELEASE
BATTERY PACK
PP2020
CHARGING A COLD BATTERY PACK
A cold battery pack may be placed directly onto the
charger port but charging will not begin until the battery
temperature warms to within acceptable temperature
range. When a cold battery pack is placed on the charger,
the charger may indicate the pack is not ready to charge.
Please refer to charger operator’s manual. When the battery
pack warms, the charger will automatically begin charging.
MAINTENANCE
BATTERIES
These batteries have been designed to provide maximum
trouble-free life. However, like all batteries, they will
eventually wear out. Do not disassemble battery pack
and attempt to replace the batteries. Handling of these
batteries, especially when wearing rings and jewelry, could
result in a serious burn.
For battery pack storage longer than 30 days:
Store the battery pack where the temperature is below
80°F and away from moisture.
Store battery packs in a 30%-50% charged condition.
Every six months of storage, charge the pack as normal.
BATTERY PACK REMOVAL AND PREPARATION
FOR RECYCLING
To preserve natural resources, please recycle
or dispose of batteries properly.
This product contains lithium-ion batteries.
Local, state or federal laws may prohibit
disposal of batteries in ordinary trash.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
WARNING: Upon removal, cover the battery
pack’s terminals with heavy-duty adhesive tape. Do
not attempt to destroy or disassemble battery pack
or remove any of its components. Batteries must be
recycled or disposed of properly. Also, never touch
both terminals with metal objects and/or body parts
as short circuit may result. Keep away from children.
Failure to comply with these warnings could result in
fire and/or serious injury.
Craftsman Consumer Helpline: 1-800-932-3188
Sears Brands Management, 3333 Beverly Rd.
Hoffman Estates, IL 60179 USA
Visit the Craftsman web page: www.sears.com/craftsman
BATTERY
GAUGE BUTTON
ON BOARD
ENERGY
INDICATOR
BATTERY
GAUGE BUTTON
Fig. 1
SAVE THESE INSTRUCTIONS
English
990000209
10-2-12 (REV:03)
Loading...