Cornelius DB200, CM450, CM650, CM500 User Manual

IMI CORNELIUS INC.

One Cornelius Place
Anoka. MN 55303-6234
Telephone[phone]
Facsimile (612) 422--3246

INSTALLATION INSTRUCTIONS

KIT, P/N 2306

For installing Scotsman Model CM450, 500, & 650 Series Ice Makers on Remcort Model DB200 Series Ice/
Drink dispenser.

1. Bin Level Control
A. Locate and drill three (3) 5/16” diameter holes (Ref. Fig. 1).

B. Install mounting clamps.

2. Seal ice maker to top of Dispenser as follows:
A. Run a bead of RTV on the dispenser cover around the outline of the ice maker and inside edge of cov-

er opening.

B. Set ice maker onto cover and install bin level thermostat capillary tube in clamps and tighten screws

(Ref. Fig 1). Position ice maker as shown.

C. Wipe away excess RTV.

3. Secure ice maker to Dispenser with mounting brackets as show. Drill holes and install sheet metal screws
provided into ice maker cabinet and dispenser cover. Screws must not interfere with ice maker compo­nents.

4. Install adhesive backed gasket strip to removable lid, and install with screw provided.

5. Follow the manufacturer’s instructions to complete the installation of the ice maker. Bin level thermostat
capillary tube must not interfere with agitator.

191933 12/9/96

24

ROUTE ICEMAKER BIN LEVEL
THERMOSTAT CAPILLARY TUBE
AS SHOWN. INSTALL ON
HOPPER AS SHOWN IN FIG. 1

30

ICEMAKER TO BE
FLUSH WITH BACK
EDGE OF COVER.

APPLY RTV AROUND INSIDE
OF ICEMAKER OUTLINE ON
DISPENSER COVER TO
FORM A SEAL.

ADD ADHESIVE BACKED GAS­KET STRIPS TO REMOVABLE LID.

REMOVE SCREWS AND TURN
BRACKETS AROUND 180_.
REPLACE SCREWS. USING
BRACKET AS TEMPLATE,

2808028080

2808028080

DRILL (4) .136 DIA. HOLES
INTO ICEMAKER CABINET
FOR SHEET METAL SCREWS
PROVIDED. DRILLING IS NOT
TO INTERFERE WITH
ICEMAKER COMPONENTS.

REMOVABLE FRONT LID
FOR MANUAL ICE FILLING.

2 9193312/9/96