Comtech EF Data RRS11 User Manual

Solid-State Transfer Switch
Installation and Operation Manual
IMPORTANT NOTE: The information contained in this document supersedes all previously published information regarding this product. This manual is subject to change without prior notice.
Part Number MN-RRS11 Revision 3

RRS11

Solid-State Transfer Switch

Installation and Operation Manual

Part Number MN-RRS11
Rev. 3
August 17, 2010
Copyright © 2010 Comtech EF Data. Al l rights reserv ed. Printed in the USA.
Comtech EF Data, 21 14 Wes t 7th St re et , Tem pe, Ariz on a 85 28 1 USA, 480.333.220 0, FAX: 480.333.2161
This page is intentionally blank.
Table of Contents
TABLE OF CONTENTS ............................................................................................................III
CHAPTER 1. INTRODUCTION .................................................................................. 1–1
1.1 Overview ...................................................................................................................................... 1–1
CHAPTER 2. INSTALLATION ................................................................................... 2–1
2.1 Installation Requirements .......................................................................................................... 2–1
2.2 Unpacking .................................................................................................................................... 2–2
2.2.1 Test Data Sheet ..................................................................................................................... 2–2
2.3 System Connections .................................................................................................................... 2–2
CHAPTER 3. OPERATION ........................................................................................ 3–1
3.1 Solid-State Transfer Switch Operation ..................................................................................... 3–1
3.2 Operating Procedures ................................................................................................................. 3–3
3.3 Solid-State Transfer Switch Backup Operation ....................................................................... 3–3
CHAPTER 4. MAINTENANCE AND TROUBLESHOOTING ..................................... 4–1
4.1 Basic Troubleshooting and Maintenance .................................................................................. 4–1
4.2 Basic User Checks ....................................................................................................................... 4–1
4.2.1 Checking the Cabling and Connectors .................................................................................. 4–1
CHAPTER 5. TECHNICAL SPECIFICATIONS .......................................................... 5–1
5.1 RRS11 and RRS11 L Technical Specifications ........................................................................ 5–1
5.2 Introduction - RRS11 L-Band Switch ....................................................................................... 5–1
5.2.1 General Specifications .......................................................................................................... 5–1
5.2.2 Power and Environmental ..................................................................................................... 5–2
5.2.3 Physical ................................................................................................................................. 5–2
5.3 Introduction - RRS11 70/140 MHz Switch ............................................................................... 5–2
5.3.1 General Specifications .......................................................................................................... 5–2
5.3.2 Power and Environmental ..................................................................................................... 5–2
5.3.3 Physical ................................................................................................................................. 5–2
iii
Table of Contents MN-RRS11 RRS11 Solid-State Transfer Switch Rev. 3
Notes:
iv

PREFACE

About this Manual

This manual describes th e installation and operation for the Radyne RRS11. This is a technical document intended for earth station engineers, technicians, and operators responsible for the operation and maintenance of the RRS11.
Reporting Comments or Suggestions Concerning this Manual
Comments and suggesti ons regar ding the cont ent an d design of this m anual are apprec iated. T o submit comments, please contact the Comtech EF Data Technical Publications department:
TechnicalPublications@comtechefdata.com

Conventions and References

Metric Conversion
Metric conversi on inf orm atio n is loc ated o n the i nside b ac k cover of this m anu al. T his inf orm ation is provided to assist the operator in cross-referencing non-Metric to Metric conversions.
i
RRS11 Solid-State Transfer Switch MN-RRS11
IM P O RTA N T
CAUTION
CAUTION indicates a hazardous situation that, if not avoided, may result in
may also be used to indicate other
WARNING
indicates a potentially hazardous situation that, if not avoided,
Preface Rev. 3
Cautions and Warnings
IMPORTANT or NOTE i ndicates a statement associated with the task
being performed or information critical for proper equipment function.
minor or moderate injury. CAUTION unsafe practices or risks of property damage.
WARNING could result in death or serious injury.
Examples of Multi-Hazard Formats
Trademarks
Product names m entioned in this manual may be tradem arks or registered trademarks of their respective companies and are hereb y acknowledged.
ii
RRS11 Solid-State Transfer Switch MN-RRS11
!
NOTE
Preface Rev. 3

Safety Compliance

EN 60950

Applicable testing is rout inely performed as a condition of manuf acturing on all units to ensure compliance with safet y requirem ents of EN609 50.T his equipm ent m eets the Safety of Inf orm ation Technology Equipment specification as defined in EN60950.
Low Voltage Directive (LVD)
The following information is applicable for the European Low Voltage Directive (EN60950):
<HAR> Type of power cord required for use in the European Community.
CAUTION: Double-pole/Neutral Fusing ACHTUNG: Zweipolige bzw. Neutralleiter-Sicherung
International Symbols:
Symbol Definition Symbol Definition
~
Alternating Current
For additional symbols, refer to Cautions and Warnings, listed earlier in this Preface.
Fuse
Protective Earth /
Safety Ground
Chassis Ground
iii
RRS11 Solid-State Transfer Switch MN-RRS11 Preface Rev. 3

Warranty Policy

Comtech EF Data products are warranted against defects in material and workmanship for a period of two years from the date of shipment. During the warranty period, Comtech EF Data will, at its option, repair or replace products that prove to be defective. Repairs are warranted for the remainder of the original two year warranty, or a 90 day extended warranty, whichever is longer.
For equipment under warranty, the owner is responsible for freight to Comtech EF Data and all related customs, taxes, tariffs, insurance, etc. Comtech EF Data is responsible for the freight charges only for return of the equipment from the factory to the owner. Comtech EF Data will return the equipment by the same method (i.e., Air, Express, Surface) as the eq ui pment was sent to Comtech EF Data.
All equipment returned for warranty repair must have a valid RMA number issued prior to return and be marked clearly on the return packaging. Comtech EF Data strongly recommends all equipment be returned in its original packaging.
Comtech EF Data Corporation’s obligations under this warranty are limited to repair or replacement of failed parts, and the return shipment to the buyer of the repaired or replaced par ts .
Limitations of Warranty
The warranty does not apply to any part of a product that has been installed, altered, repaired, or misused in any way that, in the opinion of Comtech EF Data Corporation, would affect the reliability or detracts from the performance of any part of the product, or is damaged as the result of use in a way or with equipment that had not been previously approved by Comtech EF Data Corporation.
The warranty does not apply to any product or parts ther eof where t he serial number or the serial number of any of its parts has been altered, defaced, or removed.
The warranty does not cover damage or loss incurred in transportation of the product.
The warranty does not cover replacement or repair necessitated by loss or damage from any cause beyond the control of Comtech EF Data Corporation, such as lightning or other natural and weather related events or wartime environments.
The warranty does not cover any labor involved in the removal and or reinstallation of warranted equipment or parts on site, or any labor required to diagnose the necessity for repair or replacement.
iv
RRS11 Solid-State Transfer Switch MN-RRS11 Preface Rev. 3
The warranty excludes any responsibility by Comtech EF Data Corporation for incidental or consequential damages arising from the use of the equipment or products, or for any inability to use them either separate from or in combination with any other equipment or products.
A fixed charge established for each product will be imposed for all equipment returned for warranty repair where Comtech EF Data Corporation cannot identify the cause of the reported failure.
Exclusive Remedies
Comtech EF Data Corporation’s warranty, as stated is in lieu of all other warranties, expressed, implied, or statutory, including those of merchantability and fitness for a particular purpose. The buyer shall pass on to any purchaser, lessee, or other user of Comtech EF Data Corporation’s products, the aforementioned warranty, and shall indemnify and hold harmless Comtech EF Data Corporation from any claims or liability of such purchaser, lessee, or user based upon allegations that the buyer, its agents, or employees have made additional warranties or representations as to product preference or use.
The remedies provided herein are the buyer’s sole and exclusive remedies. Comtech EF Data shall not be liable for any direct, indirect, special, incidental, or consequential damages, whether based on contract, tort, or any other legal theory.
v
RRS11 Solid-State Transfer Switch MN-RRS11 Preface Rev. 3

Customer Support

Contact the Comtech EF Data Customer Support Department for:
Product support or training
Reporting comments or suggestions concerning manuals
Information on upgrading or returning a product
A Customer Support representative may be reached at:
Comtech EF Data Attention: Customer Support Department 2114 West 7th Street Tempe, Arizona 85281 USA
480.333.2200 (Main Comtech EF Data number)
480.333.4357 (Customer Support Desk)
480.333.2161 FAX
To return a Comtech EF Data product (in-warranty and out-of-warranty) for repair or replacement:
Contact the Comtech EF Data Custom er Support D epartm ent. Be prepared to s upply the Customer Support representative with the model number, serial number, and a description of the problem.
Request a Re turn Material Authorization (RMA) number from the Comtech EF Data Customer Support representative.
Pack the produc t in its or igi nal s h ipp ing c ar ton/ pac kaging to ensure that t he pr o du ct is not damaged during shipping.
Ship the product back to Comtech EF Data. (Shipping charges should be prepaid.)
Online Customer Support
An RMA number request can be requested electronicall y by contacting the Customer Support Department through the online support page at www.comtechefdata.com/support.asp:
Click on the “ Service” h yperlink, then r ead the “R eturn Mater ial Author ization” se ction for detailed instructions on our return proc ed ur es.
Click on the “R MA Request Form” h yperlink, then fill out the form completel y before sending.
Send e-mail to the Customer Support Department at service@comtechefdata.com.
For information regarding this product’s warranty policy, refer to the Warranty Policy, p. xxii.
vi
Loading...