Comnet CNFE4+1SMSM2, CNFE4+1SMSS2 User Manual

INSTALLATION AND OPERATION MANUAL

CNFE4+1SMS(M,S)2

FOUR PORT 10/100T(X) + ONE PORT 100FX
ETHERNET SELF-MANAGED SWITCH

The ComNet™ CNFE4+1SMS(M,S)2 is a five-port self-managed Ethernet switch with
uplink management functionality. It provides four ports operating at 10/100Mbps
and is designed to combine Ethernet data from the four electrical ports into a single
optical port and forward that data to the next network device, using two-fiber ST or
SC optical connectors. There is no programming required to use this switch. The
ComNet CNFE4+1SMS comes pre-programmed, preventing network video flooding
with DIP switch selection of the fiber port as uplink or as an unmanaged switch It is
“Plug-and-Play” easy to use.

LED indicators confirm the operating status of this device. See Figure 4 on Page 3
for an explanation of the indicators.

The ComNet CNFE4+1SMS may be either wall mounted, rack mounted (“ComFit”
packaging) or DIN-rail mounted with the use of the ComNet DINBKT1 adapter. See
Figure A on Page 4 for mounting instructions.

See Figures 1 – 5 for complete installation details.

INS_CNFE4+1SMS(M,S)2_REVA 07/08/11 PAGE 1

INSTALLATION AND OPERATION MANUAL CNFE4+1SMS(MS)2

FIGURE 1 – CNFE4+1SMS

OPTICAL
FIBER

RJ-45

RJ-45

RJ-45

RJ-45

FIGURE 2 – CNFE4+1SMS

REAR PANELFRONT PANEL

BLACK

BLACK WITH WHITE STRIPE

Power Supply:
Surface Mount: 9–24VDC@1A
Rack Mount: From Rack

NOTE: Remove Electrical

Connector for Rack
Mount Units

FIGURE 3 – UPLINK SWITCH SETTINGS

EFFECT UPLINK

Uplink Enabled ON

Uplink Disabled OFF

Tech SupporT: 1.888.678.9427

INS_CNFE4+1SMS(M,S)2_REVA 07/08/11 PAGE 2